Ofuzzi Cyber 1200 Cordless Robotic Pool Cleaner User Manual

June 15, 2024
Ofuzzi

Ofuzzi Cyber 1200 Cordless Robotic Pool Cleaner User Manual
Ofuzzi Cyber 1200 Cordless Robotic Pool Cleaner

Important Precautions

  1. Do not power on the cleaner when it is out of the water.
  2. Strictly prohibit using the cleaner beyond its operating conditions, Please read the manual carefully and use it according to the manual. We have no responsibility for any loss or injury caused by mproper use Use the accessories recommended or sop bby the manufacturer ority.
  3. This model mainly apples to swimming pools with a fist floor
  4. The cleaner should not be used by chicken under the age of 8 or people with mental disorders, Please do so uncker the supervision of the guardian if necessary Please do not allow children to ride on it or play as a toy
  5. Use the original and authorized power adapter only.
  6. It must be replaced by the after-sale professionals if the power Ine is damaged.
  7. The power Ine must be connected to a leakage protected and earthed socket when changing
  8. Do not operate the leaner when there are people in the pool
  9. Always clean and wash the filter tray after use.
  10. Power off the cleaner when maintaining, deaning or not using it. 12. The cleaner should be stored in a cool and ventilated place, away from direct surishine
  11. Charge the battery under the permitted condition. The cleaner should be stored in a cool place when charging meanwhile do not place of be covered with anything to prevent the damage of internal electrical components caused by overheating of the power unit.
  12. Only professionals can disassemble the sealed arriving kit of the cleaner.
  13.  Close the pool ration system before use,
  14. The cleaner shoal’s be charged every three months if it needs to be stored for a long times Fleas use the original and authonzed adapter only to ensure that the battery power is mattered at 40%-60%, The battery voltage will be lower than the over-discharge protection voltage due to the self-discharge of battery if not charging the battery for a long times, which will lead to fatal damage to the battery if continuing too long Please be careful,
  15.  Prohibit charging the battery under the condition of fine or extreme heat, Do not use or store the cleaner near the heat source
  16. Prohibit perching the cleaner shell with nals or other sharp comets and pronoia hammering, impacting and throwing the diner.

For all above/half above ground pools

Please note that it’s not an all-rounder
For all above/half above ground pools
For all above/half above ground pools.

For Inground Pools of Flat Bottom (Water Depth < 6.56ft)

Not for deep shallow ends. Can’t climb walls or stairs
Inground Pools of Flat Bottom

Introduction

The robotic pool cleaner Cyber 1200 mm a new type of rechargeable automatic cleaning equipment for poors with the function of automatic panning The cleaning function is upgraded and the half-way tum-back function is activated for 5-12 times every 20 times the wall is hit, so that the center of the swimming pool is no longer a deed corner for cleaning

Please read this manual carefully before use.

Appearance structure

Product Parts

Specifications

1 Name Cordless Robotic Pool Cleaner
2 Model Cyber 1200
3. Rated input voltage/frequency of charger 100Vac-240Vac 50/60Hz
4. Rated output voltage of charger 12.6V
5. Rated output current of charger 3A
6. Working power Appr. 50W
7. Working time max.120min for one cycle
8. Battery capacity 6600mAh
9. Charging time 3-3.5h
10. Max. cleaning surface Appr.1076112 or 100m2
11. Filter capacity Appr.2641us gal or 10m1/h
12. Filter capability 180pm
13. Swimming pod slope max. 15°
14. Pool water temperature (50°F) – (95°F) /10 C -35 C
15. Moving speed Appr. 52.4ft or 16mImin
16. IP Grade IPx8 (main body)
17. Charging environment temperature (32°F) – (113°F) /0 C -45 C
18. Max. water depth 6.56ft or 2.0m
19. Storage condition
Snort term (less than 1 month): (-4°F) – (.140°F) / (-20 C)-(+60C ) s

75%RH
Medium term (less than 3 months): (-4°F) – (+113°F) / (-20 C )-(+45C ) s 75%Cti-1
Long term (more than 3 months). (-4°F) – (+68°F) / (-20 C)-(+20 C) 5 75%RH

Operation instruction

Precautions
A Install the brush before use to avoid possible dirt leaks.
Installation Instruction

B, Please ensure that the top cover of the cleaner is tightly assembled to its chassis.
Installation Instruction

C .After turning on. the cleaner must be placed in the pool within 20 seconds
Installation Instruction

D. Put into or lift out of the pool with the cleaner bottom towards the wall to avoid any possible scratches to the pool
Installation Instruction

E. The suction paperer CNGDO

F. Power oft the dearer utter use

G. Do not touch ther wall to avoid scratching the wall or damaging the cleaner when putting into or lifting out of the poker when putting into or lifting out of the pool .

H. Itis necessary to stay on the water surface for 10-15 seconds until water flows out from the cleaner to the pool before being placed on the ground.
I. When the floating handle is Lift the handed or clips of tne cleaner out from the pool r away form pool side, use the hook (pole is not included) to reach the floating handle .
Installation Instruction

Quick operation

A.. Quick operation

  • Plug in the cleaner with the supplied adapter and charging line to charge the battery.
  • Turn the switch knob to OFF before charging,
  • Clean the charging port before charging
  • Keep the machine charging port and the adapter dry when charging
Adapter indicator Status
Red Battery is charging
Green Charging is finished

B.  Turn the switch knob to power on or off the cleaner
Please putinto water within 20 seconds after turning on
Installation Instruction

C. Turn the switch knob to ON, the cleaner is power-on and the indicator light is steady bee, then put it into water. About 15 seconds after power-on, the
cleaner begins to work, and the blue light fishes.
D. Wren battery power silo, the cleaner will move close to the pool wall. The red-light fast flashes. The cleaner stops running when it runs out of battery.
E. Indicators

Status Meaning
Solid blue Switching
Blue light fast fishing Cleaners  out of water
Blue light scow flashing Cleaner is working i the pool
Flashing Red Low battery

Functions and adjustment of nozzles
There are two nozzles on the cleaner, one of them opens once the other closes. Water flows out through the open nozzle to thrust the cleaner forward. Adjust the nozzle by turning it to control the cleaner route.
control the cleaner route.

a. Setting nozzle angle and cleaner route

  • The nozzles of the cleaner are marked with angles (0°-40°)
  • The cleaner moves in an approximately straight line when the nozzle angle is 0°.
  • The cleaner moves in amore curved line at a larger angle from 0°-40°.

Setting 1: default setting: 0°-20°, for most of pools,

Installation Instruction

Setting 2: 0°-40°, when setting 1 does not manage a full coverage of the pool.
coverage of the pool.

Setting 3: 20°-20°, for round pools
for round pools
Note : These are the recommended settings. Different settings may work better for your pool.

Clean the filter tray
A. Open the cleaner by the clips
Clean the filter tray

B. Take out the filter t ray

C.   Clean the filter tray and chassis
Clean the filter tray and chassis

D. Reassemble the cleaner

E. Clap on the clips

Trouble shooting

Symptom Possible reason Solution
The cleaner does not work and the red indicator light slowly flashes Internal
fault Contact after-sales service
The cleaner does not work and the blue indicator light flashes Pump
protection Re-start the robot
The cleaner does not work and the indicator light does not flash Battery
protection Charge the robot and in case it does not work. please ask for

after-sales service
The adapter indicator light does not work| Adapter damage| Contact after-sales service
The cleaner does not achieve a full coverage of the pod| Unsuitable nozzle angle| Adjust nozzle angle
Special pool shape| Adjust nozzle to increase angle of deflection
Pool water filtration system is running| Turn off water filtration system
The working time of the cleaner cannot reach MAX 120 minutes| Not fully charged| r ully charge the cleaner (needs to last 3-3.5 hours)
The cleaner cannot reach the shallowwater area from the deep water area| The pool slopes more than 15 degree.| . I .                          .table  for flat-bottompc.. I .  • – . I – r.. • -..1 walls or slopes more
than 15 degree.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals