Ofuzzi Terrain 10 Cordless Robotic Pool Cleaner User Manual

June 15, 2024
Ofuzzi

Ofuzzi LOGO Ofuzzi Terrain LOGOUser Manual
ROBOTIC POOL CLEANER
Ofuzzi Terrain 10 Cordless Robotic Pool Cleaner Model: Terrain 10

Thank you for purchasing Ofuzzi Winny Cordless Robotic Pool Cleaner
If you have any questions or issues, please contact us for customer service.

Important Precautions

  1. Please read the manual carefully, and use the cleaner according to the manual. We are not held liable for any loss or injury caused by improper use.
  2. Use the accessories recommended or sold by the manufacturer only.
  3. Drythecharging port after taking the cleaner out of water and make sure the cleaner is switched off (the indicator is off) if you want to charge the cleaner.
  4. Use the original and authorized power charger only, do not charge any other devices with this charger.
  5. The power line must be connected to aleakage protected and earthed socket when charging
  6. Do not charge the cleaner if the environment temperature is above 35°C (95 °F) or below 5 C (41°F)
  7. Donot over charge the cleaner, which will reduce the battery life.
  8. The cleaner should be charged if it needs to be stored for a long time (over 6 months) to maintain battery life.
  9. Toreduce the risk of electrical shock, do not use the charger if the cord is damaged
  10. Never allow children toride on it or play with it as a toy.
  11. Do not power on the cleaner when it is out of the water.
  12. Do not operate the cleaner when there are people in the pool
  13. Always clean and wash the filter tray after use.
  14. Only professionals can disassemble the sealed driving kit of the cleaner.
  15. Do not operate the cleaner while pool filter is running
  16. The cleaner should be stored in a cool and ventilated place, away from direct sunshine or any heat source, never cover it with anything that would cause internal electrical components overheating

Introduction

The robotic pool cleaner Terrain 10 is a new type of rechargeable automatic cleaning equipment for swimming pools, cordless and easy to use.lt can clean the swimming pool fioor, walls, steps and waterline. Ideal for in-ground pools and above-ground pools.

Packing List

Item Name Quantity
1 Cleaner body 1 pc
2 Charger 1 pc
3 Retrieving hook 1 pc
4 Floating block 2 pcs
5 User manual 1 pc
6 Quick guide 1 pc
7 Sponge 1 pc

Product Diagram

Ofuzzi Terrain 10 Cordless Robotic Pool Cleaner - Product
Diagram

Specifications

1. Model Terrain 10
2. Rated Working Voltage 10.8V
3. Power 65W
4. Run Time Max. 110min for one cycle
5. Charger Input 100-240V, 50-60Hz
6. Charger Output 12.6V/3A
7. Battery Capacity 8600mAh
8. Charging Time 3.5 Hours
9. Pool Size Up to 1000sq.ft (92m2)
10. Flow Rate approx.10m3/h(2642gal/h)
11. Filter Density 180 µm
12. Moving Speed approx. 36ft/min(11m/min)
13. Waterproof Grade IPX8
14. Charging Environment Temperature 41 °F -95 °F (5°C -35°C )
15. Max Water Depth 9.8ft (3m)
16. Product Size 14.6(0141 (W)9.4(H) inches / 372(L)360(W)*240(H) mm
17. Weight 17.64Ibs (8KG)
18. Storage Condition 41 F -95 F (5 C -35 C ), RHs75%

Operations

5.1 Power button and indicator

Ofuzzi Terrain 10 Cordless Robotic Pool Cleaner - Power
Button

Item Function Description
Power on/off 1. Press the button, blue light indicates the cleaner is

powered on.
2. Press the button again, red light indicates the cleaner is powered off.
②| Indicator| 1. Blue light is steady on: power on
2. Blue light flashes: the cleaner is working
3. Yellow light flashes: low battery and start to self-parking
4. Yellow light is steady on: self-parking finished

Notes: When the yellow light is steady on, power off the cleaner and charge it. Running the cleaner in the pool after charging. If it fails to work, please contact after-sales service.
5.2 Attention
a. Putinto the pool with the robot bottom towards the wall. Hold on the robot and power on the cleaner. The robot will start working after 20 seconds when emptying trapped air inside (make sure to empty the inside air in order to make the robot work well), then the robot will clean the pool

Ofuzzi Terrain 10 Cordless Robotic Pool Cleaner - Robot
Bottom

b. The robot automatically moves to pool edge when it finishes working, then use the hook (pole not included)to lift it out of the pool.

Ofuzzi Terrain 10 Cordless Robotic Pool Cleaner - Pool
Edge

5.3 Filter Cleaning
a. Open the top cover: Put the robot aside the pool and open the top cover, the filter basket is located as shown in picture.

Ofuzzi Terrain 10 Cordless Robotic Pool Cleaner - Filter
Cleaning| Ofuzzi Terrain 10
Cordless Robotic Pool Cleaner - Filter Cleaning 1
---|---

b. Take out the the filter basket

Ofuzzi Terrain 10 Cordless Robotic Pool Cleaner - Filter Cleaning
2

c. Wash filter basket

Ofuzzi Terrain 10 Cordless Robotic Pool Cleaner - Filter Cleaning
3

d. Re-install the filter basket and close the top cover.

Ofuzzi Terrain 10 Cordless Robotic Pool Cleaner - Filter Cleaning
4

5.4 Charge the battery
a. Take the cleaner away from the pool.
b. Make sure the cleaner is powered off (no indicator flashes) and charging port is DRY, attach the charger to the charging socket. Red light indicates itis in charging. Green light indicates it is fully charged.

Ofuzzi Terrain 10 Cordless Robotic Pool Cleaner - Charge The
battery

LED Indicator
Red – In Charging
Green – Fully Charged
Notes:

  1. Charge the cleaner indoors and at least 3 meters (appr. 10ft) from the edge of the pool when the robot is in charging
  2. If there is water in the charging port, please use the sponge to dry.

Step 1: Open the protective cap of the charging port.

Ofuzzi Terrain 10 Cordless Robotic Pool Cleaner - Sponge Dry
1

Step 2: Check whether there is water in the charging port. If there is water, insert the sponge into the charging port. After the water is completely absorbed,take out the sponge and squeeze out the water.

Ofuzzi Terrain 10 Cordless Robotic Pool Cleaner - Sponge Dry
2

Step 3: Repeat step 2if there s still water inthe charging port, charge the robot when the charging portis dry.

Ofuzzi Terrain 10 Cordless Robotic Pool Cleaner - Sponge Dry
3 5.5 Charger indicator

Status of the indicator Charging status
Green light is steady on Connector not plugged or charging finished
Red light is steady on The battery is charging
Red light flashes Low battery or battery is damaged
Lightisnot on Charger light is broken or the charger is broken

5.6 Installation of Floating Blocks
Attention: If your robot performs well, please ignore these instructions
The following diagrams is limited to use of the fioating blocks when the robot cannot climb the pool walls or not able to climb walls well

Ofuzzi Terrain 10 Cordless Robotic Pool Cleaner - Wall

a. Open the filter cover and pick up the filter basket.

Ofuzzi Terrain 10 Cordless Robotic Pool Cleaner - Filter
Busket

b. Tear off the protective film on the back of the floater and stick one by one according to the position shown in the figure.

Ofuzzi Terrain 10 Cordless Robotic Pool Cleaner -
Floter

c. Install the filter basket and close the filter cover.

Ofuzzi Terrain 10 Cordless Robotic Pool Cleaner - Filter
Cover

5.7 Pool water condition
Remark: The pool water condition must be within following parameters:
– PH:7.0-7.4
– Temperature: 50 °F -95 °F (10°C -35°C )
– Salt: Max. 5,000 ppm
– Chlorine: Max. 2 ppm

Trouble Shooting

| Symptom| Possible Reason| How to diagnose| Solution
---|---|---|---|---
Related to power-on| The button cannot be turned or cannot be easily turned| There is sand or other debris stuck in the knob gap| a. Remove the top cover
b. Check whether there is sand or other debris stuck in the knob gap”| Remove sand or other debris
Power on the robot, the indicator is still off and the robot doesn’t work| The sealed box leaks| a. Dismantle the sealed box
b. Check whether there is water inside the sealed box
c. Operate professional air-tightness testing machine to test and observe whether there is any leakage point”| a. Replace the drive kit
b. Contact after-sales service”
The robot doesn’t
work| The indicator light flashes red slightly, and the robot does not work| The robot is not placed in the water in time, and pump protection is activated| | Restart the robot
The impeller is damaged or lost| Check the impeller| a. Replace the impeller
b. Contact after-sales service
The impeller gets stuck by the debris| Check the impeller| Remove the debris
The motor overheat protection| After the motor temperature drops, restart the machine and it can be automatically restored to normal| leave the robot for a while and restart
The indicator light flashes yellow slowly, and the robot does not work| The battery runs out| | Recharge the battery
The robot cannot sink to the bottom| There’s air in the robot| Shake the robot with hand to empty air| Empty air
The robot doesn’t
climb walls| The robot doesn’t climb walls| The filter basket is blocked| Check the filter basket if it is blocked| Wash the filter basket with running water
There is too much or too heavy debris in the filter basket| Check the filter basket if there is too much or too heavy debris| Wash the filter basket with running water
| Install the floating blocks to check if the robot can climb the walls| Install the floating blocks
The charger doesn’t work| The indicator lamp in the charger is off when charging| The charger is damaged| | Replace the charger
The charger doesn’t work| The indicator lamp in the charger doesn’t turn green or red| The charging pins are corroded| Check whether the charging pin are corroded| Replace the drive kit
The charger is damaged| | Replace the charger
The sealed box leaks| a. Dismantle the sealed box
b. Check whether there is water inside t he sealed box
c. Operate professional air-tightness testing machine to test and observe whether there is any leakage point| a. Replace the drive kit
b. Contact after-sales service
Coverage issue| The robot cannot cover the whole pool floor| The sensor is damaged| a. Dismantle the sealed box
b. Check whether there is water inside the sealed box
c. Operate professional air-tightness testing machine to test and observe whether there is any leakage point| a. Replace the drive kit
b. Contact after-sales service
The motor is damaged| a. Dismantle the sealed box
b. Check whether there is water inside the sealed box
c. Operate professional air-tightness testing machine to test and observe whether there is any leakage point| a. Replace the drive kit
b. Contact after-sales service

Warranty

  1. This product is covered by Ofuzzi Winny warranty for 12 montths (only for driving kit and control box kit) from the date of purchase . Consumable parts are beyond warranty which include Filter Tray/ Brush/ Wheels/Nozzles.
  2. This warranty is voided if the product has been altered, misused, or has been repaired by unauthorized personnels.
  3. The warranty extends only to manufacturing defects and does not cover any damage resulting from mishandling of the product by the owner.
  4. The order number or record must be presented for any claim or repair during the warranty period

Thank you for purchasing Ofuzzi Winny Robotic Pool Cleaner. Please read through the entire manual before using your new robotic pool cleaner. We are not held liable for any loss o injury caused by improper use. If you encounter a problem with your OfuzziWinny product, please contact our customer service for assistance.

WARRANTY CARD

Your Warranty Includes

  • 12-Month Coverage
    Within 12 monhs of purchase, we will provide fimely and effecive oniine affer- scles service. We wil repair or replace any defecive product (due fo manufacturing fout] within the warianly perod.

How to Return Your Ofuzzi Product

  • Contact support@ofuzzi.com with your order number.
  • We willissue you a retum label for your refum.
  • Tear o the Return Detals’ page and fillin the defails. Include this inside your refum package.
  • We will issue your replacement/refund on receiving fhe refum package.

**support@ofuzzi.com**

Return Details
In order to process your refum as quickly as possible, we require the following information.
Please fill out this form and include it in your refum package.

Purchase Nome:|
---|---
Order Number.|
Date of Purchase:|
Your Email Address:|
Place of Purchose:|

+1-516-927-8658
support@ofuzzi.com
Shenzhen Lanbiaoyi Technology Co., Ltd.
RM.1438F, Anjier Bldg., NO.52 Bagua 4th ST.,
Yuanling Ave., Futian Dist., Shenzhen, Guangdong, China 518000
Made in ChinaOfuzzi Terrain 10 Cordless Robotic Pool Cleaner - Symbol
2

Documents / Resources

| Ofuzzi Terrain 10 Cordless Robotic Pool Cleaner [pdf] User Manual
Terrain 10 Cordless Robotic Pool Cleaner, Terrain 10, Cordless Robotic Pool Cleaner, Robotic Pool Cleaner, Pool Cleaner, Cleaner
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals