GOZNEY DOC-0540 Arc Stand Instruction Manual

GOZNEY DOC-0540 Arc Stand

Arc Stand

This section details the process of building the stand and the correct installation of Arc Stand.

Cautions & Warnings

• Ensure you have fully read, understood and comply with the cautions & warnings in the Arc Users Manual supplied with the oven.
• All four of the casters should always be locked unless you are moving the oven.
• Never attempt to move the oven when it is still warm, wait for it to fully cool first.
• When moving the oven on the stand always push/pull from the stand and not the oven.
• Remove anything loose from the stand and its shelves before moving it.
• Placing hot items from the oven onto the wooden shelves may damage them, use appropriate protection to avoid damage.
• Exposing the wood to direct sunlight and rain for extended periods can cause the protective layers to break down. To prevent this follow the below steps:

1. Store the unit out of sunlight when not in use.
2. Dry the wood with a soft cloth after exposure to moisture.
3. Apply an outdoor furniture oil treatment every 8 weeks.

Gas Oven

• Always disconnect the oven from the gas supply before moving the oven.
• The casters should always be locked when the oven is connected to a gas supply, even if the oven isn’t in use.
• Ensure you’re using a Gooney supplied gas connector or one that complies with the Standard for movable gas appliances (ANSI Z21.69 / CSA 6.16), and a quick-disconnect device that complies with the relevant Standards (ANSI Z21.41 / CSA 6.9).

The gas connector and the quick disconnect device or its associated piping should never be used to limit the movement of the appliance.

Building & Installation

Build Manual

BUILD AREA

• Build the stand in front of the area you intend to position Arc.
• Ensure the ground is stable and level and capable of supporting the oven’s weight.
• Don’t place any of the parts on an abrasive surface and avoid damaging the paintwork of the metal parts.

What’s In The Box

SCALE 1:1

• F001 1x
  

• F002 44x

• F003 4x

• F004 1x

• F005 4x

• F006 44x

Step 1

FIXINGS

We recommend not fully tightening the bolts until the frame has been assembled.

• This will ease the alignment of future fixings. Fully tighten at Step 5.

Step 2

Step 3

Step 4

Step 5

FIXINGS

Tighten all fixings on the stand, being careful not to over tighten.

Step 6

Step 7

Step 8

INSTALLING ARC

Before installing Arc, assemble fixings F006 and F003 into the top of the stand.

• Don’t fully tighten these two fixings, there needs to be around 1/8” (4mm) of thread exposed.

Step 9

INSTALLING ARC

Ensure fixing F006 and F003 are assembled into the stand before installing the oven.

• Remove anything loose from the oven before moving.
• Two people should pick up Arc from the rounded ends of the oven as shown.
• Never lift Arc on your own.
• Don’t use the mouth of the oven as lifting point.
  

Align Arc’s feet with the highlighted slots. Ensure the feet are fully aligned before moving on.

Step 10

INSTALLING ARC

Tighten fixing F003 until Arc is fully secured to the stand.

• Be careful not to over tighten as it can damage the Stand.
• Never use Arc without it being secured to the stand.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>