COSLUS A07 Portable Nail Drill Machine Kit User Manual
- May 15, 2024
- COSLUS
Table of Contents
COSLUS A07 Portable Nail Drill Machine Kit
Thank you for purchasing our product. In order to ensure safety and better performance, please carefully read this manual before use.
Product Overview
-
Main switch
(On/Off/Forward/Reverse) -
Speed adjustment roller switch
-
Drill bit
-
DC port
Specification
| Model | AO7 |
|---|---|
| Rated input | 5V2A(MAX.) |
| Rated working power | 0-10W |
| No-load speed | 0-14000RPM |
| Power connector | DC jack 5.4mm |
Package List
- Drill bit
- USB cable
- Handpiece
Drill Bit Instruction
Needle Bit
For nail carving and nail comer filing
Safety Bit
For removing bulge parts on nail surfaces and nail polishing
Long Cone Bit
To polish nail sidewalls and cuticles
Small Barrel Bit
For removing calluses and polishing nail surfaces
Large Barrel Bit
For removing calluses and polishing nail surfaces
Mandrel with Sanding Band
For polishing hard and rough nails
Drill Bit Installation
- Hold the handpiece in one hand and the drill bit in the other hand.
- Insert into or pull out the drill bit firmly.
Operation Instruction
- Choose different drill bits according to different needs, and install the drill bits to connecting shaft at the tip of handpiece until it is fixed in place.
- Toggle the main switch on USB cable to the middle, the device will shut down.
- Toggle the main switch up or down to change the rotation direction into forward or reverse.
- Push the roller switch forward or backward to adjust working speed of the motor.
Cleaning and Maintenance
- Before starting cleaning the device, make sure it is powered off.
- Do not immerse the device in water, please disassemble accessories and clean separately.
- Use a clean doth or a wrung-out wet cloth to clean the device surfaces.
- Do not use any lubricants, cleaners, polishes, or air fresheners on this device.
Warning
- Do not store this product for a long time in humid or high-temperature environment. If it is not used for a long time, please store the product after it is fully charged.
- Do not throw this product together with household waste, it should be handed over to designated recycling center according to local law and regulation.
- The following people are not suitable to use this product: children, diabetic, those who have skin inflammation on fingers or toes, allergies, physical sensory or mental disabilities
- Please stop using immediately and consult the doctor in time if you feel uncomfortable.
- The product is only for nail drilling, do not use for any other purposes.
- Do not disassemble, repair or transform this product by yourself.
FAQ
The product does not work.
Check if the product needs to be charged and if the product is in suspended state. Check whether the product is damaged. Falling may cause deformation of drill hole, or even cause parts inside the handpiece breaking. Please try to prevent falling to avoid damage. Accumulation of excessive nail dust in power hole and the device, or accumulation of nail polish at the switch button will affect the normal operation. Washing with water will cause internal parts to rust and not work properly. Recommended to clean the device with cleaning brush after each use.
The product cannot use replacement drill bit.
Ensure whether the diameter of dill bit is too large to fit in.
The product has power, but it shuts down automatically.
Surfaces that the drill bit touches are too hard. It is recommended to increase rotating speed or operate on suitable surfaces.
Note: If there is any technical improvement in the product, we will make a new version of the manual without notice. The product appearance and color may vary according to different version, please refer to the actual product received.
WhatsApp contact
Coslus Group
- Website: www.coslus.com
- Tel: +1 855-594-3950(8am-5pm Mon. – Fri. (EST))
- E-mail: support@coslus.com
- Made in china
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>