HamiltonBeach PROFESSIONAL B96 Professional Blender Instruction Manual
- May 15, 2024
- HamiltonBeach PROFESSIONAL
Table of Contents
- HamiltonBeach PROFESSIONAL B96 Professional Blender
- Product Information:
- Product Usage Instructions
- IMPORTANT SAFEGUARDS
- Other Consumer Safety Information
- Parts and Features
- Using Your Juicer-Mixer-Grinder: Reference Table
- Sample Recipes
- Coconut Chutney
- Assembly
- Operation – MANUAL
- Troubleshooting
- Documents / Resources
HamiltonBeach PROFESSIONAL B96 Professional Blender
Specifications:
- Type: B96
Product Information:
The Pengisar Pencampur Jus is a manual blender grinder designed for blending and chopping food items. It comes with safety features to ensure secure operation.
Product Usage Instructions
Safety Precautions:
- Read all instructions carefully before use.
- Do not allow children to operate the appliance.
- Avoid contact with moving parts.
- Do not use the appliance near hot surfaces or open flames.
Operating Guidelines:
- Ensure the appliance is unplugged before assembling or disassembling parts.
- Operate the appliance in cycles of 2 minutes on and 1 minute off.
- Always use the appliance with the lid securely in place.
- Do not blend hot liquids above the recommended capacity to prevent spills.
Cleaning and Maintenance:
- Handle blades with care, especially during cleaning.
- Avoid using a broken or damaged jar or cutting blade assembly.
- Clean the appliance thoroughly after each use following the manufacturer’s instructions.
FAQ:
-
Q: Can I use this blender to crush ice?
A: It is not recommended to use this blender for crushing ice as it may damage the blades and motor. -
Q: How do I clean the blender jar?
A: The blender jar can be cleaned with warm soapy water and a non-abrasive sponge. Ensure it is completely dry before reassembling.
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury to persons, including the following:
- Read all instructions.
- This appliance is not intended for use by persons with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they are closely supervised and instructed concerning use of the appliance by a person responsible for their safety.
- This appliance shall not be used by children. Keep the appliance and its cord out of reach of children.
- Close supervision is necessary when any appliance is used near children. Children should be supervised to ensure that they do not play with the appliance.
- To protect against risk of electrical shock, do not put cord, plug, base, or motor in water or other liquid.
- Turn the appliance OFF ( ), then unplug from outlet when not in use, before putting on or taking off parts, and before cleaning. To unplug, grasp the plug and pull from the outlet. Never pull from the power cord.
- Normal operating cycle of appliance cycle is 2 minutes of on time. Allow 1 minute off period between each maximum cycle.
- Avoid contact with moving parts.
- Do not operate any appliance with a damaged supply cord or plug, or after the appliance malfunctions or has been dropped or damaged in any manner. Supply cord replacement and repairs must be conducted by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard. Call the provided customer service number for information on examination, repair, or adjustment.
- The use of attachments, including canning jars, not recommended or sold by the appliance manufacturer may cause a risk of injury to persons.
- Do not use outdoors.
- Do not place on or near a hot gas or electric burner, or in a heated oven.
- Keep hands and utensils out of the jar and away from the cutting blade, while blending or chopping food, to reduce the risk of severe personal injury and/or damage to the appliance or available attachments (attachments may not be provided with appliance). A rubber spatula may be used but must be used only when appliance is not running.
- Blades are sharp; handle carefully— especially when cleaning inside jar.
- Do not use a broken, chipped, or cracked jar.
- Do not use broken, cracked, or loose cutting blade assembly.
- Always operate appliance with lid in place. Remove filler cap only for adding ingredients.
- Do not run a soup cycle unless appliance has fully cooled to room temperature.
- When blending hot liquids in the open top blender jar, remove center filler cap and close any edge lid opening intended for pouring. To prevent possible burns: Do not exceed the 2-cup (473-ml) level. Hot liquids may push off lid during blending; therefore, with the protection of an oven mitt or thick towel, place one hand on top of the lid, keep exposed skin away from the lid, and start blending at lowest speed.
- Be careful if hot liquid is poured into the jar as it can be ejected out of the appliance due to sudden steaming.
- Do not leave appliance unattended while it is operating.
- Check that the appliance is OFF (o ) before plugging cord into wall outlet. To disconnect, turn the control to OFF ( o ); then remove plug from wall outlet. To unplug, grasp the plug and pull from the outlet. Never pull from the power cord.
- Do not use appliance for other than intended purpose.
- Keep hands and utensils, other than the tamper provided, out of container while blending to reduce the risk of severe injury to persons or damage to the blender. The cover must remain in place when using the tamper through the cover opening. A scraper may be used but must be used only when the blender is not running.
- CAUTION! In order to avoid a hazard due to inadvertent resetting of the thermal cut-off, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.
- Your plug is provided with a 13-amp fuse approved by ASTA to B.S. 1362. If you need a replacement fuse carrier, it must be replaced with the same colour-coded carrier with the same markings. Fuse covers and carriers can be obtained from approved service agents.
SAVE THESE INSTRUCTIONS
Other Consumer Safety Information
This appliance is intended for household use only.
WARNING Electrical Shock Hazard: The length of the cord used on this
appliance was selected to reduce the hazards of becoming tangled in or
tripping over a longer cord. If a longer cord is necessary, an approved
extension cord may be used. The electrical rating of the extension cord must
be equal to or greater than the rating of the appliance. Care must be taken to
arrange the extension cord so that it will not drape over the countertop or
tabletop where it can be pulled on by children or accidentally tripped over.
If the cutting blade assembly locks and will not move, it will damage the
motor.
- Do not use. Visit https://hamiltonbeach.global for service center locations or kindly take the product to the place of purchase.
- Do not place blender jar in the freezer filled with food or liquid. This can result in damage to the cutting blade assembly, jar, blender, and possibly result in personal injury
NOTE: This machine is equipped with motor overload protection. If the motor stops during operation due to overheating, unplug and allow it to cool down for approximately 15 minutes. Plug machine back in to resume normal operation.
Recycling the Product at the End of Its Service Life
The wheeled bin symbol marked on this appliance signifies that it must be
taken over by a selective collection system conforming to the WEEE Directive
so that it can be either recycled or dismantled in order to reduce any impact
to the environment. The user is responsible for returning the product to the
appropriate collection facility, as specified by your local code. For
additional information regarding applicable local laws, please contact the
municipal facility and/or local distributor.
Parts and Features
Before first use: After unpacking appliance, wash everything except Base in hot, soapy water. Dry thoroughly. Wipe Base with a damp cloth or sponge. DO NOT IMMERSE BASE IN WATER. Care should be taken when cleaning inside of Jar as the cutting blade assembly is very sharp.
Using Your Juicer-Mixer-Grinder: Reference Table
Sample Recipes
Idli Batter
Preparation:
- Pre-soak Idli Rice for 4 – 12 hours with twice volume of water.
- Drain excess water after soaking.
Recipe:
- Combine 2 parts water to 3 parts Idli Rice (by weight).
Dal (Chickpea Hummus recipe)
Recipe:
- Pre-soak dry chickpeas for 12 hours with twice volume of cold water.
- Drain chickpeas, put them in a pot and fill with new water, 2 tsp salt and 1 tsp baking soda.
- Boil chickpeas, reduce heat to a low boil for 1 hour to soften them.
- Drain chickpeas and let cool to room temperature.
- Combine ingredients using ratio of 2 cups chickpeas, ½ cup cold water, juice from ½ a lemon, 2 garlic cloves, 3 tbsp tahini and 2 tbsp olive oil.
- Press and release pulse function button multiple times until desired consistency is reached.
Coconut Chutney
Preparation:
- Remove the meat of fresh Coconuts from outer shell and cut into 1” chunks. Recipe:
- Add Fresh Coconut chunks to jar for batch test size, Add 5 mint Leaves.
Peanut Butter
Recipe:
- Add Roasted peanuts to volume desired.
Onion & Tomato Chutney
Preparation:
- Cut fresh Tomatoes and fresh Onions into 1” chunks.
Recipe:
- Add Tomato and Onion chunks to jar in 1: 1 ratio by volume.
Curry Paste
Recipe (Makes approx. 1.5 cups of curry paste):
- Chopped Onion – 1 cup, Ginger 1 inch piece, Garlic 3-4 cloves.
- Chili pepper 2-3, Diced Tomato 1 cup.
Assembly
Operation – MANUAL
Operation – PRESET
Using the Tamper
Troubleshooting
- Display shows Error Codes E01.
- Blade is jammed with food. Remove jar and lid. Use Scraper to stir food. Repeat blending.
- Appliance fails to start or stops while it is running.
- Make sure that the Power Switch Button is ON (I) and that it is illuminated blue.
- Check to see if unit is securely plugged into an electrical outlet of the proper voltage and frequency.
- Check to see if the fuse for the electrical outlet has blown or if the Reset Button on the bottom rear of Base has switched to OFF ( ).
- This appliance is equipped with an interlock feature — the appliance will fail to start or will stop when either Lid or Jar are not locked properly in place.
- Press Reset Button on bottom of Base.
Red light on Motor Temperature Status Indicator starts to flash and appliance stops running.
- Motor overload protection has engaged. Unplug and let cool for 15 minutes. Press Reset button on bottom of Base and plug back in to restart blending.
Unit does not respond to button commands.
- Turn unit power off and back on using the Power Switch to reset the controls.
- If problem persists, the unit will need to be serviced.
Ingredients will not mix properly.
- Check to see if enough liquid has been added to the ingredients. Mixture should be fluid and free-flowing at all times.
- Solid pieces are too large.
- Container is too full. Do not fill past MAX marking.
- Cutter assembly blades are not sharp or are damaged.
- Select speed to create a fluid blend.
If problem persists or if experiencing any other problem, please visit https://hamiltonbeach.global for service center locations or kindly take the product to the place of purchase.
© 2019 Hamilton Beach Brands, Inc. 4421 Waterfront Drive Glen Allen, VA 23060
Documents / Resources
|
HamiltonBeach PROFESSIONAL B96 Professional
Blender
[pdf] Instruction Manual
58770-SAU, 840315500, B96, B96 Professional Blender, Professional Blender,
Blender
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>