Lasko CD12100 Space Heater With Adjustable Thermostat Instruction Manual
- June 17, 2024
- Lasko
Table of Contents
Lasko CD12100 Space Heater With Adjustable Thermostat
Used for Model
CD12100
Read all
instructions before using this Heater. Save these instructions
WARNING
Plug heaters directly into a 120v wall outlet/receptacle only. Never use with
an extension cord. Do not plug heater into any other cord connected device,
such as a power strip, surge protector, multiple outlet adapter, cord reel or
outlet-type air freshener. The use of such devices may create a fi re hazard.
Do not plug multiple devices in the same outlet or on same circuit as heater.
Faulty wall outlet connections may cause the wall outlet to overheat. Be sure
that heater plug fits tightly into outlet before each use. During use, check
to make certain the heater plug is not overheating. If necessary have a
qualified electrician check and/or replace the wall outlet. Do not use this
heater with any solid state speed control devices.
Make certain that the power source conforms to the electrical requirements of
the heater.
Extreme caution is necessary when any heater is used by or near children or
invalids. The heater should not be left operating unattended. Never leave
children unattended when the heater is on or plugged in.
This appliance has a polarized plug (one blade is wider than the other). To
reduce the risk of electric shock, this plug is intended to fit in a polarized
outlet only one way. If the plug does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified electrician. Do not
attempt to defeat this safety feature.
Do not use the heater in areas where gasoline, paint, or flammable liquids are
used or stored. Do not use heater in locations where flammable or explosive
chemicals are stored, or in wet atmospheres.
Do not operate any heater with a damaged cord or plug or after the heater
malfunctions, or has been dropped or damaged in any manner. To disconnect
heater, turn the heater off then remove the plug from the outlet.
Always unplug heater when not in use. Unplug power cord before servicing or
moving the heater.
Do not insert or allow fingers or foreign objects to enter any ventilation or
exhaust opening as it may cause an electric shock, fire, or damage the heater.
Do not block or tamper with the heater in any manner while it is in operation.
Do not block air intakes or exhaust in any manner. Do not place on soft
surfaces, like a bed, where openings may become blocked.
Do not depend on the on/off switch as the sole means of disconnecting power
when servicing or moving the heater. Always unplug the power cord.
Hyperthermia can result in death. Symptoms of hyperthermia include high body
temperature, headache, nausea, vomiting, tiredness, dizziness, fainting, and
rapid pulse. If you begin to experience symptoms related to hyperthermia, turn
off the heater and seek medical attention.
To avoid excessive room temperatures which can cause hyperthermia: DO NOT
leave product running unattended in a confined space around infants, or
individuals with reducedphysical, sensory, or mental capabilities.
CAUTION
- Always unplug heater when not in use. Unplug power cord before servicing or moving the heater.
- Do not insert or allow fingers or foreign objects to enter any ventilation or exhaust opening as it may cause an electric shock, fire, or damage the heater. Do not block or tamper with the heater in any manner while it is in operation.
- Do not block air intakes or exhaust in any manner. Do not place on soft surfaces, like a bed, where openings may become blocked. Do not depend on the on/off switch as the sole means of disconnecting power when servicing or moving the heater. Always unplug the power cord.
- Always place the heater on a stable, flat, level surface when operating, to avoid the chance of the heater overturning. Locate the power cord so the heater or other objects are not resting on it. Do not run power cord under carpeting. Do not cover power cord with throw rugs, runners, or similar coverings as this may cause cord to overheat. Arrange power cord away from room traffic and where it will not be tripped over.
- This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Always use handle when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9 M) from the front of the heater and keep them at least 1 foot (0.3 M) from the sides and rear.
- This heater is not intended for use in wet or damp locations. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate a heater where it may fall into a bathtub or other water container.
- Do not use heater outdoors.
- This heater is not suitable for use in agricultural facilities including areas where livestock, poultry or other animals are confined. Please refer to national electric code (nec) article 547-7 (2008), or applicable state or local codes or standards relating to electrical requirements for agricultural buildings. This heater does not meet the requirements of nec article 547-7 (2008).
- This heater is not suitable for use in hazardous locations. Please refer to national electric code (nec) article 500 or applicable state or local codes or standards relating to electrical requirements for hazardous locations. This heater does not meet the requirements of nec article 500 (2008).
- Remote controls for other appliances or electronic equipment can sometimes interfere with the operation of this heater. If this occurs, move the heater to another location.
Parts Included
Heat Control
Heat Setting
Control Heat Settings with Switch.
O = OFF
II = High Heat
I = Low Heat
Oscillation Control
Oscillation Setting
Control Oscillation with Switch.
O = OFF
— = ON
Thermostat Control
- Set the Thermostat by turning the Thermostat Knob clockwise to + and allow the heater to warm up the room.
- When the desired comfort level is reached, lower the thermostat until the unit shuts off . This is done by turning the Thermostat Knob counter-clockwise toward –.
- The heater will automatically maintain the desired comfort level by cycling on and off . For continuous heat, set the thermostat towards +.
NOTE: It is recommended you adjust your thermostat with each use. Day to day changes in room and outdoor temperature will affect the position at which your thermostat will turn on or off .
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK OR PERSONAL INJURY, ALWAYS FOLLOW
THESE IMPORTANT SAFETY INSTRUCTIONS AND WARNINGS:
MAINTENANCE
- Always unplug the cord before moving, servicing or cleaning.
- Never place the heater in or near water.
- Clean the heater only with a vacuum equipped with a brush attachment; the vacuum will remove the lint and dirt from inside the heater.
- Vacuum intake grills every two weeks; this will help to maintain the optimum heater performance.
- Never attempt to take apart the heater.
- Clean the body of the heater with a soft cloth only.
- Never use alcohol or solvents such as gasoline, benzene, paint thinner, or other harsh cleaners.
TROUBLE SHOOTING TIPS
If your heater fails to operate, see below for a list of probable causes and solutions:
- Be sure the power cord is plugged into a working electrical outlet.
- Check your temperature setting. The heater may be off because it has reached the desired temperature setting.
- If your heater runs for several minutes and shuts off repeatedly, your heater may require cleaning. See maintenance section above.
STORAGE: Store the heater with these instructions, in the original carton
in a cool, dry place.
LUBRICATION: Motor is permanently lubricated. No maintenance is required.
DISPOSITION: Corrugated packaging materials are recyclable. For
environmentally responsible disposal of this product, contact your local wast
service provider or visit
www.1800recycling.com®
SAFETY FEATURE
- A thermal overload protector is built in to prevent overheating.
- If an overheat temperature is reached, the heater will automatically shut off. It can only resume operation when the user resets the unit.
To Reset Heater:
- Unplug the heater and wait 10 minutes for the heater to cool down.
- After the heater has cooled down, plug the unit into a 120V~ electrical outlet and follow the operation instructions described in this manual.
LASKO PRODUCTS, LLC LIMITED WARRANTY (VALID IN U.S. AND CANADA ONLY)
What this warranty covers: This product is warranted against defects in workmanship and/or materials.
How long this warranty lasts: This warranty extends only to the original purchaser of the product and lasts for three (3) years from the date of original purchase or until the original purchaser of the product sells or transfers the product, whichever first occurs.
What Lasko will do: During the warranty period, Lasko will, at its sole option, repair or replace any part or parts that prove to be defective or replace the whole product with the same or comparable model. For all warranty claims, the product must be returned to Lasko Products, LLC at customer’s expense with proof of purchase within the warranty period. Contact the Lasko customer service department to obtain a Return Authorization (“RA”) Do not return products without an RA or the warranty claim will not be processed.
What this warranty does not cover: This warranty does not apply if the product was damaged or failed because of accident, improper handling or operation, shipping damage, abuse, misuse, or unauthorized repairs made or attempted. This warranty does not cover shipping costs for the return of products to Lasko for repair or replacement. Lasko will pay return shipping charges from Lasko following warranty repairs or replacement.
Any and all warranties, expressed or implied (including, without limitation, any implied warranty of merchantability), last three years from the date of original purchase or until the original purchaser of the product sells or transfers the product, whichever first occurs and in no event shall lasko’s liability under any express or implied warranty include (i) incidental or consequential damages from any cause whatsoever, or (ii) replacement or repair of any house fuses, circuit breakers or receptacles. Notwithstanding anything to the contrary, in no event shall lasko’s liability under any express or implied warranty exceed the purchase price of the product and any such liability shall terminate upon the expiration of the warranty period.
Some states and provinces do not allow limitations on how long an implied
warranty lasts, or the exclusion or limitation of incidental or consequential
damages, so these exclusions or limitations may not apply to you. This
warranty gives you specific legal rights. You may also have other rights which
vary from state to state and province to province.
Proof of purchase is required before a warranty claim will be accepted.
CUSTOMER SERVICE
Email: producthelp@lasko.com. Web: www.lasko.com
Our Customer Service team is available to assist you with product service questions and replacement parts. They can be reached Monday through Friday, 8am-9pm Eastern. Please have your model number available, as well as the type and style (located on the underside of your product).
Customer Service Dept.,
820 Lincoln Ave., West Chester, PA 19380
(Please do not send product to this location)
Register Your Product Today
You will benefit from:
Have a Question? Need a Part?
Please Do Not Return Product to Store!
Chat with us at www.lasko.com Monday-Friday 8am – 9pm
EST
(Valid in U.S. and Canada only)
READ AND SAVE THESE INSTRUCTIONS
Read carefully before attempting to assemble, install, operate or maintain the
product described. Protect yourself and others by observing all safety
information. Failure to comply with instructions could result in personal
injury and/or property damage!
This heater is for residential use only. It is not intended to be used in
commercial, industrial or agricultural settings.
References
- Search. Find. Recycle - RecycleNation
- Lasko, GermGuardian, B-Air, BlueDri | Fans, Heaters, Air Purifiers – GuardianTechnologies
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>