OLIGHT RN2000 Bicycle Light User Manual
- June 17, 2024
- OLIGHT
Table of Contents
OLIGHT RN2000 Bicycle Light User Manual
IN THE BOX
-
RN 2000
-
Handlebar Mount
-
3mm Hex
-
GoPro Mount
-
Remote Control (incl. strap)
-
Aero Bar Compatible Strap
-
Type-C USB Cable
SPECIFICATIONS
The tests are performed indoors under a room temperature of 25 degrees Celsius with 25KM/H wind conditions.
HOW TO INSTALL
BEFORE FIRST USE
The bike light arrives in lockout mode.
Before first use, please unlock the light.
If the light is left unused, carried, or transported, please lock out the power button to prevent potential damage from the heat built-up due to accidental activation.
Lock: When the light is off, press and hold the power button about 3 seconds until the indicator flashes red.
Unlock: When the light is locked, press and hold the power button about 3
seconds until the indicator turns constant red.
HOW TO RECHARGE
BATTERY INDICATOR
When the device is power-on, the indicator on the power button will indicate
the battery level.
When the device is power-off, short press the power button to activate the
indicator light (light will shut down automatically after 3 seconds).
PHONE CHARGING INSTRUCTION
Note: Charging cables need to be purchased separately.
DANGER
- DO NOT shine the light directly into human eyes. This may cause temporary blindness, or permanent damage to the eyes.
- DO NOT cover the light head when the bicycle light is on, or place the bicycle light head on the ground. The radiation energy of the bicycle light may cause damage to the bicycle light itself, or even result in burning to flammable objects.
WARNING
- Keep out of reach of children.
- The light contains a lithium-ion battery. Certain restrictions may apply to this product when traveling, especially when traveling by air. Always check with your carrier for specific restrictions prior to traveling with this product.
- DO NOT clean the lens with alcohol or any other chemicals.
NOTICE
- Store the light at room temperature in a dry place. Avoid moisture, or extreme hot or cold.
- Store the light in the charged condition. Avoid “deep discharge”. Battery life will decrease if the light is stored in a fully discharged condition.
- Over time, the run time of the battery will diminish. Expect about 500 full charges, depending on care. After a full life, the battery will continue to charge but with a lower run time.
- When the run time is unsatisfactory, please recycle. DO NOT open the case of the light or incinerate.
EXCLUSION CLAUSE
Olight is not liable for damages or injuries sustained resulting from the usage of the product inconsistent with the warnings in the manual, including but not limited to using the product inconsistent with the recommended lockout mode.
OPERATING INSTRUCTIONS
REMOTE CONTROL PAIRING:
- Before using the remote control, please remove the insulating spacer and reinstall the battery.
Turn on the light, press and hold the “o””” buttons on the remote for about 10 seconds until the indicator alternately flashes blue to enter pairing mode. Then, close the remote to the light until the indicators on the remote and light unit are constantly blue for 2 seconds, confirming a successful pairing.
REMOTE CONTROL OPERATION:
ON/OFF: Press and hold the “”/”” button for 1 second ADJUST BRIGHTNESS: Click the “o” button CHANGE MODE: Double click the “o” button FLASH MODE: Double click the “” button FULL OUTPUT MODE (2000LM): Click the “” button to go into full output mode and click the “o”/”” button to return to the previous mode.
The remote control will enter sleep mode if the light is turned off for 48 hours without any operation. Click the light’s button to activate it or long- press the light’s button to turn it on, and the remote control can work normally.
HEADLIGHT BUTTON INSTRUCTIONS:
ON/OFF: Press and hold the button to turn the light on/off. The default output is the last mode when turned off.
ADJUST BRIGHTNESS: Click the “” button to increase the brightness, and click the “” button to decrease the brightness.
CHANGE MODE : Double click the button to change between floodlight mode and hybrid mode.
LOCKOUT: When the light is off, press and hold the button for 3 seconds to enter lockout mode. (In lockout mode, the light will not light up and the indicator flashes red quickly)
UNLOCK: In lockout mode, press and hold the button for 3 seconds to unlock the light.
SMART MODE : The smart mode is off by default; double click and long press for 3 seconds to turn it on/off. In smart mode, the light will automatically go out after 2 minutes of inaction and light up on any vibrations. The light will automatically switch off if no vibration is detected within 30 minutes. During the daytime, the light will automatically turn to the LOW brightness of floodlight mode. At nighttime, the light will automatically return to the brightness that it’s in when turned on.
WARRANTY
Within 30 days of purchase: Return to the original seller for repair or replacement.
Within 2 years of purchase: Return to Olight for repair or replacement.
This warranty does not cover normal wear and tear, modifications, misuse, disintegrations, negligence, accidents, improper maintenance, or repair by anyone other than an authorized retailer or Olight itself.
USA Customer Support
Global Customer Support
Visit www.olightworld.com to see our complete product line of portable illumination tools.
Dongguan Olight E-Commerce Technology Co., Ltd
4th Floor, Building 4, Kegu Industrial Park, No 6 Zhongnan Road, Changan Town,
Dongguan City, Guangdong, China. Made in China
FCC ID : 2A3J6-MJ6508REMOTE
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>