Wiser CCTFR6100 Radiator Thermostat Instruction Manual

June 17, 2024
Wiser

Wiser CCTFR6100 Radiator Thermostat Instruction Manual

CCTFR6100
CCTFR6101

FIG 1.JPG

FIG 2.JPG

FIG 3.JPG

FIG 4.JPG

FIG 5.JPG

About this product

The Wiser Radiator Thermostat (hereinafter referred to as thermostat) uses integrated temperature sensors to control the flow of water through a radiator, thereby regulating the temperature in a room. The target temperature and switching times are set in the Wiser Home App.

(1) Check package contents

A Radiator Thermostat
B O-ring (pre-installed)
C M30 x 1.5 valve adapter and chrome ring nut
D Danfoss RA adapter
E 2 x AA battery
F Installation guide

(2) Removing the old radiator thermostat
Open the valve of the radiator thermostat to facilitate removal.
(1) Loosen the ring nut engaged between the valve adapter and thermostat.
(2) Remove the thermostat and adapter from the valve.

(3) Inserting the batteries

  • When inserting batteries, observe the correct polarity.
  • Dispose of the batteries according to statutory regulations.
  • Used batteries must not be placed in normal household waste.
  • Do not use rechargeable batteries.

(4) Install the adapter and thermostat

NOTICE
RISK OF DAMAGE TO EQUIPMENT

  • Do not use tools, such as pliers, for installation.
  • Make sure that the O-ring is seated firmly on the thread. Tighten the ring nut by hand only.

Failure to follow these instructions can result in equipment damage.

Follow the installation steps for the type of adapter you have.

a. M30 x 1.5mm adapter
(1) Place the valve adapter on the valve.
(2) Loosely screw the ring nut onto the valve adapter.
(3) Screw on the thermostat and hand tighten.

To set the LEDs in the desired position: slightly loosen the ring nut, turn the thermostat to the desired position and tighten the ring nut again.

b. Danfoss RA adapter
(1) Push the Danfoss adapter over the narrow end of the Danfoss valve.
(2) Turn the Danfoss adapter until the grub screw hole is on the the opposite side to where you want the thermostat LEDs to be positioned.
(3) Tighten the grub screw with a 2 mm Allen key.
(4) Screw on thermostat and tighten by hand.

(5) Read full device guide online
Scan the QR code and choose your language for complete information about the device, including operation, configuration and using the product with a Wiser system.

Technical data

FIG 6 Technical data.JPG

Trademarks
Wiser™ is a trademark and the property of Schneider Electric SE, its subsidiaries and affiliated companies.
Other brands and registered trademarks are properties of their relevant owners.

EU Declaration of Conformity
Hereby, Schneider Electric Industries, declares that this product is in compliance with the essential requirements and other relevant provisions of RADIO EQUIPMENT DIRECTIVE 2014/53/EU. Declaration of conformity can be downloaded on: se.com/docs.

Schneider Electric Industries SAS
If you have technical questions, please contact the Customer Care Centre in your country.
se.com/contact
UK Representative
Schneider Electric Controls
401 Southway Drive
Plymouth, PL6 6QT
United Kingdom

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals