GORI BL2-SD-A4-1 Folding Propeller 2 Blades Instruction Manual
- June 17, 2024
- GORI
Table of Contents
GORI BL2-SD-A4-1 Folding Propeller 2 Blades
Propeller 2-blade for sail drive
1) OPERATING INSTRUCTIONS 2-blade Gori Folding Propeller
A) Mounting of a complete propeller for sail drive
B) Dismount of a complete propeller for sail drive
C) Exchange of “zinc anodes”
D) Service set & Spare Parts List
E) Supplied Tools
Read the Instructions before any work on the propeller.
Important!
Replace Zinc if eroded more than 50%.
Warning!
Beware of sharp edges.
OPERATING INSTRUCTIONS 2-blade Gori Folding Propeller
CONGRATULATIONS on choosing the 2-blade Gori Folding Propeller.
Under sail
When sailing under sail the blades usually fold, however, you should put the
lever in reverse if the engine is not turned on. This will lock the shaft and
ensure that the propeller folds and does not spin.
Ahead
When moving from neutral lever position, with folded blads, to forward lever
position under power the propeller will automatically open due to shaft
rotation.
Astern
When boat is moving ahead with neutral lever position and folded blads, and
reverse lever position then is engaged under power, the propeller will
automatically open due to shaft rotation and create a stop.
Before going sailing, check that the propeller works in both forward and
reverse.
If the boat has not been used for some time, you should shift cautiously
between forward and reverse a few times before sailing in order to clean the
teeth of the blades from fouling.
WARNING
- Do not start the engine when the boat is out of the water.
- The propeller has sharp edges. Be careful not to cut your fingers !
- Make sure that the propeller blades do not suddenly open or close and trap your fingers for example.
- Do not turn the propeller/engine shaft until the boat is in the water.
- Stop the engine before diving or swimming in the vicinity of the boat.
- The propeller blades are like knives and can cause considerable damage when rotating. Be careful
- Do not attempt to remove fishing net or ropes from the propeller when the engine is in motion.
- Check that the propeller works in both forward and reverse before starting each trip.
- If any strange sounds or vibration are noticed coming from the propeller, stop the engine immediately and solve the problem.
- In case of problems in connection with the mounting, use or function of the propeller, contact Gori Propeller or the importer in your country.
INSTALLATION INSTRUCTION
Mounting of a complete propeller for sail drive – (A).
Dismount of a complete propeller for sail drive ” – (B).
Exchange of “zinc anodes” – (C).
| ITEM | DK | GB | DE | STOCK NUM BER | QlY |
|---|---|---|---|---|---|
| 10 | Zink anode – ring | Zinc ring anode | Zink ring anode | 1510530000 | 2 |
| 11 | Undersa:nketskrue M 6×12 DIN 7991 A4 | Flat Count ersunk Head | |||
| Senkschraube | 1179910612 | 4 | |||
| – | Gevindsikr ing | Thread locking | Schr aubensicher ung | 1410000000 | 1 |
| – | Unb rakon¢gle – 4 mm | All en key – 4 mm | ln schlussel – 4 mm | 1402000000 | 1 |
| ITEM | DK | GB | DE | STOCK NUMBER | QTY |
| --- | --- | --- | --- | --- | --- |
| 1 | Nav | Hub | Nabe | 23115080312 | 1 |
| 2 | Bald | Blade | Flugel | – | 2 |
| 3 | Aksel | Pin | Fuhru ngsstifte | 1405100000 | 2 |
| 4 | Laseskive | Lock Washer | Sicherungsscheibe | 4772120001 | 1 |
| 5 | M¢trik | Nut | Mutter | – | 1 |
| 6 | Split | Split pin | Splint | – | 1 |
| 7 | Pinolskrue M8x12 | Hex socket set screw | Gewindestift | 1401300000 | 2 |
| 8 | Pinolskrue M8x12 | Hex socket set screw | Gewindestift | 1401300000 | 2 |
| 9 | Und Schenket skrue M8x20 | Flat countersunk head | Senkschraube | 1179910820 |
1
10| Zink anode – ring| Zinc ring anode| Zinc Ring anode| 1510530000| 2
11| Undersa:nket sprue M6x12 DIN 7991A4| Flat Countersunk Head| Senkschraube|
1179910612| 4
Supplied tools – (E)
| ITEM | DK | GB | DE | STOCK NUM BER |
|---|---|---|---|---|
| 1 | Unb rakon!Zlg l e – 5 mm | Allen key – 5 mm | ln schlussel – 5 mm | 1402100000 |
| 2 | Unbrakon!Zlg l e – 4 mm | Allen key – 4 mm | ln schlussel – 4 mm | 1402000000 |
| 3 | Gevi dansikring | Thread locking | Schraubensicherung | 1410000000 |
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>