nedes WL20R Rechargeable LED Light User Manual
- June 17, 2024
- Nedes
Table of Contents
nedes WL20R Rechargeable LED Light
Product Overview
The image shows a rechargeable LED light by Nedes®. It represents the product from different angles and displays key features.
- Front view: LED light panel, handle, and base with wheels and power switch.
- Side view: Adjustable angle mechanism and cable storage.
- Back view: Power switch, power indicator light, and input charge port.
Specifications
| Feature | Description |
|---|---|
| Power Output | 10W |
| Luminous Flux | 800lm |
| Protection Level | IP54 |
| Battery Type | Li-ion |
| Battery Capacity | 2200mAh |
| Charging Time | Approximately 4 hours |
| USB Output | 5V/1A |
| USB Cable Length | 100cm |
Operating Instructions
Rechargeable LED Light
- Before using the product for the first time, please read the instructions for use below and retain them for later reference. This appliance may only be used by persons with the physical, sensory, or mental capabilities. Turn off before cleaning! Use a soft, dry cloth! Do not use aggressive detergents and liquids! The LED light source of the luminaire is not replaceable! Do not look into the light of the LED, and do not direct it to reflecting surfaces!
- The lamp’s accumulator must be charged before first use. Charge the lamp in dry indoor areas at a temperature of +5 °C to +45 °C. If the lamp is not used for an extended period of time, it is necessary to recharge the accumulator before further use. The accumulator self-discharges and must be recharged at least once every 3 months to prevent its voltage from dropping and the accumulator potentially being rendered unusable. If the lamp does not glow or the light is weak, immediately recharge. If the accumulator is damaged or destroyed due to non-observance of the above rules, complaints filed within the warranty period regarding the lamp accumulator will not be accepted. Do not throw the accumulator into a fire and do not disassemble or short-circuit it.
Charging procedure:
- Turn the blank on the lamp body until the power connector is visible and connect the power cable.
- After fully charging, remove the power cable and turn the blank on the lamp so that water, humidity, or dust cannot enter into the lamp.
FAQ
How do I properly charge the LED light? Expose the power connector by turning the blank on the lamp body, then connect the power cable and charge fully. Once charged, remove the cable and re-secure the blank to protect against water and dust. What should I do if the LED light is not bright or does not turn on? Recharge the accumulator immediately. If it still does not function properly, check for damage and do not attempt to repair or dispose of it yourself. Can I replace the LED light source if it stops working? No, the LED light source of the luminaire is not replaceable. Contact the manufacturer if there are issues during the warranty period. Is it safe to charge the LED light in any environment? The LED light should be charged in dry indoor areas at a temperature of +5 °C to +45 °C to ensure safety and proper functioning. How often do I need to recharge the accumulator if I’m not using the lamp? The accumulator should be recharged at least once every three months to prevent voltage drop and preserve its lifespan.
Important Notices
Do not dispose of with domestic waste. Use special collection points for sorted waste. Contact local authorities for information about collection points. Improper disposal may endanger health and the environment.
The electrical waste symbol indicates that this product should not be disposed of with household waste. It is collected separately to prevent harm to health and the environment due to hazardous substances.
Additional Information
For more detailed information about the product, a manual with more instructions is available. Users can access this information by scanning the provided QR code.
PRODUCT IDENTIFICATION
Rechargeable LED Light
- Before using the product for the first time, please read the instructions for use below and retain them for later reference.
- This appliance may only be used by persons with impaired physical, sensory or mental capabilities.
- Turn off before cleaning! Use a soft, dry cloth! Do not use aggressive detergents and liquids!
- The LED light source of the luminaire is not replaceable!
- Do not look into the light of the LED, and do not direct it to reflecting surfaces!
- The lamp’s accumulator must be charged before first use.Charge the lamp in dry indoor areas at a temperature of +5 °C to +45 °C.lf the lamp is not used for an extended period of time, it is necessary to recharge the accumulator before further use. The accumulator self-discharges and must be recharged at least once every 3 months to prevent its voltage from dropping and the accumulator potentially being rendered unusable. If the lamp does not glow or the light is weak, immediately recharge. If the accumulator is damaged or destroyed due to non-observance of the above rules, complaints filed within the warranty period regarding the lamp (accumulator) will not be accepted. Do not throw the accumulator into a fire and do not disassemble or short-circuit it.
Charging procedure
- Turn the blank on the lamp body until the power connector is visible and connect the power cable.
- After fully charging, remove the power cable and turn the blank on the lamp so that water, humidity or dust cannot enter into the lamp.
Do not dispose with domestic waste. Use special collection points for sorted waste. Contact local authorities for information about collection points.If the electronic devices would be disposed on landfil, dangerous substanoes may reach groundwater and subsequently food chain, where it could affect human health.
manual + more informations on
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>