LED Solution 50W CCT LED Surfaced Panels Instruction Manual
- June 17, 2024
- LED Solution
Table of Contents
LED Solution 50W CCT LED Surfaced Panels
Product Information
Specifications
- Model : LED surfaced panels
- IP Rating : IP20
- Version: 1.0.0
- Manufacturer : LED Solution s.r.o.
- Address : Dr. Milady Horakove185/66, Liberec 460 07, Czech Republic
- Email : obchod@ledsolution.cz
Product Usage Instructions
General Instructions and Safety Information
Before installing or using the LED surfaced panels, please read and understand the following instructions:
- Ensure the power source is switched off before installation.
- Handle the panels carefully to avoid damage to the LED surface.
- Do not expose the panels to water or moisture as they have an IP20 rating.
- Follow the installation guide provided by the manufacturer for proper setup.
Installation Steps
- Locate a suitable mounting location for the panels.
- Securely attach the panels to the mounting surface using appropriate fixtures.
- Connect the power source following the electrical wiring diagram provided.
- Switch on the power and test the functionality of the LED panels.
Maintenance and Cleaning
To ensure optimal performance and longevity of the LED surfaced panels:
- Regularly clean the surface of the panels with a soft, dry cloth.
- Avoid using harsh chemicals or abrasive materials for cleaning.
- Inspect the panels periodically for any signs of wear or damage.
FAQ
- Q: Can the LED surfaced panels be dimmed?
- A : Some models may support dimming functionality. Refer to the product specifications or contact the manufacturer for more information.
- Q: Are these panels suitable for outdoor use?
- A : No, these panels are rated IP20, which means they are only suitable for indoor use and should not be exposed to water or moisture.
LED surfaced panels
- Carry out all manipulations with the lamp only when the power supply is disconnected from the mains.
- Remove the mounting plastic ring of the panel by turning it counter-clockwise and screw it to the ceiling or wall with the included screws and dowels.
- Connect the 230V wires to the terminals of the power supply wire to the led panel.
- Place the panel on the plastic mounting ring and rotate it clockwise.
- Turn on the power supply.
- The change in chromaticity temperature is switched by the switch on the back of the lamp
General instructions and important safety information
Please read this manual carefully before using the product and keep it for
future reference.
For damage caused by improper use or changes in the product structure, LED
Solution s.r.o. bears no responsibility.
Before handling the product in any way, make sure that the power supply is switched off.
All activities performed on electrical equipment must only be performed by a
person with electrical technical qualifications.
The product is intended for use in an indoor and dry environment IP20. The
light source of this lamp is non-replaceable, after the end of the life of the
lamp or damage to the cover, the entire lamp must be replaced. When
assembling, use only the parts that are included in the delivery. Moistened
cotton is best for cleaning the lamp. Do not use solvents, thinners or alcohol
for cleaning.
When a fault is detected, disconnect the power supply from the socket or turn
off the relevant circuit breaker, secure the body and the lamp until the fault
is professionally repaired do not use it.
ATTENTION : Do not look directly into the light beam of the LED(s)
LÉD Solution s.r.O., Dr. Milady Horakove 185/66, Liberec 460 07, Czech Republic
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>