Totnz TZESD6B Electric Standing Desk Instruction Manual

Totnz TZESD6B Electric Standing Desk

Electric Standing Desk Instruction Manual
Model: TZESD10/11TZ

Thank you for choosing this product! We strive to provide you with the best quality products and service in the industry. Should you have any issues, please don’t hesitate to contact us at service.wowowo@gmail.com .

Specifications

Assembly

• Step 1: Assembling and Connecting the Desk Legs

• Step 2 : Attaching the Side Plates and the Transmission Rod
  • Ensure the transmission rod is properly inserted into the hole in the left leg. Smoothly connect the other end of the rod to the end of the motor drive shaft on the right leg.
  • Secure the transmission rod to the motor drive shaft by turning the  set  screw  clockwise.
• Step 3: Assembling the Desktop
  • Assemble the desktop.
• Step 4: Attaching the Desktop
  • Attach the controller and hooks to the desktop.
• Step 5: Connecting the Cables
• Step 6: Installing the Cable Hole Covers

Using the Controller

• Save Current Height Setting
  Short-press the S button, and the display will flash. Press the 1 2  or 3 button to save the current height setting to that button.

• Select Height Setting 1
  Press the 1 button, and the desk will move to the height that was previously set for that button.

• Select Height Setting 2
  Press the button2 , and the desk will move to the height that was previously set for that button.

• Select Height Setting 3
  Press the 3 button, and the desk will move to the height that was previously set for that button.

• Raise the Desk
  Press the button to raise the desk continuously until it reaches the highest position of 46.5” (118cm) or the button is released.

• Lower the Desk
  Press the button to lower the desk continuously until it reaches the lowest position of 28.3” (72cm) or the button is released.

Protection Mode Error Codes

• Hot
  Overheating Protection: When the motor has been working continuously for 2 minutes, it will stop operating to prevent damage from overheating. Wait for at least 18 minutes before making any further height adjustment.

• E10
  Sensor Malfunction Warning: Motor safety sensor can’t be detected. Power off, check the connection between the motor and controller, and power back on again.

• E20
  Overloading Warning: Max load exceeded. If raising the desk, take the things off the desk and try again. If lowering the desk, power off, take the things off the desk, power back on, and try again.

• E02
  Operation Status Warning: The desk stops moving if vibration, impact, or incline are detected. If this detection is incorrect, follow the reset instructions before continuing use.

• E32
  Overvoltage Protection: Input voltage too high. If the correct AC adapter is being used, power off the desk, check the connection between power and the controller, and power on again.

• E31
  Under voltage Protection: Input voltage too low. If the correct AC adapter is being used, power off the desk, check the connection between power and the controller, and power on again.

• –
  Cable Disconnection Warning: Check motor and controller cable connections. Normal operation should return once all connectors are properly connected.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>