airhood AH-01AE Wired Portable Air Cleaner User Manual

airhood AH-01AE Wired Portable Air Cleaner

USER MANUAL

SAFETY INFORMATION

Please read and save these instructions carefully before using your AirHood and keep for future reference. If you pass this AirHood to another person, make sure to include this manual.

• Use the AirHood only for its intended purpose and as described in this manual.
  Improper use may result in an electric shock, fire or serious injury and may void the warranty. In the event of improper use or incorrect operation, we do not accept any liability for resulting damages.

• The AirHood is intended to be used in household applications only.

• The AirHood is not intended for commercial, industrial or outdoor use.

• To prevent the risk of an electrical shock, do not place the AirHood near a source of water or where water may splash or drip on it. Never immerse the AirHood, plug or charger/power cord in water.

• Do not operate the AirHood with a damaged charger/power cord or plug, after a malfunction, or if dropped or damaged in any manner. Never attempt to dismantle
  or repair the AirHood. If the AirHood, cord or plug are damaged in any way,
  do not use the AirHood and contact an authorized service center.

• The AirHood is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the AirHood by a person responsible for their safety.

• The AirHood is not a toy. Always supervise children to make sure they do not play with the AirHood. Close supervision must be provided when the AirHood is used by or near children. Make sure it is stored in a location that is inaccessible to children.

• Never leave the AirHood unattended while it is in operation.

• Always unplug the AirHood from the mains outlet when it is unattended, not in use, when moving the AirHood, before changing filters and cleaning.

• The AirHood should not be operated by an external timer switch or remote control.

• Place the AirHood on a flat, dry, heat-resistant and stable surface.

• Avoid using the AirHood in front of air conditioners, fans or open windows as they may reduce the effectiveness of the AirHood.

• Before first use, make sure the power voltage matches the information on the AirHood rating label.

• Do not let the charger/power cord hang over sharp edges, the edge of a table or counter or touch any hot objects. Arrange the cord in a location where it cannot be easily caught on.

• To disconnect the AirHood from the mains power, pull the plug out. Do not pull the charger/power cord.

• Only use the manufacturer’s approved accessories.

• Never cover the AirHood. Ensure there is sufficient ventilation.

• Never insert fingers, pencils or other similar objects through the covers.

• The AirHood must be assembled completely before use.

• Keep hair or loose clothing away from the AirHood when it is in use, as there is a danger that they can be caught in the AirHood and cause injury.

• Never operate the AirHood with wet hands or when standing on wet ground.

• RISK OF SUFFOCATION! KEEP OUT OF REACH OF CHILDREN – Keep all packaging materials out of the reach of babies, children and pets.

POLARIZED PLUG

This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician.
Do not attempt to defeat this safety feature.

READ AND SAVE THESE INSTRUCTIONS

DESCRIPTION OF PARTS

1. Power switch
O – Off
I – Low
II – Medium
III – High
2. Air duct tab
3. Air duct with front filter

4. Main body
5. Air diffuser with tab
6. Handle
7. Power cord storage area
8. Power cord and plug
9. Rear filter (charcoal filter)

HOW TO USE

• Unpack and remove all packaging materials from the AirHood and accessories.
• Check for damage. If any parts are damaged or missing, do not use the AirHood and return it to your retail outlet immediately.

OPERATING INSTRUCTIONS

Your AirHood sucks in contaminated air and filters it. The front filter extracts heavier impurities in the air such as fat, dust and water vapour, and the rear filter removes smoke, dirt and further toxic contaminants. The purified air is then passed through the air diffuser on the back.
1. Connect to the power source.
Insert the plug into the mains socket.
2. To attach the Base Boost (if purchased) to the AirHood, align the 4 nodules on the Base Boost with the grooves on the bottom of the AirHood, and then twist the base anticlockwise until it locks into place.

3. Slide the power switch to the desired setting:

SETTING| MEANING|
---|---|---
I| Low| Quiet operation
II| Medium| Optimal effectiveness, noise-compromise
III| High| Maximum power
O| Off|

4. When you are not using the AirHood, make sure the power switch is in the off position O and make sure it is disconnected from the power supply.
5. Stow your AirHood on a countertop or hang it up and create more space.

CLEANING AND CARE

Note

• Do not use solvents, chemical or abrasive cleaning agents, wire brushes, sharp objects or scouring pads to clean the AirHood.
• Never immerse the AirHood main body, charger/power cord in water.

The AirHood is designed to make cleaning quick and easy. To keep your AirHood in tip top condition, we recommend that you clean the main unit and the front filter after each use and change the rear filter after every 100 hours of use.

1. Make sure the power switch is in the off position O and that the AirHood is disconnected from the power supply.
2. The air duct is fixed into place with magnets. Simply pull the tab on the top of the air duct to release and remove it. Similarly, pull the tab on the air diffuser on the back of the AirHood and remove it.
3. The front filter is attached to the back of the air duct. It comprises 2 parts, the stainless steel mesh and the frame that holds the mesh in place. Turn the front filter frame anticlockwise to remove it from the air duct. Then, pop out the wire mesh.

TIP: When reassembling the front filter, make sure you put the mesh into the front filter frame, align the frame with the groves on the air duct and then twist the front filter frame clockwise until the two parts slot firmly together.

If the rear filter becomes a bit wet (this may happen when it is used for filtering water vapor), remove the rear filter and let it dry naturally away from the AirHood. We recommend that you also check the front filter for moisture and if necessary dry it with a towel. Only reassemble when both filters are completely dry.

4. If it is time to change the rear filter, lift out the old one and replace after cleaning the main body.
TIP: When you handle the rear filter, you may see some carbon / charcoal residues (little black specks), this is normal and does not mean that the rear filter is degrading.
When inserting a new filter. Make sure the filter is tucked behind the two clips that hold it in place.
5. Clean the main body with a damp soft cloth.
6. Clean the air duct, front filter and air diffuser using a mild detergent and soft cloth. Only the front filter is dishwasher safe. Do not put any other parts in a dishwasher.
7. Dry all parts thoroughly and reassemble the AirHood.

STORAGE INSTRUCTIONS

• If you are not using the AirHood for a long period, always clean and store it in its original packaging in a dust-free, dry environment.
• Coil the power cord and plug and insert into the cord storage area.

TROUBLESHOOTING

The AirHood
is not working.| Power supply issues.| Unplug and then plug it back in making sure the plug is firmly connected to the mains socket.
The fuse in the plug may have blown.
Change the fuse.
The AirHood doesn’t appear to be working optimally.| The setting is too low.| Try a higher setting.
---|---|---
| The AirHood is dirty and/or the rear filter needs changing.| Clean the unit as described in the CLEANING AND CARE section and/or change the rear filter if it is clogged or has been used for 100 hours.

DISPOSAL

Proper disposal of this product.

This symbol indicates that this appliance may not be treated as household waste. Instead, it should be taken to the appropriate collection point for recycling electrical and electronic equipment.
Please use the return or collections services available in your community or contact the retailer where you purchased this product.

TECHNICAL SPECIFICATIONS

GENERAL

Dimensions Main Unit (H × W × D)| 13.15 × 8.70 × 5.51 “ (334 × 221 × 140 mm)
Weight Main Unit| 3.92 Ibs (1.78 kg)
Shell Material| UL94-V0 rated ABS (flame-retardant)
Rated Voltage| 100 – 240 V AC 50/60 Hz 36W
Front Filter| Ø 5.71 × 0.12 “ (Ø 145 × 3 mm)
stainless steel mesh, dishwasher safe
Rear Filter| Ø 140 × 8 mm, carbon content ≥ 70 %, replaceable
Country of Origin| China
SPEED SETTING| I| II| III
Fan Speed| 3,100 rpm +/- 5%| 4,000 rpm +/- 5%| 5,000 rpm +/- 5%
Noise Level (distance of 1m / 3.3 feet)| Sound Proof Room:
< 60 dBA| Sound Proof Room:
< 65 dBA| Sound Proof Room:
< 70 dBA
Airflow| 1.1 – 1.33 m³/min| 1.45 – 1.8m³/min| 2 – 2.5 m³/min

Officially ETL-certified as Air Cleaner.
Biconic LimitedUnit B | 21/F | Legend Tower | 7 Shing Yip Street | Kwun Tong | Kowloon | Hong Kong

Specifications:

• Product Name: AirHood (AH-01AE)
• Intended Use: Household applications
• Not for: Commercial, industrial, or outdoor use
• Features: Front and rear filters, air diffuser, power cord storage

Frequently Asked Questions (FAQ):

1. Can I use the AirHood for commercial or outdoor purposes?

No, the AirHood is intended for household applications only and should not be used commercially or outdoors.

2. What should I do if the plug does not fit in the outlet?

If the plug does not fit fully in the outlet, reverse the plug.
If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>