Plawdlik Folding Adirondack Chair Instruction Manual
- June 17, 2024
- Plawdlik
Table of Contents
IMPORTANT
RETAIN FOR FUTURE REFERENCE
READ CAREFULLY
ASSEMBLY INSTRUCTIONS
Folding Adirondack Chair
Note:
- Do not use electric screwdriver.
- Two people are required to assemble this item. Assemble the item on a flat, solid and even surface.
- Make sure that all the necessary parts are in the box before starting the assembly.
- Please secure all parts and bolts loosely, only when the frame is complete should you fully tighten the screws.
- If any instability occurs, loosen the screws, re-align the components as necessary and retighten the screws evenly.
- This item is not a climbing frame or toy.
- Danger of suffocation. Keep out of reach of children.
- WARNING: Be very careful when folding chair to avoid smashing your hands or fingers.
Parts List
Hardware List
Note:
Before beginning assembly of product, make sure all parts are present. Compare
parts with package content list.
If any part is missing or damaged, do not attempt to assemble the unit.
Contact customer service for replacement parts.
Assembly Instructions
Step 1: Pass the pins and Hardware ② (M6×60 Bolt) through Part B (Right Chair Leg) . Part C (Left Chair Leg) to perform the same operation.Step 2: Attach Part B ( Right Chair Leg) and Part C (Left Chair Leg) to Part A(Chair Seat) with Hardware ② (M6×60mm Bolt), ⑥(WASHER) and ⑦(NUT).Step 3: Secure Part J (Cup holder) to Part D (Right Chair Arm) using Hardware④(M6×30mm Bolt) .Step 4: Secure Part D(Right Chair Arm) to the right leg, and attach Part E(Left Chair Arm) to the left leg, using Hardware② (M6×60mm Bolt), Hardware⑥ (Washer) and Hardware⑦(M6 Nut).Step 5: Attach Part F (Chair Backrest) to the armrests using Hardware ①(M6×80mm Screw)Step 6: Connet Part G (back Rail) to the seat panel using Hardware⑤ (M6×40mm Screw). Secure the upper hole of part I to the back panel using Hardware ⑤ (M6×40mm Screw). Secure the lower hole of part I to the seat panel using Hardware③ (M6×50mm Bolt), Hardware⑥ (Washer) and Hardware⑦ (Nut). Repeat the part I assembly on the other side.Step 7: Secure Part H (Front Rail) to Part B (Right Chair Leg) and Part C (Left Chair Leg) using Hardware ⑤ (M6×40mm Screw). Assembly is complete. Lock all the hardware and you can use this Adirondack chair. Congratulations! Assembly of your Adirondack Chair is complete. To fold the chair, remove adjustment pins for both legs and collapse as shown below .The ExxonMobil HDPE material used in this product has resilience, so if you encounter difficulties inserting adjustment pins, please lift the armrest slightly upwards to insert adjustmentpins