AudioControl PNW Series 5 X 7inch High Fidelity Coaxial Speakers User Manual
- June 17, 2024
- AudioControl
Table of Contents
AudioControl PNW Series 5 X 7inch High Fidelity Coaxial Speakers
Product Specifications
- Model: PNW-57
- Type: High-Fidelity Coaxial Speakers
- Speaker Wire Gauge: 14-18 gauge
- Crossover Type: 1st order series resistor crossover network
Product Usage Instructions
Installation
- Ensure the speakers are properly secured in the vehicle to prevent any accidents or damage.
- Use 14-18 gauge speaker wire to connect the speakers to the audio system.
- If you are not familiar with car audio installations, it is recommended to seek assistance from a qualified AudioControl dealer.
Crossover Network
- The 1st order series resistor crossover network helps in dividing the audio frequency spectrum between the woofer and tweeter.
- Benefits of using this crossover network include maintaining a relatively constant impedance, protecting the tweeter, and potentially improving sound quality.
FAQ
-
Q: Can I use any gauge of speaker wire for the PNW Series Speakers?
A: It is recommended to use 14-18 gauge speaker wire to ensure adequate current to the speakers. -
Q: Do I need to install a crossover network for the speakers?
A: The PNW-57 speakers come with a 1st order series resistor crossover network built-in for optimal audio performance.
PNW-57
HIGH-FIDELITY COAXIAL SPEAKERS
FEATURES
- Edge-enhanced steel frame for added structural strength
- Black anodized voice coil former for superior heat dissipation
- Linear double-roll surround for precision cone movement
- Complex FEA designed high-efficiency motor
- Rigid poly mica-coated cone for optimized sound reproduction
- Rear dampened hybrid silk dome tweeter for extended frequency response
- Concentric point source design for a seamless transition from midrange to tweeter
- Sonic diffuser and radiant collar for better off-axis frequency response
- High-quality mounting hardware included
- Umbrella not included
Important Safety Instructions
- Read these instructions.
- Keep these instructions.
- Heed all warnings.
- Follow all instructions.
- Do not submerge this apparatus in water.
- Clean only with a dry cloth.
- WARNING: The speakers must be properly secured in the vehicle. Improper installation may lead to permanent injury or death. Installation of the speakers must be done with great care by qualified personnel, to prevent damage to fuel lines, power and other electrical wiring, hydraulic brake lines, and other systems, that might compromise vehicle safety.
- Use speaker wire of sufficient size to ensure adequate current to the speaker. For PNW Series Speakers, this means 14-18 gauge speaker wire.
- Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as the power input terminals are damaged, objects have fallen into the apparatus, does not operate normally, or has been dropped.
- Not tested for use in Bigfoot’s Cave.
- Exposure to high sound pressure levels may lead to permanent hearing loss. Take every precaution to protect your hearing.
- The exclamation point within an equilateral triangle is intended to alert the user of the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
- Recycling notice: If the time comes and this apparatus has fulfilled its destiny, do not throw it out into the trash. It has to be carefully recycled for the good of mankind, by a facility specially equipped for the safe recycling of electronic apparated. Please contact your local or state recycling leaders for assistance in locating a suitable nearby recycling facility. Or, contact us and we might be able to repair it for you.
Speaker Talk
- Right on! You got yourself some shiny new AudioControl speakers. After you’re done admiring the quality workmanship and attention to detail, you need to get these bad-boys installed.
- If you did not attend auto-shop in school or are having trouble plugging in power tools, your best bet is to seek out a qualified AudioControl dealer. They have the skills, experience, and specialized tools to get your vehicle sounding like a live concert and they usually smell alright too.
Crossover
- The 1st order series resistor crossover network is an effective solution for dividing the audio frequency spectrum between the woofer and tweeter. One of the main benefits of using a 1st order series resistor crossover network is that it maintains a relatively constant impedance, which can be advantageous for certain amplifier and speaker combinations.
- Another benefit of using a 1st order series resistor crossover network is that it can be used to protect the tweeter from damage. By adding a resistor in series with the tweeter, the power delivered to the tweeter can be limited, which can help to prevent it from being overloaded and potentially damaged. This can be particularly important in high-powered audio systems. Additionally, the use of a series resistor can help to mitigate phase issues between the woofer and tweeter, resulting in improved sound quality.
- First-order crossovers have very shallow slopes – 6dB per octave. That means if your crossover is at 2,000Hz, then at 1,000Hz, one octave down, the tweeter is still getting 1/4 of the music power; at 500Hz, two octaves down, the tweeter is getting 1/16th of the music power, about 6%.
- In summary, the benefits of using a 1st order series resistor crossover network include a relatively constant impedance, protection for the tweeter, simplicity of design and implementation, and potential improvement in sound quality.
Specifications
- Crossover Type ………………………………………………………………… Butterworth
- DC Resistance (Re) ………………………………………………………………….. 2.3 ohms
- Filter Type ……………………………………………………………………………………….. HP
- System Frequency Response ……………………………………………… 60-20K Hz XO
- Frequency …………………………………………………………………………. 5250 Hz
- Slope (Octave) ……………………………………………………………………………… -6 dB
- Tweeter Voice Coil Diameter …………………………………………………… 20 mm
- Midrange Voice Coil Diameter ………………………………………………… 35 mm
Dimensions
- Overall Diameter (A)(a) ……………………….. 5.5 x 8.73 in / 140.6 x 221.9 mm
- Cut Out Diameter (B)(b) …………………………..4.64 x 6.96 in / 118 x 177 mm
- Mounting Depth (C)………………………………………………. 2.24 in / 57 mm
- Height (D) ……………………………………………………………. .0.22 in / 5.6 mm
- Motor Diameter (w/ Cover) (E) …………………………………… .4.17 in / 106 mm
Simple installation instructions
Factory Location Installation
- Wow! Look how far we have come, you made it to page 5! For those brave enough to tackle the installation on their own, proceed to the next steps. For those feeling out of their comfort zone, don’t be threatened, help is available. Our suggestion is that you seek out a qualified AudioControl dealer. They have the skill set and experience to get your new PNW-57 installed properly.
- First, remove the factory grille or panel to gain access to the factory speaker. Next, remove the factory speaker and disconnect the necessary wiring. After the speaker has been wired, mount the speaker where you removed the factory speaker using the factory speaker hardware.
- Large speaker terminal = positive (+).
- Small speaker terminal = negative (-).
Custom Location Installation
First, determine where the speaker will be mounted. Next, make sure the area
has a flat surface for the speaker to mount. Check the mounting depth of the
desired location (use page 4 for midrange mounting dimensions.) If the speaker
will be mounted in a door, roll the windows up / down and lock / unlock the
doors making sure there are no obstructions the speaker will hit. Using the
cut out template, mark the location for the speaker to be mounted. With the
tool of your choice cut out the marked hole. After the speaker has been wired,
place the speaker into the hole. Use supplied mounting hardware to keep
speaker in place.
- Large speaker terminal = positive (+).
- Small speaker terminal = negative (-).
The Warranty
- In just the same way as being covered in honey and thrown into a dark pit full of hungry woodchucks, people are scared of warranties. Lots of fine print. Months of waiting around.
- Well, fear no more. This warranty is designed to make you rave about AudioControl. It’s a warranty that looks out for you and your client, plus helps you resist the temptation to have your friend Sparky, who’s “good with electronics,” try to repair your AudioControl product. So go ahead, read this warranty, then register the information at www.audiocontrol.com/product-registration and include your comments.
- Our warranty has conditional conditions! “Conditional” doesn’t mean anything ominous. The Federal Trade Commission tells all manufacturers to use the term to indicate that certain conditions have to be met before they’ll honor the warranty. If you meet all of these conditions, AudioControl will, at its discretion, repair or replace any AudioControl speaker products that exhibit defects in materials and/or workmanship for one (1) year from the date you bought it. We will repair or replace it, at our option, during that time.
Here are the conditional conditions:
-
You must fully register your purchase within 15 days of the purchase date by going to the AudioControl product registration page at: www.audiocontrol.com/product-registration
Failure to register your product will negate the warranty. -
You need to hold on to your sales receipt! All warranty service requires original sales receipt documentation. The warranty only applies to the original purchaser from an authorized AudioControl dealer. Note: Products purchased from unauthorized dealers are not covered under warranty.
-
The AudioControl speaker products must have originally been purchased from an authorized AudioControl dealer. If an authorized AudioControl dealer installs your AudioControl product, the warranty is extended to two (2) years.
-
Our warranty covers AudioControl products that have been installed according to the instructions in this manual.
-
You cannot let anyone who isn’t: (A) the AudioControl factory; or (B) someone authorized in writing by AudioControl, service your AudioControl product. If anyone other than (A), or (B) messes with your AudioControl product, the warranty is void.
-
The warranty is void if the serial number is altered, defaced or removed, or if your product has been used improperly. Now that may sound like a big loophole, but here is what we mean by this: Unwarranted abuse is:
-
physical damage (don’t use your product to pound in fence posts);
-
improper connections (120 volts into the speaker terminals can fry the poor thing). This is the best product we know how to build, but for example, if you mount it to the front bumper of your car, drop it over Niagara Falls, or use it for anchoring your boat, something will go wrong.
Assuming you conform to 1 through 6, and it really isn’t all that hard to do,
we get the option of fixing your product, or replacing it with a new one, at
our discretion.
In the event that your product is out of warranty or not covered under our
warranty, you may request to have any damage repaired at our normal “Out of
Warranty” repair cost.
Legalese
The warranty above is the only warranty issued by AudioControl. This warranty
gives you specific legal rights, and you may also have rights that vary from
state to state.
Promises of how well your AudioControl product will work are not implied by
this warranty. Other than what we’ve said we’ll do in this warranty, we have
no obligation, express or implied. We make no warranty of merchantability or
fitness for any particular purpose. Also, neither we nor anyone else who has
been involved in the development or manufacture of the unit will have any
liability for any incidental, consequential, special, or punitive damages,
including but not limited to any lost profits or damage to other parts of your
system by hooking up to the unit (whether the claim is one for breach of
warranty, negligence of other tort, or any other kind of claim). Some states
do not allow limitations of consequential damages.
- For more information about this fine product, and for additional details of the limited warranty and repair services, please visit www.audiocontrol.com
- For technical questions, please visit www.audiocontrol.com/knowledge-base/
- AudioControl, Inc.
- 22410 70th Avenue West
- Mountlake Terrace, WA 98043 USA
- Phone: 425-775-8461
- email: sound.great@audiocontrol.com
- ©2023 AudioControl. All rights reserved.
- As technology advances, AudioControl reserves the right to continuously change our specifications, like our Pacific Northwest weather, although we are working on changing that as well.
The End ( Thanks for hang’n in there)
Documents / Resources
|
AudioControl PNW Series 5 X 7inch High Fidelity Coaxial
Speakers
[pdf] User Manual
PNW-57, PNW-525, PNW Series 5 X 7inch High Fidelity Coaxial Speakers, 5 X
7inch High Fidelity Coaxial Speakers, High Fidelity Coaxial Speakers, Fidelity
Coaxial Speakers, Coaxial Speakers, Speakers
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>