acer XV345CURV3BMIPHUZX LCD Monitor User Guide
- June 17, 2024
- Acer
Table of Contents
Acer LCD Monitor Quick Start Guide (QSG)
Important safety instructions
Please read the following instructions carefully.
-
To clean the LCD monitor screen:
• Trun off LCD monitor and unpplug the power cord.
• Spray a non-solvent cleaning solution onto a rag and clean the screen gently. -
Do not place the LCD monitor near a window. Exposing the monitor to rain, moisture or sunlight can severely damage it.
-
Do not apply pressure to the LCD screen. Excessive pressure may cause permanent damage to the display.
-
Do not remove the cover or attempt to service this unit yourself. An authorized technician should perform servicing of any nature.
-
Store the LCD monitor in a room with a temperature of -20° to 60° C (-4° to140° F). Storing the LCD monitor outside this range may result in permanent damage.
-
Immediately unplug your monitor and call an authorized technician if any of the following circumstances occur:
• Monitor-to-PC signal cable is frayed or damaged.
• Liquid spills onto the LCD monitor or the monitor is exposed to rain.
• The LCD monitor or case is damaged.
Attaching the monitor to the base
- Remove the monitor from the packaging.
- Remove the screws of the base for use, align the neck with the base,and tighten the screws.
- Clip the bracket into the notch of the rear housing in sequence and press it down. Hear a “click” and the installation is completed.
Connecting your monitor to a computer
- Turn off your computer and unplug your computer’s power cord.
- Connect the signal cable to the HDMI (optional) and /or DP (optional) and /or Type C (optional) input socket of the monitor, and the HDMI (optional) and /or DP (optional) and / or Type C (optional) output socket of the graphics card on the computer.
- USB Type C Cable (Optional, USB Type C input models only) Connect one end of the USB type C cable (optional) to your computer and connect the other end to your electric devices.
- Connect the USB Cable(Optional) Connect the Type-C cable to port for fast charge. Connect the USB 2.0/USB-B cable to port.
- Insert the monitor power cable into the power port at the back of the monitor.
- Plug the power cords of your computer and your monitor into a nearby electrical outlet.
- Connecting HDMI/DP+USB-B to computer 1 and USB-C to computer 2 when Control up to 2 computers from a single set of keyboard and mouse connected to the monitor.
Note:
Audio output is only for audio output model. Please check user manual for more
instruction.
Transmitting the 4K 180Hz signal via one DP 1.4 port.
FreeSync Premium
It can allow a FreeSync Premium supported graphics source to dynamically
adjust display refresh rate based on typical content frame rates for power
efficient, virtually stutter free and low-latency display update.
External
controls
1| Power button/OK Key| a. Power on; Press more than 5 seconds to turn off the
power.
b. Press to view the home page. Press again to go to the next function in the
function menu.
---|---|---
2| Four directions key | a. Press to any directions key to display first menu.
b. The four directional buttons on the back of the monitor are like a
joystick.
To move the cursor, just toggle buttons in four directions. Press the button
to select the desired option. Red indicates operational.Grey indicates
inoperable.
Note: Acer monitor is purposed for video and visual display of
information obtained from electronic devices.
Regulations and safety notices
FCC notices
This device has been tested and found to comply with the limits for a Class
B digital device pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This device generates, uses, and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this device does cause harmful
interference to radio or television reception, which can be determined by
turning the device off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the device and receiver.
- Connect the device into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/television technician for help.
CE declaration of conformity
Hereby, Acer Inc., declares that this LCD monitor is in compliance with the
essential requirements and other relevant provisions of EMC Directive
2014/30/EU, Low Voltage Directive 2014/35/EU, and RoHS Directive 2011/65/EU
and Directive 2009/125/EC with regard to establishing a framework for the
setting of ecodesign requirements for energy-related product.
Notice: Shielded cables
All connections to other computing devices must be made using shielded cables
to maintain compliance with EMC regulations.
Notice: Peripheral devices Only peripherals (input/output devices, terminals,
printers, etc.) certified to comply with the Class B limits may be attached to
this equipment. Operation with non-certified peripherals is likely to result
in interference to radio and TV reception.
Caution
Changes or modifications not expressly approved by the manufacturer could void
the user authority, which is granted by the Federal Communications Commission,
to operate this product.
In order to prevent damage to the monitor, do not lift the monitor by its
base.
Operation conditions
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause ndesired
operation.
Notice: Canadian users
CAN ICES-003(B) NMB-003(B)
Disposal of waste equipment by user in private household in the European Union
This symbol on the product or on its packaging indicates that this product
must not be disposed of with your other household waste. Instead, it is your
responsibility to dispose of your waste equipment by handing it over to a
designated collection point for the recycling of waste electrical and
electronic equipment. The separate collection and recycling of your waste
equipment at the time of disposal will help to conserve natural
resources and ensure that it is recycled in a manner that protects human
health and the environment. For more information about where you can drop off
your waste equipment for recycling, please contact your local city office,
your household waste disposal service or the shop where you purchased the
product.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>