Bellman Symfon BE1370 Pro Classic Alarm Clock Instruction Manual
- June 17, 2024
- Bellman Symfon
Table of Contents
Bellman Symfon BE1370 Pro Classic Alarm Clock
Model Overview
Remove the battery tab
Connect the alarm clock
Set the tim e
Set the alarm
Activate the alarm
Snooze
Night light
Settings
VISIT MODEL
Pairing with a Visit transmitter
Additional regulatory information
- This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the bot-tom of this equipment is a label that contains, among other information, a product identifier in the format US:AAAEQ##TXXXX. If requested, this number must be pro-vided to the telephone company.
- An applicable certification jacks Universal Service Order Codes (USOC) for the equipment is provided (i.e., RJ11C) in the packaging with each piece of approved terminal equip-ment.
- A plug and jack used to connect this equipment to the premises wiring and telephone network must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. A compliant telephone cord and modular plug is provided with this product. It is designed to be connected to a compatible modular jack that is also compliant. See in-stallation instructions for details.
- The REN is used to determine the number of devices that may be connected to a telephone line. Excessive RENs on a telephone line may result in the devices not ringing in response to an incoming call. In most but not all areas, the sum of RENs should not exceed five (5.0). To be certain of the number of devices that may be connected to a line, as determined by the total RENs, contact the local telephone company. [For products approved after July 23, 2001, the REN for this product is part of the product identifier that has the format US:AAAEQ##TXXXX. The digits represented by ## are the REN without a decimal point (e.g., 03 is a REN of 0.3). For earlier products, the REN is separately shown on the label.]
- If this alarm clock equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. But if advance notice isn’t practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary.
- The telephone company may make changes in its facilities, equipment, operations or procedures that could affect the operation of the equipment. If this happens the telephone company will provide advance notice in order for you to make necessary modifications to maintain uninterrupted service.
- Should you experience trouble with this equipment, please contact your retailer for information about warranty and service. If the equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equipment until the problem is resolved.
- Please follow instructions for repairing if any (e.g. battery replacement section); otherwise do not alternate or repair any parts of device except specified.
- Connection to party line service is subject to state tariffs. Contact the state public utility commission, public service commission or corporation commission for information.
- NOTICE : If your home has specially wired alarm equipment connected to the telephone line, ensure the installation of this alarm clock does not disable your alarm equipment. If you have questions about what will disable alarm equipment, consult your telephone company or a qualified installer.
NOTICE: According to telephone company reports, AC electrical surges, typically resulting from lightning strikes, are very destructive to telephone equipment connected to AC power sources. To minimize damage from these types of surges, a surge arrestor is recommended.
Applicable for Coin or Pay Phone Only
To comply with state tariffs, the telephone company must be given notification
prior to connection for customer-owned coin or credit card phone. In some
states, the state public utility commission, public service commission or
corporation commission must give prior approval of connection.
For use in all EU countries
Hereby, Bellman & Symfon declares that this Alarm Clock is in compliance with
the essential requirements and other relevant provisions of directives: RED
Directive 2014/53/EU
Use and disposal of batteries
Replace only with the same or equivalent type recommended by the manufacturer.
Please dispose of old, defective batteries in an environ- mentally friendly
manner in accordance with the relevant leg-islation in your country.
FCC compliance statement
- REN: 0.1B
- US: 1PNRG01BBERXTE1
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on acircuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
For a complete Declaration of Conformity please contact: info@bellman.com or call +46 31 68 28 20
Statement for Industry Canada
This Class B digital apparatus complies with Canadian ICES-003.
- BE1580: HMV 16.99.09.3021
- BE1370: HMV 16.99.09.3022
- BE1350: HMV 16.99.09.3023
European office
- Bellman & Symfon Europe AB Södra Långebergsgatan 30 436 32 Askim
- Sweden
- Phone +46 31 68 28 20
- Fax +46 31 68 28 90
- E- mail info@bellman.com
Asia Pacific office
- Bellman & Symfon Asia Ltd.
- 1115-16, Main Tower, GD Int’l Bldg
- 339 Huanshi Dong Rd
- Guangzhou, China, 510095
- Phone +86 20 8318 2950
- Fax +86 20 8333 5528
- E-mail info.cn@bellman.com
© 2018, Bellman & Symfon AB, all rights reserved. Bellman, Bellman & Symfon and the Bellman & Symfon logo are registered trademarks of Bellman & Symfon AB.
DESIGN FOR EARS™
bellman.com
BE1580_067MAN010