db Link DBLBT1 Bluetooth Control Module Instruction Manual
- June 17, 2024
- db Link
Table of Contents
DBLBT1 Bluetooth Control Module
BLUETOOTH CONTROL MODULE
DB Link is a Registered Trademark of
DB Research L.L.P.
Designed and Engineered in the U.S.A.
www.dblink.net
Contact us at: 1-800-787-0101
support@dbdrive.net
DB LINK DBLBT1 BLUETOOTH CONTROL
The DBLBT1 is an easy to operate
Bluetooth Volume Control Knob.
One simple knob controls all
Bluetooth functions as well as the
system volume!
HOW TO PAIR THE DBLBT1 TO YOUR BLUETOOTH DEVICE
STEP 1 : Turn on DBLBT1 by turning on your 12 volt ignition or dash
switch.
The blue LED will indicate that the DBLBT1 is powered on.
STEP 2: Press in and hold the control knob until you see the blue
indicator
flashing. Once flashing, the DBLBT1 is ready to be paired with your
Bluetooth device.
STEP 3: From your device’s Bluetooth pairing menu, find the DB Link BT
and connect to it.
CONTROL KNOB OPERATING INSTRUCTIONS
AUDIO PLAY : Start your media player or
music streaming.
AUDIO PAUSE: Tap the knob once to pause,
tap a second time to resume play mode.
TRACK FORWARD: Turn the knob
counter-clockwise for approximately 1
second.
VOLUME UP: Turn and hold the knob
Clockwise to desired volume level.
VOLUME UP: Turn and hold the knob
Counter-clockwise to desired volume level.
WIRING INSTRUCTIONS
Red Wire 12v +
Wire to 12v positive (+)
switched ignition or dash
switch
Blue Wire 12v +
Wire to amp remote
turn on input
Black Wire 12v Ground
Negative (-) ground
terminal or ground
terminal block
RCA Cables
RCA inputs on amp
NOTE: To power unit on and off manually – simply push in and hold the
knob until the unit powers on or off.
MOUNTING INSTRUCTIONS
Remove the surface mount portion of the controller by unscrewing the large nut
on the DBLBT1 back section. Drill a 1” or 25mm hole in your desired mounting
location making sure that you have checked your wires or anything else that
could
be affected by the drilling into the dash. Install the controller from the
front and
secure it with the main body nut from behind. Make sure the Bluetooth knob is
correctly oriented before tightening into place.
UNDER DASH MOUNT
Use two included screws to mount controller under the dash on surface mount
applications using the supplied bracket.
Notice: This unit is universal . Professional installation is highly
recommended to ensure proper fit and performance. In no
event shall DB Research LLP be liable for any direct, indirect, punitive,
incidental, special consequential damages, to property
or life, whatsoever arising out of or connected with the use or misuse of our
products.”
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>