taurus HD2000D Digital Force 2000 Ionic Instruction Manual

Table of Contents

Digital Force 2000 Ionic HD2000D

(Original instructions)

DESCRIPTION

Temperatures:

Blue light – Cold air
Green light – Hot air 60ºC
Purple light – Hot air 80ºC
Red light – Hot air 100ºC
Red / blue light – Hot air 100ºC alternating cycles of 5 seconds of cold air
If the model of your appliance does not have the accessories described above, they can also be bought separately from the Technical Assistance Service.

Fully extend the appliance’s power cable before each use.
Do not use the appliance if its accessories are
Do not use the appliance if the accessories attached to it are defective. Replace them immediately.
Do not use the appliance if the on/off switch does not work.
Unplug the appliance from the mains when not in use and before undertaking any cleaning task.
Store this appliance out of reach of children and/or persons with physical, sensory or reduced mental or lack of experience and knowledge. Do not store the appliance if it is still hot.
Make sure that dust, dirt or other foreign objects do not block the fan grill on the appliance. Keep the appliance in good condition. Check that the moving parts are not misaligned or jammed and make sure there are no broken parts or anomalies that may prevent the appliance from operating correctly.
Never leave the appliance unattended while in use.
Do not leave the unit running on a surface.
Do not use the appliance to dry pets or animals. Do not use the appliance to dry textiles of any kind.

BEFORE USE:

Make sure that all products’ packaging has been removed.
Some parts of the appliance have been the appliance is used a light smoke may be detected. After a short time, this smoke will disappear.

USE:

Extend the cable completely before plugging it in.
Connect the appliance to the mains. the desired direction.
Turn the appliance on, by using the speed selector button (C).
Select the desired temperature.
To improve the outcome the appliance should be used at low speed and soft power. In addition it should be kept at a distance of between 10 and 15 cm from the user head.

IONIC FUNCTION

The appliance can generate negative ions. Once the appliance is in operation, it automatically activates the generation of negative ions.
Negative ions are useful for removing the static electricity and hair frizz.
COOL AIR BLOW: to shape the hair.
To use this function, press button (B) until the light is blue.
ONCE YOU HAVE FINISHED USING THE APPLIANCE:
Stop the appliance using the speed selector (C). Unplug the appliance from the mains.

Air concentrator accessory (F):
This accessory is used to concentrate the air
Place the concentrator at the air outlet (A) when the appliance is switched off and has cooled down completely.

The appliance has a safety device, which protects the appliance from overheating. When the appliance switches itself on and off repeatedly, for reasons other than the thermostat control, check to ensure that there are no obstacles that impede correct air entry or expulsion.
If the appliance turns itself off and does not switch itself on again, disconnect it from the mains supply, and wait for approximately 15 minutes before reconnecting. If the machine does not start again seek authorised technical assistance.

CLEANING

Disconnect the appliance from the mains and allow it to cool before undertaking any cleaning task.
Clean the equipment with a damp cloth with a few drops of washing-up liquid and then dry. Do not use solvents, or products with an
acid or base pH such as bleach, or abrasive products, for cleaning the appliance.
Do not let water or any other liquid get into the air vents to avoid damage to the inner parts of the appliance.
Never submerge the appliance in water or any other liquid or place it under running water.

CLEANING THE FILTER (FIG.1):

The air inlet filter should be cleaned periodically for proper operation of the device. To do this, turn the filter counterclockwise. Clean the filter and remove any dirt or hair. Put the filter back in its place and turn clockwise.