FANSTEL EV-BT680F HCI Evaluation Board User Guide

EV-BT680F/T/E HCI Evaluation Board
Quick Start Guides

EV-BT680F HCI Evaluation Board

EV-BT680F/E
Evaluation board includes an USB cable for connection to PC.

• To use a PC to evaluate HCI commands, set SW1 (GPIO 1) to L.
• Set SW1 to H for stand alone operation.

EV-BT680TA
EV-BT680TA can be used for evaluation of BT680T or BT680TA (Automobile temperature). It consists of main board and USB-UART bridge board. The main board operates in automative temperature range except two white power connectors on the left side. After high temperature testing, you may have to solder power supply wires on board if white plastic melt.
To evaluate:

• Connect USB-UART bridge board to JS2 of main board as shown below.
• Connect to a Windows PC USB port.

Windows PC HCI Evaluation Software
Download BT680_HCItool files from this webpage and install.
https://www.fanstel.com/download-bluefanmodule- document

PC Com Port

• Connect evaluation board to a PC COM port.

• Check the Device Manager.

• Silicon Labs CP210x USB to UART Bridge should appear.

• If not, download the driver from Silicon Labs website.
  https://www.silabs.com/products/developmenttools/software/usb-to-uart-bridge- vcp-drivers

• Launch Fanstel BH68X HCI tool and scan COM port.

• Select the COM port where BT680/1 is connected.

• Check reset and make sure there is a Reset OK response.

• The tool support basic HCI commands.

• The sensor screen allows setting BLE parameters and advertising.

Standalone Code Development and Programming

To develop user application codes and program into BT680F modules, you need:

• IAR tool chain

• ARM-JTAG-20-10 adapter cable.
  https://www.mouser.com/ProductDetail/Olimex-Ltd/ARM- JTAG-20-10?qs=DUTFWDROaMbVQp3WoAdijQ==

• JLINK-ARM
  https://www.digikey.ca/product-detail/en/iarsystems-software-inc/JLINK-ARM /JLINK-ARM-ND/2021939
  Toshiba HCI Command document can be downloaded from:
  https://www.fanstel.com/download-bluefanmoduledocument

Fanstel Corporation
7466 E. Monte Cristo Ave. Scottsdale, AZ 85260 USA
t: 1 480.948.4928
f: 1 480.948.5459
e: info@fanstel.com
w: http://www.fanstel.com
V1.00, Sep. 2019

Documents / Resources

| FANSTEL EV-BT680F HCI Evaluation Board [pdf] User Guide
EV-BT680F HCI Evaluation Board, EV-BT680F, HCI Evaluation Board, Evaluation Board, Board
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>