AVENTICS ED07 EP-Pressure Controller ED07 290psi VDS Instructions
- June 4, 2024
- AVENTICS
Table of Contents
AVENTICS ED07 EP-Pressure Controller ED07 290psi VDS Instructions
Instructions
EP-Pressure Controller ED07 290psi VDS
This short instruction describes all operator control elements as LED and switches of the VDS pressure control valve ED07. For further information please refer to description 5610219900. This manual is available at AVENTICS and must be read thoroughly before installing and initial start-up of the module.
This device fulfils the category 3G and 3D according to ATEX directive 2014/34/EU. If the device is used in potentially explosive atmospheres attention has to be paid for the corresponding themes in the device description.
LED-Diagnosis
| Plate | Color of LED | Meaning |
|---|---|---|
| OK | green | VDS communication OK |
| ERR | red | VDS communication NOT OK |
| 24V | green | Power supply valve |
| 24V | green | Power supply interface |
Y: Status LED
Electrical Connections
- A: Power supply
- B: Data input VDS C: Data output VDS
| Pin 1 | 24V Valve (ext. fuse M 2,5A) |
|---|---|
| Pin 2 | 0V Valve |
| Pin 3 | n.c. |
| Pin 4 | n.c. |
| Pin 5 | FE |
A: Power supply
The 0V of the pressure control valve has to be connected directly with the 0V of the Bus module
The pressure control valve is defined as equip- ment with low energy. It has to be supplied with electrical power from a power pack with over- voltage protection according to standard DIN EN 60079-15: 2011, paragraph 13.
Control Data
The Control data are described in the device description
Declaration of conformity valid until 2016, Apr. 19th)
in accordance with ATEX Directive 94/9/EC
The EMC directive 2004/108/EC also was applied
EU declaration of conformity valid from 2016, Apr. 20th)
in accordance with ATEX Directive 2014/34/EU and in accordance with the EMC directive 2014/30/EU
- Apparatus model/Product: ELECTROPNEUMATIC PRESSURE CONTROL SYSTEM, EDO
- Name and address of the manufacturer:
- This declaration is issued under the sole responsibility of the manufacturer.
- Object of the deciaration EDO7, material number(s):
- The object of the declaration described above is in conformity with the relevant Union harmonisation legislation: as referred to in the headlines of this document
- References to the relevant harmonised and other standards used:
- notified body was not involved
- Additional information:
The instructions in the Operation Manual are to be kept.
Explosive atmospheres — Part 0: Equipment — General requirements
Electrical apparatus for explosive gas atmospheres — Part 15: Construction, test and marking of type of protection ,n* electrical apparatus
We reserve the right to make changes in the declaration. Presently applicable edition can be obtained upon request.
Subject to alternation. Printed in Germany No parts of this edition may be reproduced without our prior permission. R499050039-DAT-001-AE
Internet, http://www.aventics.com
AVENTICS GmbH
Ulmer Str. 4
D-30880 Laatzen
GERMANY
Tel. +49(0)511/2136-0
Fax. +49(0)511/2136-269
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>