MVMT QC1026 3 In 1 Foldable Magnetic Travel Charger User Manual
- June 17, 2024
- MVMT
Table of Contents
MVMT QC1026 3 In 1 Foldable Magnetic Travel Charger
Device Layout
FCC disclaimer
FCC 10 : 2A2YZ-QC1026
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- this device may not cause harmful Interference, and
- this device must accept any interference received, including Interference that may cause undesired operation.
Packaging contents
- 1 x 3 in 1 wireless charger
- 1 x USB-C charging cable
- 1 x Manual
Specifications
- Product name: 3 in 1 wireless charger
- Material quality: ABS
- Dimensions: 24774.57.5MM
- Interface: USB-C
- Input: 9V-3A
- Mobile phone output: 5W/7.5W/ 10W/15W
- iWatch output: 2.5W
- Airpods: 3W
- Compatibility: support mobile phones, Airpods, and IWatch that comply with the QI standard
How to use
The device is connected to the power supply through the charging cable, and
then it can be powered on.
When charging the mobile phone, place the mobile phone flat In the mobile
phone charging area to start charging the mobile phone.
After fully charged, simply take off the phone, during the charging process,
if you need to terminate the charging, take It directly.
When charging the Apple Watch, place the iWatch flat in the charging area to
start charging the watch. After fully charged, directly remove the iWatch;
During the charging process, If you need to terminate the charging, remove the
iWatch directly.
When charging the Airpods , place the Airpods flat in the charging area to
start charging ;
After fully charged, simply remove the Airpods; During the charging process,
If you need to terminate the charging, remove it directly.
Note
- When charging the iwatch, recommended to use flat and . vertical charging at 90 degrees. Do not select 30 degrees, as charging may not be possible at this angle.
- Recommended to use the supplied charging cable for power supply, and not to use the original iphone cable.
FCC STATEMENTS
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co‐located or operating
in conjunction with any other antenna or transmitter.
This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>