LUXUL AP3064 Wi-Fi 6 4×4 Indoor Access Point User Manual
- June 17, 2024
- LUXUL
Table of Contents
LUXUL AP3064 Wi-Fi 6 4×4 Indoor Access Point
Product Information
Specifications
- Model: Wi-Fi 6 AX3600 4×4 Dual-Band Indoor Access Point
- Last Updated: 01/23/2024
- FCC ID: W59AP3064
- IC: 8584A-AP3064
Product Usage Instructions
Regulatory Compliance and Safety
The device complies with Part 15 of the FCC Rules, ensuring that it does
not cause harmful interference and accepts any interference received. To
maintain compliance:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a different circuit from the receiver.
- Consult the dealer or an experienced radio/TV technician for assistance.
Note : Any changes or modifications not approved by the responsible party may void the user’s authority to operate the equipment. The device should not be co-located or operated with any other antenna or transmitter.
Radiation Exposure Statement
The equipment complies with FCC radiation exposure limits for an
uncontrolled environment. To ensure safety, maintain a minimum distance of 49
cm (19.3 in) between the radiator and your body.
Note : Country code selection is only available for non-US models. FCC regulations mandate that all WiFi products marketed in the US must operate on US channels only.
Furthermore, the device is restricted for indoor use only according to FCC regulations.
Warnings and Safety Information
- Ensure that the electrical circuits have appropriate grounding, overload, and surge protection.
- Only attach approved power cords to the device.
- Verify there is adequate ventilation around the device and that ambient temperatures meet equipment operation specifications.
- Do not install the device in hot or humid places, such as a kitchen or bathroom, to minimize exposure to excessive heat or moisture.
- Keep all accessories out of the reach of children, as small parts and plastic bags used for packaging may be harmful.
- Do not install the device where it will be exposed to paper, cloth, or other flammable materials.
Health and Safety Recommendations
Observe all warning notices regarding the use of wireless devices.
Potentially Hazardous Atmospheres
In environments with chemicals or particles (such as grain, dust, or metal
powders), observe restrictions on the use of radio devices in fuel depots,
chemical plants, and similar areas.
Safety in Hospitals
Wireless devices transmit radio frequency energy that may affect medical
electrical equipment. When installing the device adjacent to other equipment,
verify that the adjacent equipment is not adversely affected.
FAQ
Q: Can I use this device outdoors?
A: No, this device is restricted to indoor use only according to FCC
regulations.
Q: How far should I keep the device from my body?
A: To ensure safety, maintain a minimum distance of 49 cm (19.3 in) between
the radiator and your body.
This documentation contains regulatory compliance and safety information. No part of this publication, or any other publication may be modified or adapted in any way, for any purposes without written permission from Luxul. ©2022 Legrand AV Inc. All Rights Reserved. The name Luxul, the Luxul logo, the Luxul logo mark, and Simply Connected are all trademarks and or registered trademarks of Legrand AV Inc. All other trademarks and registered trademarks are the property of their respective holders. LUX-REG-COM-AP-3064-240105-01
Health and Safety Recommendations
Warnings for the use of Wireless Devices
Please observe all warning notices with regard to the use of wireless
devices
Potentially Hazardous Atmospheres
You are reminded of the need to observe restrictions on the use of radio
devices in fuel depots, chemical plants, and other similar areas where the air
contains chemicals or particles (such as grain, dust, or metal powders).
Safety in Hospitals
Wireless devices transmit radio frequency energy and may affect medical
electrical equipment. When installed adjacent to other equipment, it is
advised to verify that the adjacent equipment is not adversely affected.
RF Exposure Guidelines
Safety Information: The device complies with internationally recognized
standards covering human exposure to electromagnetic fields from radio
devices. The following safety precautions should be observed:
- Do not touch or move the antenna while the unit is transmitting or receiving.
- Do not hold any component containing the radio such that the antenna is very close or touching any exposed parts of the body, especially the face or eyes while transmitting.
- Do not operate the radio or attempt to transmit data unless the antenna is connected; this behavior may cause damage to the radio.
ErP Statement
The purpose of this product is to create a constant network connection for
your devices. It does not have a standby mode or use a power management mode.
If you wish to power down this product, please unplug it from the power
socket.
Industry Canada
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Caution
Operation shall be limited to indoor use only; Utilisation limitée à
l’intérieur seulement;
Radiation Exposure Statement
This equipment complies with ISED radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
greater than 30 cm (11.8 in) between the radiator & your body.
Frequency/Band Information
| Channel| Frequency (GHz)| US (FCC)| Industry
Canada
---|---|---|---|---
2.4GHz Band| 1| 2412| P| P
2| 2417| P| P
3| 2422| P| P
4| 2427| P| P
5| 2432| P| P
6| 2437| P| P
7| 2442| P| P
8| 2447| P| P
9| 2452| P| P
10| 2457| P| P
11| 2462| P| P
Frequency/Band Information
| Channel| Frequency (GHz)| US (FCC)| Industry
Canada
---|---|---|---|---
5GHz Band| 36| 5.180| P| P
40| 5.200| P| P
44| 5.220| P| P
48| 5.240| P| P
52 (DFS)| 5.260| P| P
56 (DFS)| 5.280| P| P
60 (DFS)| 5.300| P| P
64 (DFS)| 5.320| P| P
100 (DFS)| 5.500| P| P
104 (DFS)| 5.520| P| P
108 (DFS)| 5.540| P| P
112 (DFS)| 5.560| P| P
116 (DFS)| 5.580| P| P
120 (DFS)| 5.600| P|
124 (DFS)| 5.620| P|
128 (DFS)| 5.640| P|
132 (DFS)| 5.660| P| P
136 (DFS)| 5.680| P| P
140 (DFS)| 5.700| P| P
144 (DFS)| 5.720| P| P
149| 5.745| P| P
153| 5.765| P| P
157| 5.785| P| P
161| 5.805| P| P
165| 5.825| P| P
FCC STATEMENT—WIRELESS FCC
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
- FCC ID: W59AP3064
- IC: 8584A-AP3064
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of the
following measures:
- Reorient or relocate the receiving antenna.
- X Increase the separation between the equipment and receiver.
- X Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- X Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This device meets all the other requirements specified in Part 15E, Section 15.407 of the FCC Rules.C
RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance 49 cm (19.3 in) between the radiator & your body.
Note : The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all WiFi product marketed in US must fixed to US operation channels only. FCC regulations restrict the operation of this device to indoor use only.
Warnings and Safety Information
- X Ensure that the electrical circuits have appropriate grounding, overload and surge protection.
- X Attach only approved power cords to the device.
- X Verify there is adequate ventilation around the device, and that ambient temperatures meet equipment operation specifications.
- DO NOT install in or near hot or humid places, such as a kitchen or bathroom. Take care to minimize exposure to excessive heat or moisture.
- Small parts and plastic bags used for packaging may be harmful to small children. KEEP ALL ACCESSORIES OUT OF THE REACH OF CHILDREN!
- This product may become hot when in use for extended time periods. This is normal and is not a malfunction. DO NOT install it where it will be exposed to paper, cloth or other flammable materials.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>