GRACO 9120 Pack N Play On the Go Playard Owner’s Manual
- June 17, 2024
- Graco
Table of Contents
GRACO 9120 Pack N Play On the Go Playard
Read all instructions BEFORE assembly and use of this product. Keep instructions for future use. We recommend that you keep these instructions with your Pack ‘N Play. A storage pocket has been provided for them on the bottom panel of your unit.
Congratulations on your purchase of a Graco® Pack ‘N Play®! Graco is the recognized leader in the design and manufacture of quality baby products. We believe your new Graco® Pack ‘N Play® is a wise choice, promising many hours of enjoyment for your baby.
Customer Satisfaction
Our goal is to make every product the best it can be! We are also committed to
supporting our products after purchase. If you would like to speak to Graco
about your product, please contact our Customer Service Department at
1-800-345-4109 or visit our Internet
website, www.gracobaby.com.Our knowledgeable staff
will be ready to answer any questions you may have concerning parts, use or
maintenance. When you call, please have the model and serial numbers ready so
your call may be processed quickly and efficiently. Your Pack ‘N Play® may be
used as a playard or instructions in this manual and those found on the spend
reading the instructions and warnings.
WARNING
Failure to follow instructions
Setting Up the Pack ‘N Play
- THIS PRODUCT REQUIRES ADULT ASSEMBLY.
- Keep fingers clear of top corners during setup.
Be sure Pack ‘N Play is completely set up before use. Check that the four top rails are completely latched, the center of the floor is pushed down, and the mattress is flat and secured by the VELCRO® straps. Always follow the instructions in the owner’s manual to set up the Pack ‘N Play.
- Before each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges.
- Do not use Pack ‘N Play if any parts are missing or broken. Call 1-800-345-4109 for replacement parts or owner’s manual.
- Do not substitute parts.
Using the Pack ‘N Play
- The Pack ‘N Play can be used as a playard or a sleeping crib. When used as a playard, never leave child unattended and always keep child in view.
- When used as a sleeping crib, you must still provide the supervision necessary for the continued safety of your child.
- Always keep the Pack ‘N Play away from hazards in the area that may injure your child.
- Do not add padding or other objects inside the Pack ‘N Play that will permit your child to climb out.
- Stop using this product when your child reaches 35 inches (89 cm) in height, weighs more than 30 pounds (14 kg), or is able to climb out.
- Do not modify Pack ‘N Play or add any attachments that are not listed in the owner’s manual, including an add-on bassinet.
Avoiding Suffocation Hazards
- Unlike cribs that have rigid sides, the Pack ‘N Play has flexible sides. As a result, the Pack ‘N Play mattress is specially designed to prevent suffocation.
- The Pack N Play mattress has a solid base, a certain length and width, and is less than one inch thick in order to meet safety standards.
- Using a thicker or a different sized mattress may allow a child’s head to get between mattress and the side of the Pack ‘N Play causing suffocation.
- TSE ONE THE MATTRESS PROVIDED BY GRACO. Never use additional mattress or padding.
- Never us covers not solidand intended to last pinose. They can cause suffocation.
- Do not use a water mattress with the Pack ‘N Play. Avoiding Strangulation Hazards
- Strings and cords can cause strangulation. Keep strings and cords away from child.
- Do not place the Pack ‘N Play near a window where cords from blinds or drapes can strangle a child.
- Do not hang strings on or over the Pack ‘N Play.
- Do not place items with a string around a child’s neck, such as hood strings, pacifier cords, etc.
- Do not attach strings to toys. This product is not intended for commercial use.
CARE AND MAINTENANCE
FROM TIME TO TIME CHECK YOUR PACK ‘N PLAY
for worn parts, torn material or stitching. Replace or repair the parts as
needed. Use only Graco® replacement parts.
IF PACK ‘N PLAY IS USED AT THE BEACH , you
MUST clean sand off your Pack ‘N Play, including the feet, before packing it
into cover. Sand in top rail lock may damage it.
TO CLEAN PACK ‘N PLAY , use only household soap or detergent and warm
water. NO BLEACH.
TO WASH CARRY BAG , machine wash in lukewarm water on delicate cycle and
drip-dry. NO BLEACH.
Step 1
Undo the three VELCRO* straps. Fold VELCRO® straps back onto themselves. Set
mattress aside.
**Step 2
**
IMPORTANT
Leavecenter of floor UP until all four top rails are latched. Grasp the
bottom of two of the top rails, and pull up until you hear a “click.” Be sure
top rails have become rigid. If not, pull up again until they are rigid.
Top rail
FOR SMOOTH SETUP
and takedown, it’s important to remember one thing: the center of the floor
must be at least halfway up when locking OR unlocking rails (see picture
below).
Therefore
- When setting up, lock rails
- BEFORE lowering center.
- When taking down, raise center halfway BEFORE unlocking rails.
Step 3
Pull up the other two sides until they latch. If top rails do not latch, lift
the center of the floor higher. Center of floor must be at least halfway up
for the latches to catch properly. Be sure all top rails are rigid.
Step 4
Hold one end of the unit up and push the center of the floor down.At first
your Pack ‘N Play maybe like a new pair of shoes.You may need to break it in
bystay down, place some weight (several books) in the center of the unit and
let it stand
overnight.
Step 5
Place in pasted side pour Always use your unit with mattress installed soft
side up. so m to of Pack ‘N Play and fasten to VELCRO” a prevent.
Side Flap (on certain models)
You can raise side flap if desired. at top.
Toy Bag (on certain models)
Toy bag snaps on end of 109 weight 2 1s and a mild detergent.
To Use Your Changing Table (on certain models)
Parts List
CHECK that you have all parts listed below BEFORE assembling your changing table.
- To protect your child from falls and other injuries:
- Always stay within arm’s reach of your child when using the changing table. Always use waist belt when child is on the changing table. Never leave child unattended.
- The changing table is designed for use only with this Graco Pack ‘N Play.
- Do not attempt to use it with any other product. Before each use, make sure the changing table is properly secured to the Pack ‘N Play by pushing down firmly in the middle of the changing table. The changing table should not fall.
- Do not use the changing table as a sleeping or play area.
- Weight limit for the changing table is 25 pounds(11 kg). Do not use the changing table as extra storage. Always remove the changing table when your child is in the Pack ‘N Play.
- The Pack ‘N Play changing table can be used on the floor without being attached to the Pack ‘N Play.
- Never place the changing table on a piece of furniture, bed, counter or any raised surface from which the changing table or your child could fall.
Step 1
Lay changing table flat on floor with short side in front of you and belt
facing up. Gently slide one long tube into opening on long side exactly as
shown. Repeat on other long side.
Step 2
Slide one short tube into opening on end as shown. Be sure folding side of
hinge faces pad as shown. DO NOT insert other short tube at this time.
Step 3
Turn up long tube so that its end points down. Insert end of long tube into
opening on end of short tube as shown. DO NOT slide short tube up around the
bend Short tube side. of long tube until you have finished next step. Make
sure fabric does not get caught in opening when inserting long tube into short
tube.
Step 4
Repeat step 3 on other end of short tube, then slide short tube ends up onto
long tubes. TO AVOID TEARING FABRIC, slide the short end up before proceeding
with step 5.
Step 5
Now repeat steps 2, 3 and 4 on how to install the short tube on the other end
of the changing table. If the short tubes have been inserted correctly, the
changing table should be able to FOLD UP in the center as shown. If you cannot
fold the
tubes up in the center, review steps 2, 3, and 4.
Step 6
Place pad in changing table with vinyl side up. Pull belt straps through holes
in center of pad.
Step 7
Insert VELCRO® straps into the four slots at the corners of changing table and
attach to VELCRO® on underside of changing table. This will prevent pad from
moving.
Step 8
Place changing table on Pack ‘N Play as shown. Make sure tubes are placed
securely over the sides of the Pack ‘N Play®. Check that the changing table is
properly supported by the Pack ‘N Play® by pushing firmly down into center of
changing table.
To Fold Changing Table
Step 1
Pull up on waist belt straps to fold.
Step 2
Ends of long tubes must point up when folded as shown.
Step 3
To carry or store your changing table with your folded Pack ‘N Play, see “To
Cover Your Pack ‘N Play” section In these instructions.
To Use Accessory Bag (on certain models)
Snap accessory bag onto end of Pack ‘N Play with four snaps as shown.
To Fold Your Pack ‘N Play”
Step 1
Release the two VELCRO” straps under the Pack ‘N Play.
Step 2
IMPORTANT: Raise center halfway BEFORE unlocking rails. Grasp center loop
as shown and pull up approximately halfway to the top rails.
Step 3
The top rail has a center piece with two tubes hidden under the fabric. The
button on the bottom of the center piece releases the two tubes when it is
pushed up.
Püsh UP button under fabric
To fold the top rail:
- Lift up slightly on the top rail.
- Push up on the button located under the symbol to release the two tubes.
- Push down.
- Il top rails do not unlatch, lift the center of the floor higher.
- Both tubes must be released for the top rail to fold.
Step 4
Pull center up all the way.
Step 5
Gather your unit together. Do not force. If unit will not fold, look for a
partially latched top rail. Squeeze the latch button to release the rail.
Step 6
Find the bottom corner belt loop(only one). This loop is for holding unit and
mattress together while carrying.
Step 7
Wrap the mattress around your unit. Fasten together the VELCRO® straps,
attaching the bottom strap to the bottom corner belt loop.
To Cover Your Pack ‘N Play”
Step 1
Pull cover over your unit. Be sure the carrying handle attached to the Pack ‘N
Play mattress is exposed. Certain models have a second handle on the carrying
bag.
Step 2
Zip together. On changing table models, turn unit upside down so that feet
point up. Pull the cover over your unit. Turn unit over. Before pulling bag
up, insert folded changing table into the side oppo- site the handle as shown.
Pull bag up to cover end. Zip together.
Replacement Parts
Instructions for ordering Pack ‘N Play” parts: Complete form below. Your Pack ‘N Play model number MUST be included on the form to ensure proper replacement parts. Your model number can be found on a label on the center of the bottom of the unit. Payment must accompany your order.
Parts List: Price
- awesS ……….. $19.00
- Carry ba…………………13.00
- Long tube* ………… $ 9.00
- Short tube* ……. .$ 7.00
- Changing pad*……… …$10.00
- Changing table*…….. 15.00
- Accessory bag* ……… 7.00
- Fied sheet. $13.00 $10.00
IF YOU NEED HELP
If you have any questions or if you need any part not listed, please call
toll-free: 1-800-345-4109 or visit our
Internet website, www.gracobaby.com.
Return the form below with payment to: GRACO CHILDREN’S PRODUCTS INC. CUSTOMER
SERVICE DEPARTMENT P.O. BOX 100, MAIN STREET ELVERSON, PA 19520
Model Number (Must be filled in)
- Mattress
- Carry bag
- Long tube
- Short tube
- Changing pad
- Changing table
- Accessory bag
- Toy bag
- Fitted sheet
SHIP TO: Name
Address City, State, Zip
Telephone Check enclosed (payable to Graco Children’s I
Products Inc.)
- Charge to credit card:
- Visa
- MasterCard
- Discover
Total: Shipping
& handling: 6% sales tax
(PA only): Total amount due: $5.00
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>