RAYCON RAPSTA100 Magic Charging Base User Manual
- June 17, 2024
- Raycon
Table of Contents
MAGIC CHARGING BASE
QUICK START GUIDE
PRODUCT DETAILS
CHARGING YOUR DEVICE
INSTRUCTIONS
- Plug in the Type-C cable and turn on the power.
- Stand the bracket up and place the device supporting Qi standard in the center of the charging area to start charging.
- This product has an indicator light touch switch, the user can turn the indicator light on or off.
ATTENTION
- Please use a qualified power adapter more than 18W, otherwise it may cause unstable charging.
- Do not put metal debris or magnetic card on the product, it may cause damage to the product or abnormal charging.
- Please use the device as it is designed for and kindly follow the safety instructions, or it would be your own responsibility.
| LED Indicator | State |
|---|---|
| Blue & green light turns off after 2s | Power connected |
| Blue light | Stand by |
| Green light | Charging |
| Blue light flashing | Metal object detected or abnormal charging |
PRODUCT SPECIFICATIONS
Model: RAPSTAIOO
Product size: 15085117mm
Input: 9V/2V 12V/1.5A
Phone Output: 5W/7.5W/1OW/15W (only for phone)
Earphone Output: 3W (max)
Apple iWatch Output: 3W (max)
FCC ID: 2AZOV-RAPSTAIOO
IC: 27185-RAPSTAIOO
SAFETY INSTRUCTIONS
- Do not pull the power supply hard, to avoid the power cord break or fall off.
- Do not disassemble the product or put it into fire or water to avoid short circuit and leakage.
- Do not use the product in severe high temperature, humidity or corrosive environment, to avoid damage to the circuit and leakage phenomenon.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>