BTF-LIGHTING LET634 RGB LED Controller Strip Light Instruction Manual
- May 15, 2024
- BTF-LIGHTING
Table of Contents
BTF-LIGHTING LET634 RGB LED Controller Strip Light Instruction Manual
Description of switch function
- Power on off-Press and hold the power button.
- Change the mode: Short press the cycle button.(Multiple mode options: Static Red/Static Green/Static Blue/Static White/Multicolour Change/Multicolour Flash/Multicolour Breathing/White Breathing/Red Breathing/Green Breathing/Blue Breathing)
- Adjust the flashing speed: Short press the power button.
- Adjust the brightness Press and hold the cycle button and short press the power button meanwhile.
Remote control instructions
NOTE
- During use, if the switch can work normally, but the remote control cannot, you need to perform the code matching operation.
- if the light is interfered by other remote controls or cannot be controlled remotely. Please power off and then power on again before performing code matching. How to perform code matching operation: Press and hold the start button on the remote control for 3 seconds within 7seconds of turning on the power, the light strip flashes 3 times with white light, indicating that the code (remote control) is matched.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. This equipment has
been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna. -Increase the separation between
the equipment and receiver. -Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected. -Consult the dealer or
an experienced radio/TV technician for help. FCC Caution: Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. This transmitter
must not be co-located or operating in conjunction with any other antenna or
transmitter.