Metallophone PMC002 Outdoor Musical Instrument Instruction Manual

Table of Contents

Metallophone-PMC002-Outdoor-Musical-Instrument-PRODCUT

Installation Steps

STEP 1: Using eight (8) M8 set screws, connect the Glockenspiel top to the post.
STEP 2: Attach mallets to the post using the V-bracket supplied and two (2) M6 set screws for each bracket.
STEP 3: Drill four (4) holes into the concrete 1/2 inch deeper than the anchor will penetrate. Ensure minimum embedment requirements are met and clean out the holes.
STEP 4: Hammer the bottom of the wedge anchor into the concrete, ensuring a tight fit.
STEP 5: Use four (4) lock nuts and four (4) washers to tighten the nuts into the previously hammered anchors.

STEP: 1 Using eight (8) M8 set screws connect the Glockenspiel top to the post.
STEP: 2 Attach mallets to post using V-bracket supplied and two (2) M6 set screws for each bracket.
STEP: 3 Drill four (4) holes into the concrete 1/2 inch deeper than the anchor will penetrate. Make sure that the minimum embedment requirements are met. Clean out the holes.
STEP: 4 Hammer the bottom of the wedge anchor into the concrete. Make sure this is a tight fit.
STEP: 5 Using four (4) lock nuts and four (4) washers, tighten the nuts into the previously hammered in anchors.

Created By: Kelly D.
Date Modified: 12/01/2020

Frequently Asked Questions

Q: Do I need any special tools for the installation?
- A: For the installation process, you will need a drill, hammer, set screws, lock nuts, washers, and mallets as provided in the kit.
Q: What should I do if the anchor does not fit tightly into the concrete?
- A: If the anchor does not fit tightly, ensure that the hole is deep enough and clean out any debris before attempting to hammer it in again.
Q: Can the Metallophone Installation Kit be used indoors and outdoors?
- A: Yes, this kit is suitable for both indoor and outdoor use. However, ensure proper anchoring for stability in outdoor environments.

Read User Manual Online (PDF format)