SHARP FU-NC01 Air Purifier Instruction Manual

SHARP FU-NC01 Air Purifier

The number in this technology mark indicates an approximate number of ions supplied into air of 1 cm3, which is measured around the center of a room applicable floor area (at 1.2 m height above the floor) when the product is placed on the floor and is operating with MAX mode.

• Thank you for purchasing this SHARP Air Purifier.
• Please read this manual carefully before using the product.
• This manual should be kept in a safe place for handy reference.

Please read before operating your new Air Purifier

• The air purifier draws in room air through the Air Inlet, circulates it through a Pre-Filter, a Two in one dust collection and deodorizing Filter inside the product, and then discharges it through the Air Outlet. The Two in one dust collection and deodorizing Filter can remove dust particles and absorb odors as they pass through the filter.
• Some odors absorbed by the filters will break down over time, causing additional odors. Depending on usage conditions, and especially if the product is used in environments significantly more severe than a normal household, these odors may become noticeable sooner than expected. If these odors persist, replace the filters.

NOTE

• The air purifier is designed to remove air-suspended dust and the odors. The air purifier is not designed to remove harmful gases such as carbon monoxide contained in cigarette smoke.
• The air purifier may not completely remove an odor if the source of the odor is still present.

IMPORTANT SAFETY INSTRUCTIONS

Always follow basic safety precautions when using electrical appliances, including the following:
WARNING – Always observe the following to reduce the risk of electrical shock, fire, or injury:

• Read all instructions before using the product.
• Use only a 220 – 240 volt outlet.
• Use only the AC adapter of the product.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure they do not play with the appliance.
•  If the power cord is damaged, it must be replaced by the manufacturer, its service agent, a Sharp authorized Service Center or similarly qualified persons in order to avoid a hazard. Contact the nearest Service Center for any problems, adjustments, or repairs.
• Do not repair or disassemble the product yourself.
• Be sure to remove the AC adapter before performing maintenance, when removing and attaching and replacing the filter and when not using for a long time. Failure to do so can cause a short circuit resulting in electrical shock or fire.
• Do not use the product if the power cord or AC adapter is damaged or if the connection to the wall outlet is loose.
• Periodically remove dust from the AC adapter.
• Do not insert fingers or foreign objects into the Air Inlet or Air Outlet.
• When removing the AC adapter, always hold the AC adapter and never pull on the cord. Failure to do so can cause a short circuit resulting in electrical shock or fire.
• Be careful not to damage the power cord. Failure to do so can cause electric shock, heat generation, or fire.
• Do not remove the AC adapter when your hands are wet.
• Do not use this product near gas appliances or fireplaces. When the product is operated with gas appliances in same room, Ventilate a room periodically, otherwise it may cause Carbon monoxide poisoning.
• Do not operate the product in rooms where aerosol insecticides are present. Do not operate the product in rooms where there is oily residue, incense, sparks from lit cigarettes, or chemical fumes in the air.
• Keep the product away from water. Do not operate the product in places where it may get wet, such as a bathroom.
• Do not expose the product to water. Doing so can cause a short circuit or electrical shock.
• Be cautious when cleaning the product. Strong corrosive cleansers can damage the exterior.

NOTE – What to do if the product interferes with radio or TV reception
If the air purifier interferes with radio or television reception, try one or more of the following measures:

• Adjust or reposition the receiving antenna.
• Increase the distance between the product and the radio or TV.
• Connect the equipment into an outlet on a circuit different from that of the radio or TV receiver.
• Consult the dealer or a qualified radio or TV technician.

CAUTIONS CONCERNING OPERATION

• Do not block the Air Inlet or Air Outlet.
• Do not place the product near or on hot objects, such as stoves or heaters, or where it may come into contact with steam.
• Always operate the product in an upright position.
• Do not move the product when it is in operation.
• If the product is on easily damaged flooring, an uneven surface, or thick-piled carpet, lift it up when moving.
•  Do not operate the product without the filters properly installed.
• Do not wash and reuse the Two in one dust collection and deodorizing Filter. Doing so will not improve filter performance and can also cause electric shock or operating malfunctions.
• Clean the exterior with a soft cloth only. Do not use volatile fluids or detergents. The product surface may be damaged or cracked with Benzine paint thinner, alcohol or polishing powder.
• Do not scrub the Pre-Filter hard during its maintenance.
• Do not use the AC adapter for other products.
• Do not get or lean on the product.

INSTALLATION GUIDELINES

• Avoid locations where furniture, fabrics, or other objects can come in contact with the product and interfere with the Air Inlet and Air Outlet.
• Avoid locations where the product is exposed to condensation or drastic changes in temperature. Appropriate room temperature is between 0 – 35 ºC.
• Place the product on a level and stable surface with sufficient air circulation. When placed on heavy carpet, the product may vibrate slightly.
• Avoid locations with grease, oil smoke, alcohol, hypochlorous acid, or chemicals in the air. Doing so can cause the product exterior to crack.
• The surrounding walls and floor of the product may become dirty over time. When using the product for an extended period of time at the same location, periodically clean the walls and floor adjacent to it.
• Do not use fluororesin or silicone-containing products (cosmetics, hair care products, etc.,) near the product. The fluororesin or silicone could get stuck inside the product, preventing it from producing Plasmacluster ions.

FILTER GUIDELINES
Follow the instructions in this manual for proper filter care and maintenance.

PART NAMES

NOTE
When using for the first time, please remove the plastic bag from the Two in one dust collection and deodorizing Filter.(Page 6)

1. Operation Panel
2. Night Light Power Lamp (Blue).
3. Air Outlet
4. Air Inlet
5. Two in one dust collection and deodorizing Filter
6. Pre-Filter country.
7. Bottom Cover
8. Power Cord
9. Power Lamp (Blue)
   • The lamp lights up while the AC adapter is connected to the outlet.
10. AC Adapter
    • Shape of AC adapter depends on
11. AC Adapter Terminal

OPERATION PANEL

1. Power ON/OFF and Mode Button
2. Night Light Button
3. Plasmacluster Ion Lamp (Blue)
4. Mode Lamps (White)

POWER ON/OFF AND SETTING MODE

NOTE
In LOW mode, the lamps on the Operation Panel lights up dimly.

NIGHT LIGHT ON/OFF

PLASMACLUSTER ION ON/OFF

NOTE
Plasmacluster ion will become always ON when after disconnecting and connecting the AC adapter again.

FILTER INSTALLATION

1. Turn the product upside down.

2. Remove the Bottom Cover.

3. Remove the Pre-Filter ( 1 ) and the Two in one dust collection and deodorizing Filter ( 2 ).

4. Remove the Plastic Bag.

5. Attach the Two in one dust collection and deodorizing

6. Attach the Pre-Filter.

7. Attach the Bottom Cover

CARE AND MAINTENANCE

MAIN BODY

When it gets dirty
Wipe with a dry, soft cloth.

AIR INLET / PRE-FILTER

Once a month
Remove the dust gently with a cleaning tool such as a vacuum cleaner.

NOTE About Pre-Filter

• Do not apply excessive pressure when scrubbing the Pre-Filter.
• How to clean hard to remove dirt.
  1. Add a small amount of kitchen detergent to water and soak for about 10 minutes.
  2. Rinse off the kitchen detergent with clean water.
  3. Completely dry the filter in a well ventilated area.

Two in one dust collection and deodorizing Filter

Whenever dust accumulates, or when odor emanates from the air outlet.

Remove the dust on the filter.

Clean only the tagged surface. Do not  clean up the opposite surface. The filter  is fragile, so be careful not to give too  much pressure.

NOTE

• Do not wash the filter. Do not expose to sunlight. (Otherwise these filter may lose efficacy.)
• Some odors absorbed by the filter will break down over time, causing additional odors. Depending on usage conditions, and especially if the product is used in environments significantly more severe than a normal household, these odors may become noticeable sooner than expected. Replace the filter in those cases or if dust is unable to be removed after maintenance.

FILTER REPLACEMENT

LIFE OF FILTER

• Filter life varies depending on the room environment, usage conditions, and location of the product.

• Lifespan of the Two in one dust collection and deodorizing Filter and replacement suggestions are based on purifying a room in which 5 cigarettes are smoked per day and the product’s dust collection and deodorizing performance has declined to half the level of a new filter. We recommend replacing the filter more frequently if the product is used in conditions significantly more severe
  (PM2.5 etc.,) than a normal household.

  • The life of the Two in one dust collection and deodorizing Filter is about 1 year after opening.

REPLACEMENT FILTER MODEL

• Consult your dealer when purchasing a replacement filter.
• Two in one dust collection and deodorizing Filter (1 unit) FZ-N15SFE
• Dispose of used filters according to local laws and regulations. material:

TROUBLESHOOTING

Before calling for service, please review the Troubleshooting list below, since the problem may not be the product malfunction.

• It doesn’t operate.

  • Check if the AC adapter is correctly connected to the product and the outlet.
    (It may take some time until the operation starts when after connecting the AC adapter.)

• Odor and smoke persists.

  • Is the filter still in the plastic bag? Take out the filter.
  • Has the wind from the Air Outlet been weakened?
    In that case, clean the Bottom Cover, the Pre-Filter and the Two in one dust collection and deodorizing Filter.

• Air discharged from the product has an odor.

  • Check to see if the filters are extremely dirty.
  • Clean or replace the filters.

• Smell from a new product and/or filter.

  • Immediately after removing the plastic bag, a slight odor may occur. This odor is not harmful for filter performance or human exposure.

• The Plasmacluster Ion Lamp is turned off.

  • When the Plasmacluster Ion is set to “OFF”, the Lamp automatically turns off. If you do not want the light to be off, set the Plasmacluster Ion to “ON” setting. (Page 5)

• The LOW mode Lamp is flashing.

  • Unplug the product, wait one minute, and then plug the product in again.
    If the flashing repeats periodically, please contact the customer service.

SPECIFICATIONS

Rated Power (W)

(Value when the Night Light is off.)

| 20

(20)

| 8.6

(8.1)

| 3.0

(2.5)

Noise Level (dBA) 1| 48| 34| 22
Standby power (W)| Approx. 0.6
Recommended Room Size (m2) 2| ~ 10
High density Plasmacluster ion recommended room size (m2) *3| ~ 10
Filter Type| Two in one dust collection and deodorizing
Cord Length (m)| Approx. 1.8
Dimensions (mm)| 190 (Φ) × 330 (H)
Weight (kg)| Approx. 2.0

1. Noise level is measured based on the JEM1467 standard of the Japan Electrical Manufactures’ Association.
2. The recommended room size is appropriate for operating the product of maximum fan speed.
   • The recommended room size is an area in which a given amount of dust particles can be removed in 30 minutes (according to JEM1467).
3. Room size in which approximately 7000 ions per cubic centimeter can be measured in the center of the room, at a height of approximately 1.2 meters from the floor, when the product is placed on the floor and is running at MAX mode.

Standby Power

• When the product’s AC adapter is inserted in a wall outlet it consumes standby power in order to operate electrical circuits.
• To conserve energy, unplug the AC adapter when the product is not in use.

References

• SHARP ผลิตภัณฑ์เครื่องใช้ไฟฟ้า | Sharp Thai Co., LTD

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>