antunes GST-2H Horizontal Toaster Instruction Manual

Wendy’s
GST-2H Horizontal Toaster
Manufacturing Numbers:
9210888

IMPORTANT
A.J. Antunes & Co. reserves the right to change specifications and product design without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
IMPORTANT
Keep these instructions for future reference. If the unit changes ownership, be sure this manual accompanies the equipment.

WARRANTY INFORMATION

Please read the full text of the Limited Warranty in this manual.
If the unit arrives damaged, contact the carrier immediately and file a damage claim with them. Save all packing materials when filing a claim. Freight damage claims are the responsibility of the purchaser and are not covered under warranty.
The warranty does not extend to:

• Damages caused in shipment or damage as result of improper use.
• Installation of electrical service.
• Normal maintenance as outlined in this manual.
• Malfunction resulting from improper maintenance.
• Damage caused by abuse or careless handling.
• Damage from moisture into electrical components.
• Damage from tampering with, removal of, or changing any preset control or safety device.

SERVICE/TECHNICAL ASSISTANCE
If you experience any problems with the installation or operation of your unit, contact your local Roundup Authorized Service Agency.
Fill in the information below and have it handy when calling your Authorized Service Agency for assistance.
The serial number is on the specification plate located on the rear of the unit.
Purchased From
Date of Purchase
Model Number
Serial Number
Manufacturing Number
Use only genuine Roundup replacement parts in this unit. Use of replacement parts other than those supplied by the manufacturer will void the warranty. Your Authorized Service Agency has been factory  trained and has a complete supply of parts for this unit.
Visit www.ajantunes.com or contact the factory at 1-630-784-1000 to locate your nearest Authorized Service Agency. Refer to the service agency directory packaged with your manual and fill in the information below.
Authorized Service Agency

IMPORTANT SAFETY INFORMATION

Use the following guidelines for safe operation of the unit.

• Read all instructions before using equipment.

• For your safety, the equipment is furnished with a properly grounded cord connector. Do not attempt to defeat the grounded connector.

• Install or locate the equipment only for its intended use as described in this manual. Do not use corrosive chemicals in this equipment.

• Do not operate this equipment if it has a damaged cord or plug, if it is not working properly, or if it has been damaged or dropped.

• This equipment should be serviced by qualified personnel only. Contact your nearest Authorized Service Agency for adjustment or repair.

• Do not block or cover any openings on the unit. y Do not immerse cord or plug in water.

• Keep cord away from heated surfaces.

• Do not allow cord to hang over edge of table or counter.

• Turn the power off, unplug the power cord, and allow unit to cool down before performing any service or maintenance on the unit.
  NOTE: Turning off the power switch does NOT turn off all power to the unit.

• The procedures in this manual may include the use of chemical products. These chemical products will be highlighted with bold face letters followed by the abbreviated HCS (Hazard Communication Standard). See Hazard Communication Standard manual for the appropriated Material Safety Data Sheets (MSDS).

• The equipment should be grounded according to local electrical codes to prevent the possibility of electrical shock.
  It requires a grounded receptacle with separate electrical lines, protected by fuses or circuit breaker of the proper rating.

• All electrical connections must be in accordance with local electrical codes and any other applicable codes.

• Do not clean this appliance with a water jet.

SPECIFICATIONS

Model &
Mfg. No.| Width
(A)| Depth
(B)| Height
(C)|
---|---|---|---|---
GST-2H
9210888| 22″ (559 mm)| 21″ (533 mm)| 17″ (432 mm)|
Model &
Mfg. No.| Volts| Watts| Hertz| Plug
Description
GST-2H
9210888| 20| 2000| 60| NEMA 6-20P
20 Amp, 250 Volt
Right Angle

INSTALLATION

1. Remove unit and all packing materials from shipping carton.

2. Open the Accessories Box. It should contain the following:
   a. Bun Chute
   b. Bun Feeder
   c. 1 Belt Set
   d. Owner’s Manual
   NOTE: If any parts are missing or dam aged, contact Antunes Technical Service IMMEDIATELY at 1-877-392-7854 or 1-630-7841000.

3. Open the side door (Figure 1) and remove all of the plastic ties securing the toaster mechanism.

4. Remove all packing materials and protective coverings from the unit.

5. Wipe the entire exterior of the toaster and the accessories mentioned above with a hot damp cloth. Allow to air dry
   NOTE: Do NOT use a dripping wet cloth. Wring out before use.

6. Attach the Bun Chute, Bun Feeder, and Butter Wheel assembly.

7. Make sure the Compression Knob is set to 3, the default setting. When placing the toaster into service,  pay attention to the following guidelines.
   The power cord is located at the bottom of the unit. The unit is designed to be placed on a table that will NOT pinch the power cord.
   Make sure the power switch is off and the unit is at room temperature before plugging in the power cord.
   Do not block or cover any openings on the unit.
   Do not immerse the power cord or plug in water.
   Keep the power cord away from heated surfaces.
   Do not allow the power cord to hang over edge of table or counter.

8. Place the unit on a sturdy, level table or other work surface.

9. Turn the power switch to off (if it is set to on).

10. Ensure the line voltage cor- responds to the stated voltage on the specification label and power cord warning tag.

11.  Plug the power cord into the appropriate power outlet. Refer to the specification plate for the proper voltage.

OPERATION

1. Press and release the Power button to turn the toaster on. Allow the toaster to warm up until USE appears in the display
2. Set the Compression Knobs to the desired setting. The recommended Compression Settings are: CROWN – #4 HEEL – #3
3. Insert product into the appropriate lane on the Bun Feeder according to Bun Feeder labels. Insert buns with the cut side facing down. 4. Finished product drops into the bun landing zone.

Light/Dark Adjustments
The light/dark value can be adjusted when the unit is displaying “USE”. To adjust the light/dark value, press the LIGHTER or DARKER button. The display will change to show the current light/dark value.
NOTE: The default light/dark value is d0.
Press the LIGHTER or DARKER buttons to change the light/dark value. The adjustment range is L1-L9 and d0-d9. L9 is the lightest, d0 is the middle, and d9 is the darkest setting. To save the light/dark value, press the PROGRAM button or wait 5 seconds until  he screen displays “USE”. NOTE: Adjusting the light/dark value does NOT change the temperature. It changes the speed of the conveyors. The light/dark value will reset to the default value of d0 when the unit is turned off.

DAILY CLEANING

1. Press and release the Power button to turn the toaster off. The toaster enters a 45 minute cool-down mode and automatically shuts down when complete.
   NOTE: Be sure to perform cleaning steps during cool-down mode.

2. Put on neoprene gloves and remove the Bun Feeder and Trivet.

3.  Clean the outside surfaces of the toaster with a paper towel sprayed with an approved multi-surface cleaner. Allow to air dry.

4. Wipe the Bun Feeder and Trivet  with a paper towel sprayed with an approved multi-surface cleaner. Allow to air dry.

5. Remove the Top Cover and set aside.
   NOTE: Replac e all Belts if any of the Belts are discolored, torn, or if any of the Belt Snaps are damaged.
   NOTE: The conveyors continue to turn during the cool-down period.

6. Inspect the top and bottom Belts. Replace all of the belts if any of them are torn, folded, discolored, missing snaps, or damaged in any way.

7. If the Belts are all in good condition, spray a clean, sanitized towel with an approved sanitizer. Press and hold both arrow buttons for 5 seconds. PUR appears on the display with a blinking cursor.
   This locks the belt speed in Purge mode for 5 minutes to assist in cleaning. Wipe the front and rearBelts clean. Allow to air dry. 8. Press any button to exit Purge mode.9. Clean the Top Cover with a paper
   towel sprayed with an approved multi surface Cleaner. Allow to air  dry.

8. Reinstall the Top Cover and then reinstall the Bun Feeder and Trivet.

9. Turn the toaster on and test the unit before returning it to operation. NOTE: These cleaning steps may need to be repeated to remove heavy carbon buildup.

REPLACEMENT PARTS

LIMITED WARRANTY

Equipment manufactured by Roundup Food Equipment Division of A.J. Antunes & Co. has been constructed of the finest materials available and manufactured to high quality standards.
These units are warranted to be free from electrical and mechanical  defects for a period of one (1) year from date of purchase under normal use and service, and when installed in accordance with manufacturer’s recommendations.
To insure continued operation of the units, follow the maintenance procedures outlined in the Owner’s Manual. During the first 12 months, electro-mechanical parts, non-overtime labor, and travel expenses up to 2 hours (100 miles/160 km), round trip from the  nearest Authorized Service Center are covered.

1. This warranty does not cover cost of installation, defects caused by improper storage or handling prior to placing of the Equipment. This warranty does not cover overtime charges or work done by unauthorized service agencies or personnel.
   This warranty does not cover normal maintenance, calibration, or regular adjustments as specified in operating and maintenance instructions of this manual, and/or labor involved in moving adjacent objects to gain access to the equipment.
   This warranty does not cover consumable/wear items.
   This warranty does not cover damage to the Load Cell or Load Cell
   Assembly due to abuse, misuse, dropping of unit/shock loads or exceeding maximum weight capacity (4 lbs).
   This warranty does not cover water contamination problems such as foreign material in water lines or inside solenoid valves. It does not cover water pressure problems or failures resulting from improper/incorrect voltage supply. This warranty does not cover  Travel Time & Mileage in excess of 2 hours (100 miles/160 km) round trip from the nearest authorized service agency.

2. Roundup reserves the right to make changes in design or add any improvements on any product. The right is always reserved to modify equipment because of factors beyond our control and government regulations. Changes to update equipment do not  constitute a warranty charge.

3. If shipment is damaged in transit, the purchaser should make a claim directly upon the carrier. Careful inspection should be made of the shipment as soon as it arrives and visible damage should be noted upon the carrier’s receipt. Damage should be  eported to the carrier. This damage is not covered under this warranty.

4.   Warranty charges do not include freight or foreign, excise, municipal or other sales or use taxes. All such freight and taxes are the responsibility of the purchaser.

5. THIS WARRANTY IS EXCLUSIVE AND IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING ANY IMPLIED WARRANTY OR  MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, EACH OF WHICH IS HEREBY EXPRESSLY DISCLAIMED. THE REMEDIES DESCRIBED ABOVE ARE EXCLUSIVE AND IN NO EVENT SHALL ROUNDUP BE LIABLE FOR SPECIAL CONSEQUENTIAL ORINCIDENTAL DAMAGES FOR  THE BREACH OR DELAY IN  PERFORMANCE OF THIS WARRANTY.

A.J. Antunes & Co.
Headquarters/Manufacturing
Carol Stream, Illinois 60188 USA
Phone: 630-784-1000
Toll Free: 800-253-2991
Fax: 630-784-1650
Antunes Equipment
Manufacturing (Suzhou) Ltd.,
Suzhou, Jiangsu, China 215011
Phone: 86-512-6841-3637
Toll Free: 400-0-7878-22
Fax: 86-512-6841-3907
www.ajantunes.com

References

• Manual-Hub.com - Free PDF manuals!
• Antunes: High Quality Cooking Equipment & Water Treatment Solutions
• Manual-Hub.com – Free PDF manuals!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>