MTSIM 2023-11-22 Optional Quick Change Wall Mount Instruction Manual
- June 16, 2024
- MTSIM
Table of Contents
MTSIM 2023-11-22 Optional Quick Change Wall Mount
Product Information
Specifications
- Quick Change Wall Mount
- Model: MTSIM Joystick Quick Change
- Compatible with vertical 80x40mm profiles
- Assembly on table mount or profiles
- Universal Connector: Slot nut M8
- Bolt Dimensions: M8x35, M8x25
Parts Included
- 1x Profile Nut
- 1x Hex Key Set with Ball Head + Extension or Similar
- 1x Universal Connector (Slot nut M8)
- 1x Set with Counterpart (usually pre-assembled on profile 80)
- 1x Quick Change System (Pressure Plate)
- 2x Beam Support
- 1x Set of Screws and Bolts (sizes may vary)
Assembly Instructions
Table Mount Assembly
- Make sure the two beam supports are mounted at the same height.
- Place the quick change system (pressure plate) on the table mount.
- Attach the beam supports to the quick change system using the provided screws.
- Securely tighten all screws to ensure stability.
Profile Mount Assembly
- Choose a suitable vertical 80x40mm profile for mounting.
- Insert 4x slot nuts M4 into the profile at desired positions.
- Attach the quick change system (pressure plate) to the slot nuts using 4x M4x14 flat head screws.
- Securely tighten all screws to ensure stability.
Optional Wall Mount Assembly
- Choose a suitable wall for mounting and select appropriate screws to support the load.
- Note the orientation of the wall mount.
- Attach the beam supports to the wall mount using 4x M4x8 flat head screws.
- Securely tighten all screws to ensure stability.
GENERAL ASSEMBLY INFO AND HOW TO
PROFILE NUT
HEX KEY SET WITH BALL HEAD + EXTENSION OR SIMILAR REQUIRED
UNIVERSAL CONNECTOR
BOLT DIMENSIONS AND HOW TO MEASURE THEM [mm]
PARTS
PARTS FOR OPTIONAL WALL MONT
ASSEMBLY
On table mount for example. Can be mounted on every vertical 80x40mm profile. E.g. chair mounts, rail mounts, MTS Cockpit…
Make sure that the two beam supports are mounted at the same height.
OPTIONAL WALL MOUNT ASSEMBLY
WARNING NOTICES
CAUTION
Check before usage if all screws are tightened.
DANGER
Contains small parts not suitable for children under 3 years. Only
suitable for children over 12 years old and adults. All MTSIM products are
hand-assembled and quality-checked. The mount is designed for usage only with
a computer controller (f.e. joystick or throttle). We exclude liability if the
product is used for purposes other than intended. MTSIM shall be liable for
damage arising from causes other than the detriment to life, body, and health
only to the extent that such damage arises from wilful misconduct, gross
negligence, or the culpable violation of a fundamental contractual obligation
on the part of MTSIM or a vicarious agent (e.g. the delivery service) of
MTSIM. Any further liability for damages shall be excluded. If you have safety
concerns or questions regarding assembly, contact us at
[email protected] or visit
www.mtsim.com/en
FAQ
Can I use the wall mount on profiles?
Yes, the wall mount can be assembled on profiles using a 2x slot nuts M8 and 2x M8x16 flat head screws.
Do I need any additional parts for the optional wall mount assembly?
No, all necessary parts are included in the quick-change system delivery.
What is the maximum weight capacity of the wall mount?
The maximum weight capacity is not specified in the user manual. Please contact MTSIM for further information.