MTSIM MULTIPURPOSE-UFC Carrier for Table Mount Instruction Manual
- June 12, 2024
- MTSIM
Table of Contents
MTSIM MULTIPURPOSE-UFC Carrier for Table Mount
Product Information
The Multipurpose-UFC Carrier for Table Mount is a versatile carrier designed for mounting various devices on a table. It comes with a detailed instruction manual to guide you through the assembly process. The carrier includes different parts such as profile nuts, bolts, hex keys, stop nuts, locknuts, and slot nuts.
Assembly Example
The assembly example provided in the manual demonstrates how to set up the
carrier for the table mount.
Bolt Dimensions and Measurements
The manual provides bolt dimensions in millimeters (mm) and explains how to
measure them accurately.
Parts Included
- 1x Multipurpose-UFC carrier for table mount
- 2x M5 double slot nuts
- 2x M5x12 flat head black bolts
- 2x M8x14 bolts
- 2x M8 stop nuts
- 4x M8 locknuts (selbstsichernd)
- 1x Hex key set with ball head + extension (or similar)
- 1x Open-end wrench (13mm)
- 1x Original part (M6x20) included with the device
Product Usage Instructions
- Start by identifying all the parts mentioned above.
- Using the hex key set or a similar tool, assemble the carrier according to the provided assembly example.
- Tighten the bolts securely using the appropriate tools. For the desired viewing angle, adjust and tighten the screws accordingly.
- If necessary, use the open-end wrench (13mm) to further secure the assembly.
- For additional settings after installation, follow the same procedure.
- Use the double slot nuts (2x M5) and flathead black bolts (2x M5x12) to attach devices to the carrier securely.
- Ensure the original part (M6x20) that comes with the device is properly installed.
- Refer to the warning notices in the manual for important safety information.
GENERAL ASSEMBLY INFO AND HOW TO PROFILE NUT
HEX KEY SET WITH BALL HEAD + EXTENSION OR SIMILAR REQUIRED
BOLT DIMENSIONS AND HOW TO MEASURE THEM [mm]
PARTS
[dimensions in mm / different scales] No extra or spare parts listed!
ASSEMBLY
WARNING NOTICES
CAUTION! Do not clamp your fingers while attaching the multipurpose ufc
holder.
CAUTION! Check before usage if all screws are tightened.
CAUTION! Check before usage that the multipurpose ufc holder is screwed
on tight after making adjustments.
DANGER : Contains small parts not suitable for children under 3 years.
Only suitable for children over 12 years and adults. All MTSIM products are hand-assembled and quality checked. The mount is designed for usage only with a computer controller (e.g. joystick or throttle). We exclude liability if the product is used for purposes other than intended. MTSIM shall be liable for damage arising from causes other than the detriment to life, body, and health only to the extent that such damage arises from wilful misconduct, gross negligence, or the culpable violation of a fundamental contractual obligation on the part of MTSIM or a vicarious agent (e.g. the delivery service) of MTSIM. Any further liability for damages shall be excluded. If you have safety concerns or questions regarding assembly, contact us at info@mtsim.com or visit www.mtsim.com/en/
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>