1010music Nanobox Battery Case User Guide
- June 16, 2024
- 1010music
Table of Contents
1010music Nanobox Battery Case
Power Button
Lithium Ion Polymer Battery
3.7V, 2000mAh, 7.4Wh
Push once to turn on, push twice to turn off. Battery will not power off when plugged in.
Lights
Use the nanobox USB C power cord to charge the battery case. You may charge it while you are using the nanobox.
USB C Port
Use the nanobox USB C power cord to charge the battery case. You may charge it while you are using the nanobox.
Note
The nanobox will power down and then restart when you unplug the charging cable. Save your changes before disconnecting from external power.
nanobox Power saving Firmware Updates
Check the forum for nanobox firmware updates with power saving features:
forum.1010music.com.
Lower the screen brightness to improve battery life.
Important Safety Information
Disposal
Recycle or dispose of in accordance with government, state & local regulations for lithium ion polymer batteries. Do not incinerate.
Caution
Risk of fire and burns. Do not open, crush, disassemble, overcharge, short
circuit, or dispose of in fire. Do not heat above 65° C/149° F. Keep away from
water. Do not use if damaged.
Do not place in checked bags when traveling by airplane. Must be transported
in carry on luggage.
Designed for use only with the 1010music nanobox line of products.
To Connect The Nanobox To The Power Cable
Connect the USB cable by pushing it against the side of the case with the
nanobox level with the case. To avoid damaging the cable, do not push it in
when the nanobox is at an angle to the case.
To Disconnect The Nanobox From The Power Cable
First, gently pry the power cable from the nanobox, then pull the nanobox from
the case.
Do not pull the nanobox out an angle.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>