Health Household NA-H1223C Heating Pad User Manual

Heating Pad
USER MANUAL
NA-H1223C

NA-H1223C Heating Pad

IMPORTANT: PLEASE STORE THESE INSTRUCTIONS FOR FUTURE REFERENCE!
READ THE INSTRUCTIONS CAREFULLY BEFORE USING THE PRODUCT, ESPECIALLY THE SAFETY INSTRUCTIONS.
SHOULD YOU GIVE THIS UNIT TO ANOTHER PERSON, IT IS VITAL THAT YOU ALSO PASS ALONG THESE IN STRUCTIONS.
ICONS
THIS GUIDE CONTAINS IMPORTANT INFORMATION ABOUT USING, OPERATING,AND STORING THE PRODUCT.PLEASE READ IT THROUGH AND NOTE THAT NON-OBSERVANCE OF THESE INSTRUCTIONS CAN RESULT IN SERIOUS INJURY OR DAMAGE TO THE DEVICE.
WARNING
THESE WARNING NOTES MUST BE OBSERVED TO PREVENT ANY INJURY TO THE USER
NOTE
THESE NOTES GIVE YOU USEFUL ADDITIONAL INFORMATION ON THE INSTALLATION OR OPERATION.
CAUTION
THESE NOTES MUST BE OBSERVED TO PREVENT ANY DAMAGE TO THE DEVICE.

| LOT NUMBER
---|---
| MANUFACTURER
| DO NOT PUNCTURE THE HEATING PAD.
| DO NOT USE THE HEATING PAD WHEN IT IS FOLDED.
| ONLY USE THE HEATING PAD INDOORS.
| THE HEATING PAD CAN BE WASHED IN GENTLE CYCLE AND BY HANDS AT MAX 40°C/104°F .
****| DO NOT BLEACH!
| DONOT DRY THE HEATING PAD IN A TUMBLE DRIER.
| DO NOTIRON THE HEATING PAD.
| DO NOT DRY CLEAN!

SAFETY INFORMATION

1. THE APPLIANCE IS ONLY TO BE OPERATED THROUGH ITS CONTROL.
2. PLEASE CHECK THE HEATING PAD BEFORE EACH USE. DO NOT USE IF YOU NOTICE WEAR,DAMAGE,OR SIGNS OF IMPROPER USE ON THE CONTROL,CABLE, OR HEATING PAD.RETURN THE DAMAGED PRODUCT TO THE SUPPLIER.
3. BEFORE CONNECTING THE PRODUCT TO A POWER SUPPLY, PLEASE MAKE SURE THAT THE SUPPLY VOLTAGE STATED ON THE RATING PLATE IS WITHIN THE ALLOWED POWER RANGE.
4. DO NOT FOLD OR CREASE THE HEATING PAD DURING USE.
5. DO NOT PIERCE THE PAD WITH OR ATTACH SAFETY PINS OR OTHER SPIKY OR SHARP OBJECTS TO THE PAD.
6. DO NOT USE THE HEATING PAD ON CHIL DREN OR PERSONS WHO ARE DISABLED, ASLEEP,OR INSENSITIVE TO HEAT.
7. THE UNIT IS DESIGNED FOR HOME USE ONLY.
8. DO NOT KEEP THE HEATING PAD SWITCHED ON AFTER YOU FALL ASLEEP.
9. PROLONGED USE OF THE HEATING PAD AT A HIGH SETTING COULD LEAD TO SKIN BURNS.
10. DO NOT COVER THE HEATING PAD WITH ANY OTHER CUSHIONS.THE CONTROL SHOULD NOT BE COVERED OR PLACED ON OR BELOW THE HEATING PAD WHILE IT ISIN OPERATION.
11. D0 NOT SIT ON THE HEATING PAD, ONLY PLACE THE PAD ON THE PART OF YOUR BODY YOU WANT TO TREAT.
12. NEVER TOUCH A HEATING PAD THAT HAS FALLEN INTO WATER.UNPLUG THE UNIT FROM POWER IMMEDIATELY.
13. KEEP THE POWER CORD AWAY FROM HOT SURFACES.
14. NEVER CAPRY,PULL,OR TURN THE HEATING PAD BY THE CORD AND DO NOT LET THE CORD GET TANGLED.
15. ONLY USE IT IN DRY ENVIRONMENTS NOTIN THE BATHROOM OR SIMILAR ENVIRONMENTS).
16. DO NOT EXPOSE THE CONTROL AND CABLE TO MOISTURE OR HUMID.
17. IF A FAULT OCCURS,DO NOT ATTEMPT TO REPAIR THE UNIT BY YOURSELF. REPAIRS MUST ONLY BE CARRIED OUT BY AN AUTHORIZED TECHNICIAN OR OTHER SUITABLY QUALIFIED PERSONNEL.
18. IF THE CABLE IS DAMAGED,IT MUST BE REPLACED BY ITS MANUFACTURER, ITS SERVICE AGENT OR SIMILARLY QUALIFIED PERSONS IN ORDER TO AVOID A HAZARD.WHEN STORINNG THE HEATING PAD,ALLOW IT COOL DOWN BEFORE FOLDING.

WARNING

1. CONSULT YOUR DOCTOR BEFORE USING THE HEATING PAD IN CASE YOU HAVE ANY HEALTH CONCERNS.
2. DO NOT USE THE HEATING PAD ON PARTS OF THE BODY THAT ARE SWOLLEN, INJURED, OR INFLAMED.
3. IF YOU EXPERIENCE PERSISTENT PAINS, IT CAN BE SYMPTOMS OF SERIOUS ILLNESS, STOP USING IMMEDIATELY AND CONSULT YOUR DOCTOR.
4. IF YOU EXPERIENCE ANY PAIN OR DISCOMFORT WHILE USING THE UNIT, STOP USING IT IMMEDIATELY,NOT INTENDED FOR MEDICAL USE IN HOSPITAL.

WARNING
PLEASE ENSURE THAT POLY BAG IS KEEP AWAY FROM CHILDREN!RISK OF SUFFOCATION!

1. DO NOT USE THE HEATING PAD WHEN IT IS TOTALLY WET.
2. DO NOT USE ON A HELPLESS PERSON, AN INFANT,OR A PERSON INSENSITIVE TO HEAT.
3. CHILDREN NOT TO USE THIS APPLIANCE DUE TO THEIR INABILITY TO REACT TO OVERHEATING
4. WHEN STORING THE APPLIANCE, ALLOW IT TO COOL DOWN BEFORE FOLDING.DO NOT CREASE THE PAD BY PLACING ITEMS ON TOP OF IT DURING STORAGE.
5. USE ONLY THE CONTROL MARKED ON THE RATING LABEL.

IMPORTANT SAFETY

INSTRUCTIONS DO NOT DESTROY DANGER – To reduce the risk of burns, electric shock and fire, this product must be used in accordance with the following instructions.

1. READ ALL INSTRUCTIONS.
2. D0 NOT USE WHILE SLEEPING.
3. DO NOT USE ON AN INFANT.
4. THIS PAD IS NOT TO BE USED ON OR BY AN INVALID, SLEEPING OR UNCONSCIOUS PERSON, OR A PERSON WITH POOR BLOOD CIRCULATION UNLESS CAREFULLY ATTENDED.
5. DO NOT USE ON AREAS OF INSENSITIVE SKIN.
6. BURNS CAN OCCUR REGARDLESS OF CONTROL SETTING,CHECK SKIN UNDER PAD FREQUENTLY.
7. DO NOT USE PINS OR OTHER METALLIC MEANS TO FASTEN THIS PAD IN PLACE.
8. DO NOT SIT ON OR CRUSH PAD – AVOID SHARP FOLDS.
9. NEVER PULL THIS PAD BY THE SUPPLY CORD.
10. D0 NOT USE THE CORD AS A HANDLE.
11. LOOP CORD LOOSELY WHEN STORING. TIGHT WRAPPING MAY DAMAGE CORD AND INTERNAL PARTS.
12. SAVE THESE INSTRUCTIONS.

Please read this User Guide thoroughly before use and retain it for future reference.

Package Contents

1x Heating Pad(NA-H1223C)
1x User Guide

Product Diagram

1. Temperature button –
2. Temperature button +
3. Timer button
4. Display screen area temperature display/ temperature position/set time
5. Power switch

Use Method

1. Insert the plug in the socket and one press the power button.Then the display lights up and the pad in Initial state automatically, which is auto-off at 3H and in lowest temperature position 100° .
2. Adjust Timing:In Initial state,press”Timer” button then the”timing”flashes. press the “Timer”again to change the timing in the order of”3H ~ 0.5H ~ 1H ~ 1.5H ~ 2H ~ 2.5H”. After turning to the proper timing mode.if no other operation,the displayed figure will flash for 3S then automatically in the mode you set.
3. Adjust Temperature Position:In Initial state, press the’+”/”-“button,the display lights up. Again press the “+”button,change the temperature position in the order of “100°F ~ 110°F ~ 120°F ~ 130% ~ 140°F ~ 150°F “.After turning to the proper temperature position,if no other operation, the displayed figure will flash for 3S ,then automatically heat to the temperature you set

  Attention
Do not spray or wet the connector of the control.

Specifications

The pad is clean and as dry as possible.

1. Be sure to disconnect the appliance from the mains by removing the plug from the power outlet and cooling it down for at least ten minutes before cleaning.
2. Use only a soft brush to clean the heating pad when dry.
3. DO NOT use strong detergents or hard brushes to clean the heating pad.
4. Gentle Machine Wash: Select Gentle Cycle for Wool, detach the control connector, and then wash at maximum of 40°C/104°F.
5. Untangle the cable from time to time.
6. When storing the appliance, allow it to cool down. Store the unit in a clean and dry place, lay out flat with nothing covering or resting on top of it.

Troubleshooting

A. Control Connector
B. Pad Connector
Note:
The connector of the controller and the pad must be interconnected before plugging the appliance to a power source,
IMPORTANT – This appliance has a polarized plug (one blade is wider than the other).
To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT attempt to rig this safety feature.

connected to the power source
2. If replacement is required, please contact professional technician.
The appliance does not heat up| Analysis by error code heat up| 1. Press +/- button to
2. Press +/-button to heat up
3. Refer to the solutions for below error codes
Not enough heat| 1. Heating level not adjusted 2.Ambient temperature
too low
3. Side temperature lower than that of the center| 1. Increase the heating level as needed
2. Increase the ambient temperature
3. Place the pad center to the location that requires more heat
Error code “Fl”| Component failure| If replacement is required, professional technician is required for maintenance.
Error code “F2”| Controller does not detect the pad| 1. Verify that it is fully connected
2. If replacement is required, professional technician is required for maintenance
3. Do not pull violently during use
4. Do not place the pad near heat sources or near pets
Error code “F3”| Frequency error| Make sure the voltage and frequency satisfy the requirements,
Error code “F4”| Chip faults| If replacement is required, professional technician is required for maintenance.
Error code “F5”| The hot wire is short-circuited due to folding| 1. Do not fold or twist during heating
2. If replacement is required, professional technician is required for maintenance.
Error code “F6”| Controller overheat| 1. Do not wrap it up when using
2. Do not use the controller near the heat source

Customer Service

We provide 30 Day-money-back and 1-year worry-free warranty serivce.If you have any questions,please contact us through Amazon’s ” Contact Seller”.we will be happy to serve you and guarantee a 100% satisfactory solution. Any questions? Feel free to contact us first.

FCC Compliance

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

MANUFACTURER
Ningbo Quanxiao Health Technology Co.,Ltd.
Adress: Trusteeship 3348,Room 112,building
10,No.21,Lane 689,Changxing Road,Jiang-
bei District, NINGBO, Zhejiang. MADE IN CHINA

Documents / Resources

| Health Household NA-H1223C Heating Pad [pdf] User Manual
NA-H1223C Heating Pad, NA-H1223C, Heating Pad, Pad
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>