Teddle TP1502 Baby Playpen Instruction Manual

Teddle TP1502 Baby Playpen Instruction Manual

Thank you for choosing one of our Teddle products! For customer support, please contact our email: info@teddle.nl.

SECTION 1: IMPORTANT SAFEGUARDS

WARNING: Assembly must be performed by an adult. To reduce the risk of serious injury, the following basic safety precautions should be followed:

READ AND KEEP ALL INSTRUCTIONS, SAFETY RULES AND WARNINGS BEFORE STARTING
Failure to follow any of the safety rules and instructions for safe use may create a risk of serious injury and void your warranty.

1. Read all instructions carefully. Save this manual for later.
2. Carefully read and follow all warnings and instructions.
3. Take your time and be careful when unpacking and setting up the playpen.
4. Assembly must be performed by an adult.
5. Always place the playpen on a flat, firm and stable surface.
6. The playpen is suitable for babies and children under 3 years of age up to a maximum weight of 15 kg.
7. Keep all parts, packaging materials and promotional stickers away from babies and children to avoid possible choking hazard.
8. Use requires close adult supervision. Prevent babies and children from climbing.
9. Do not use the playpen if any part is broken, torn or missing. Only use spare parts approved by the manufacturer.
10. All mounting elements must be checked regularly and tightened if necessary.
11. Avoid open fire and other strong heat sources such as electric heaters, gas fires, etc., near the playpen.
12. Clean the playpen regularly with a neutral detergent so that your child can play in a clean and hygienic environment.
13. If there are any extra parts left after installation, please recheck the installation steps.
14. CAUTION: Do not use more than one mat in the playpen – risk of suffocation.
15. Do not leave anything in the playpen and do not place the playpen near any other product that could pose a risk of suffocation or strangulation, such as cords, curtains, ropes, etc.
16. Do not use the playpen for purposes other than its intended use.

SECTION 2: PARTS

SECTION 3: ASSEMBLY

IMPORTANT: It is important to clean the playpen before first use or if it has not been used for a long time. Remove the stickers, the protective foil and/or the plastic from the playpen. See chapter 4 cleaning and maintenance for more information.

1. Lay the cloth flat and insert the 897mm and 747mm tubes alternately through the holes provided for this purpose.
   WARNING: Make sure the clips in the tubes are facing the corners.
   

2. Connect the tubes using the corner T-pieces with suction cups and the T-pieces with feet.
   Do this in the order shown in the illustration.
   IMPORTANT: Make sure the tubes with clips are clipped into the designated holes of the corner T-pieces.
   

3. Then insert the 620mm tubes upright as shown in the illustration.

4. Place the remaining T-pieces (without suction cup and feet) on top of the upright tubes.

5. Insert the 897mm and 747mm tubes alternately through the appropriate holes as described in step 1. IMPORTANT : Again, make sure that the clips in the tubes are directed towards the corners.

6. Connect the tubes in the same way as in step 2 and finally fold the protective flaps over the T-pieces and secure with Velcro.
   IMPORTANT: Make sure the tubes are clipped into the designated holes of the corner Pieces with clips.
   IMPORTANT: Make sure the T-pieces are covered with the protective flaps to avoid possible injury

7. The installation is completed.
   OPTIONAL: Place the supplied mat and balls in the playpen if desired.
   IMPORTANT : Do not place two mats in the playpen to avoid the risk of suffocation.

SECTION 4: CLEANING & MAINTENANCE

IMPORTANT : Clean the playpen regularly with a neutral detergent so that your child can play in a clean and hygienic environment.
The playpen should be cleaned with a neutral detergent, warm water, a damp cloth and then dried. Do not use chemical cleaning and do not use corrosive agents. Do not dry mechanically, do not iron.

SECTION 5: WARRANTY

Thank you for purchasing our product, which is made to meet high quality standards.
The manufacturer’s warranty covers the product against manufacturing defects for a period of 2 years from the date of purchase.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>