Uliyati DP336-X LED Vanity Makeup Mirror User Manual
- June 15, 2024
- Uliyati
Table of Contents
Uliyati DP336-X LED Vanity Makeup Mirror
BEFORE YOU START
As the mirror is fragile, although we use multi-layer packaging, we can not ensure that it is delivered in good condition. If you find it broken upon receipt, please feel free to contact us, we will offer a satisfactory solution within 24 hours(working days).
Please read all instructions carefully.
Retain instructions for future reference.
Separate and count all parts and hardware.
Read through each step carefully and follow the proper order.
We recommend that, where possible, all items are assembled near to the area in
which they will be placed in use, to avoid moving the product unnecessarily
once assembled.
Always place the product on a flat, steady and stable surface.
Keep all small parts and packaging materials for this product away from babies
and children as they potentially pose a serious choking hazard.
PRODUCT DESCRIPTION
BUTTON CONTROLS
- Press button ① to turn the light on/off; short press once to switch light color: warm, natural and cold light. Press and hold to adjust the brightenss.
- Press and hold the Bluetooth button ② to turn on Bluetooth function, Short press to pause the music.
- Press the forward button ③ once to skip to next song; press and hold to turn the volume up.
- Press the backward button ④ once to replay the previous song, press and hold to turn the volume down.
CONTAINED ITEMS
1 OX magnifying
12V Power Adapter In put 11 0-240V Output 1 2V 3A
Please use included power adapter, do not use an unsuitable power adapter, otherwise it could damage the mirror electronics.
INSTALLATION STEPS
Preparation Tools ( Not Included ) :
Desktop
Unscrew the screws at the bottom of the mirror.
Align the holes on the base and the bottom of the mirror, and tighten the
screws.
Insta llation is completed.
Wall- mounted
Use tape to measure the distance between the two hooks.
Use pencil to draw parallel lines on the wall, The intersection is the punch
position.
Use electric drill to punch holes at the intersection.
Use hammer to drive the expansion tube into the hole
Use screwdriver to screw the screw into the expansion tube.
Hang up the mirror, installation is completed.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference
that may cause undesired operation.
FCC Radiation Exposure Statement
The antennas used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be
co‐located for operating in conjunction with any other antenna or transmitter.
