Mobotix D25 Camera Day IP Camera Body Instruction Manual
- June 16, 2024
- MOBOTIX
Table of Contents
Mobotix D25 Camera Day IP Camera Body
Product View
Installation
Stand/Wall Mount for Camera Tests (MX-OPT-TW-Demo-1)
The Stand/Wall Mount is a useful accessory for testing and for finding the optimum mounting position of the camera. The set also includes an Allen wrench as well as a Torx screw with dowel and the corresponding Torx wrench for installing as alternative wall mount for testing.
Using as a Stand (with/without tripod)
Using this stand, you can now place the camera upright on a flat surface or mount the whole assembly on a tripod (1/4” tripod thread at the bottom of the stand).
Converting to a wall mount (simulation of On-Wall set with 10 deg. tilt)
-
If required, release the two stainless steel Allen screws and remove the camera from the stand/wall mount.
-
Place the camera with the two upper body screws exactly into the two receptacles of the Stand/Wall Mount.
Preparing the Installation
-
Mount the camera to the stand using the two stainless steel Allen screws.
-
Use the Torx screw to fasten the mount onto the wall. Make sure that the head of the screw is not tight against the wall, but that it still has 5 mm/0.2 in to go.
-
Slide the entire assembly from above over the Torx screw in the wall.
-
Properly tighten the Torx screw to secure the assembly in the desired position. There is a special hole in the Stand/ Wall Mount to access the Torx screw.
Caution
The Stand/Wall Mount has been only designed used for testing purposes. Make
sure that you replace this mount by a proper wall mount before bringing the
system into service.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com •
sales@mobotix.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>