JOLUX LED Can Light Gimbal Retrofit Recessed Downlight Installation Guide
- June 16, 2024
- Jolux
Table of Contents
LED Can Light Gimbal Retrofit Recessed Downlight
Installation Guide
-
Turn power off
-
Remove previous fixture or bulb
-
Extend lamp at maximum height
-
Screw in the E26 adaptor into the open socket
-
Push the trim untill flush with ceiling
In case the lamp trim cannot flush with the ceiling completely due to soft housing holder
5. 1 Retract a littte bit according to the outstanding length. eg. the length is 039° then retract height 0.39″
5.2 Rotate the trim ta screw in the E26 adaptor into the socket until tight -
Adjust the vertical angle of cover, turn the trim in counterclockwise (sameas screw in direction) to make cover in expected position
-
Turn power on and test
*tn case the E26 adaptor cnnot be screwed out of socket when you want to
remove this lamp,
Pull the trim down and turm the trim in cockwise meanwhile to screw out the
lamp
WARNING**
Risk of fire orelectric shock. LED Retrofit Kit installation requires
knowledge of luminaires electrical systems. If not qualified, do not attempt
installation. Contact a qualified electrician.
Install this kit only in luminaires that have the construction features and
dimensions shown in the photographs and/or drawings and where the input rating
of the retrofit kit does not exceed the input rating of the luminaire.
Do not make or alter any open holes in an enclosure of wiring or electrical
components during kit installation.
Jo prevent wiring damage or abrasion, do not expose wiring to edges of sheet
metal or other sharp objects.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>