Jolux 56 LED Can Light Adjustable Recessed Retrofit Downlight Instruction Manual
- June 14, 2024
- Jolux
Table of Contents
Jolux 56 LED Can Light Adjustable Recessed Retrofit Downlight
INSTALL GUIDE
- Turn the power off.
- Remove the previous fixture or bulb.
- Extend lamp at maximum height.
- Screw in the E26 adaptor into the open socket.
- Push the trim until flush with the ceiling.
- Turn the power on and test.
- In case the lamp trim cannot flush with the ceiling completely due to the soft housing holder.
- Retract a little bit according to the outstanding length. e.g. the length is 0.39″ then retract height 0.39″.
- Rotate the trim to screw in the E26 adaptor into the socket until tight.
The socket extender is a backup, not necessary to use it unless your housing is too deep that the lamp base cannot reach the socket.
Instructions
WARNING
- Risk of fire or electric shock.
- LED Retrofit Kit installation requires knowledge of luminaires electrical systems.
- If not qualified, do not attempt installation.
- Contact a qualified electrician.
- Install this kit only in luminaires that have the construction features and dimensions shown in the photographs and or drawings and where the input rating of the retrofit kit does not exceed the input rating of the luminaire.
- Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
- To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>