Pur Line HYDRO 18 Ultrasound Humidifier User Manual
- June 16, 2024
- Pur Line
Table of Contents
- Pur Line HYDRO 18 Ultrasound Humidifier
- Product Usage Instructions
- Please read this manual carefully before use, and keep it for any future
- TECHNICAL DATA
- SAFETY INSTRUCTIONS
- OPERATION
- CONTROL PANEL
- CLEANING AND MAINTENANCE
- TROUBLE SHOOTING
- WARRANTY
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Pur Line HYDRO 18 Ultrasound Humidifier
Specifications
- Model: HYDRO 18
- Power : 100 W
- Electric supply : 220-240 V ~ 50/60 Hz
- Mist volume : 300ml/h
- Dimensions : 22x22x32 cm
- Capacity : 6 L
Product Usage Instructions
Safety Instructions
Please read this manual carefully before use, and keep it for any future
reference.
Operation
Parts
- Ejector plug
- Thimble
- Spring
- Water cup thimble
- Floating bar support
- Floating bar
- Middle layer of water cup
- Nozzle cap
- Cup lids
- Water cup
- Float cap
- Floater
- Transparent cover for sterilizing lamp
- Smart panel
- Bottom cal of water cup
Control Panel
- Power button: After connecting the power, touch the power key to turn on the humidifier. Touch the power key again to stop the humidifier and enter standby mode.
- Mist level button : The product has zero fog volume, low fog volume, medium fog volume, and high fog volume settings. Press the lower fog volume key to adjust the fog volume. The product starts with the maximum fog volume by default.
- Constant humidity button: Press this key to enable the constant humidity function. The default humidity is 40%, and you can increase it by 5% until 90%. Press the button again to exit the constant humidity function.
- Timer button: This product has appointment timing function. You can set the shutdown time from 1 hour to 8 hours.
- Warm button : Activates the warm steam function.
- Sleep night light function: Press and hold the timer key for 3 seconds to turn on or off the night light function.
Cleaning and Maintenance
Troubleshooting
Problem | Possible Causes |
---|---|
The appliance does not work | The cable is not connected correctly. Connect the |
cable and
turn on the power.
No mist output| The selected humidity level has been reached. Disable or reset
the humidity level.
Mist with strange odor| For a new device, the odor will disappear after a few
hours of
operation. If the water is dirty or old, replace it.
Mist volume too low| There may be a layer of dirt in the water tank. Clean the
membrane.
Abnormal noise| Ensure that the appliance is placed on a flat and stable
surface.
Spray mist is coming out of the area around the jets|
FAQ
-
Q: How do I adjust the mist volume?
A: Use the mist level button to adjust the fog volume. Press the lower fog volume key to cycle through the volume settings. -
Q: Can I set a specific humidity level?
A: Yes, you can use the constant humidity button to set the desired humidity level. The default is 40%. -
Q: How do I clean the humidifier?
A: Refer to the cleaning and maintenance section in the user manual for instructions on how to clean and maintain the humidifier.
Please read this manual carefully before use, and keep it for any future
reference
TECHNICAL DATA
SAFETY INSTRUCTIONS
- Children of less than 3 years should be kept away unless continuously supervised.
- Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
- This appliance must be used under the rated voltage and frequency as indicated in rating label.
- To avoid the risk of electrical shock, make sure the appliance is unplugged from the electrical outlet before relocating, servicing, or cleaning it.
- Disconnect the appliance from the mains before filling the water tank.
- Please switch off power before unplugging.
- Unplug power from outlet when not in use.
- Empty and dry the water tank when the device is not in use.
- Do not move the appliance while in use.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or a similarly qualified person in order to avoid a hazard.
- The appliance must not be positioned directly underneath socket-outlet.
- For indoor household use only.
- Do not immerse the unit in any liquid.
- To protect against electric shock, do not immerse unit, plug or cord in water, do not spray with liquids. Do not touch the unit with wet or damp hands.
- Keep the unit away from any hot sources.
- Always operate the unit on a dry, level surface.
- Do not cover the unit. Do not place any objects on the top of the unit.
- Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or has been damaged in any manner. Return appliance to the nearest authorized service facility for examination, repair, or adjustment.
- Do not place the mist outlet close to furniture, a wall, a TV or any other appliance that could be damaged by the moisture.
- Do not overfill the water container more than the MAX mark indicates.
- Do not introduce foreign objects into the device.
- If water spills on the device, immediately unplug it and allow it to dry
- Do not use the appliance in association with a programmer, timer or other device that automatically switches it on.
- Do not switch the appliance on without water.
- Do not use the device if the water in the tank has run out.
- Store the device in a dry, dust-free place out of direct sunlight.
- Always fill the tank with clean water. We recommend you use filtered or distilled water.
OPERATION
PARTS
CONTROL PANEL
-
Power
Power button: after connecting the power, touch the power key, the LCD will light up and the machine will work. Touch the power key again, the humidifier will stop working and enter the standby mode. -
Mist Level
Mist level button: the product is divided into zero fog volume, low fog volume, medium fog volume and high fog volume. The fog volume can be adjusted. Press the lower fog volume key to adjust the cycle each time. The product starts up with the maximum fog volume by default. -
Humidistat
Constant humidity button: press this key for the first time, the product will enter the constant humidity function, and the “ambient humidity” on the LCD will light up. The default humidity is 40%, and then press 5% to increase until 90% to exit the constant humidity function, so as to adjust the cycle, and stop working when the ambient humidity reaches the preset humidity value. -
Timer
Timer button: this product has the function of appointment timing. It can be shut down for 1 hour, 2 hours to 8 hours. Touch this key to set the shutdown time, and the corresponding time will be displayed on the display screen each time you press this key. -
Warm
Button that activates the warm steam function. -
Sleep
Night light function: Touch and press the timer key for 3 seconds to turn on or turn off the night light function and the night light icon will show on the display screen.
CLEANING AND MAINTENANCE
In case when the water is hard which means water contains too much calcium and
magnesium, they can cause “white powder” problem and give heavy scum on the
surface of water basin, transducer and inner surface of the water tank. Scum
on the surface of transducer will make the unit work improperly.
WE RECOMMEND:
- Use filtered water or distilled water.
- Clean the transducer, water tank and basin unit every week.
- Change the water in water tank more often to keep it fresh.
- Clean the whole unit, and make sure to keep all parts of the unit dry completely when the unit is not in use. HOW TO CLEAN THE TRANSDUCER: 1. Put 5-10 drops of vinegar on the surface of the transducer, wait for 2-5 minutes. 2. Brush out the scum on the surface. 3. Rinse the transducer with clean water.
- HOW TO CLEAN THE BASIN UNIT: 1. Clean the water basin with soft cloth and the vinegar if there is scum in it. 2. If the scum is covered on the security switch, drop the vinegar on the scum and clean it out with the brush. 3. Rinse the water basin with clean water.
CLEAN THE TANK FILTER:
- Remove the filter from the tank.
- Clean with a little vinegar and clean water.
- Shake about 10 times and rinse with water.
- Leave to dry.
TROUBLE SHOOTING
Any trouble found in normal operation, please kindly refer to the following points:
Trouble | Possible reasons | Solution |
---|---|---|
**** | **** | **** |
Does not work | No power supply | Connect power supply, switch on |
No water in water tank | Fill with water and wait 10 min. | |
No mist | Selected humidity level has been reached | Deactivate or reset the |
humidity level
Defective device| Contact Technical Service
Mist with strange odour| New device| Odor disappears after the first few hours
of operation
Dirty water or long time staying water| Clean water tank, fill with clear
water
Mist volume too low| Too much dirt in the water basin| Clean membrane
Water is too dirty or water kept too long in the tank| Clean water tank, fill
with clear water
Low humidifying level| Change the humidifying level
Abnormal noise| Not enough water| Fill with water
The device is tilted or on an uneven surface| Place the unit on a flat, stable
surface
Spray mist is coming out of the area around the jets| Miste nozzle or water
tank misplaced| Re-install the nozzle or tank
Notice:
- If the problem cannot be found in the list or it persists, please contact our service center or a qualified technician for further inspection.
- Do NOT open and repair the unit by yourself. Use only qualified agents for repairs or services.
WARRANTY
All the warranty terms finish 24 months after the buying date. It is absolutely necessary to show your buying invoice to be covered by the warranty terms. The warranty covers any defect produced during the manufacturing or caused by the raw material used in this product, and only in the event that the customer has followed the instructions and maintenance showed in the user’s manual, and only in the event that the installer has followed the installation directions. This warranty does not cover any damage caused by accidents or negligence. The warranty only covers the customer in case that any reparation has been done in our authorised repairing shops. The warranty DOES NOT COVER any damage or injury caused to people, animals or things caused by an accident or the negligent use of this product. The warranty will be suspended in case of any manipulation of unauthorised people or in case of non-original parts or components.
DISCARDING WORN HOUSEHOLD DEVICES
The European directive 2012/19/EC pertaining to electrical and electronic
waste prohibits such household goods from being discarded with local refuse
services. Worn devices must be collected separately to optimize the recovery
and recycling rates of the components therein to reduce detrimental effects on
the environment and on human health.
This unit may be submitted to changes in specifications, characteristics
and/or operation without prior notice to the user, in order to continue
improving and developing its technology
The contents of this operation manual and the specifications of this product are subject to change without notice. An updated manual is available on www.purline.es
CLIMACITY S.L.
C. Torrox, 2 – 5 · 28041 Madrid (ESPAÑA) tel. 91 392 05 09
www.purline.es
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>