MINI-GY MQ Series LED Flood Light User Manual
- June 16, 2024
- MINI-GY
Table of Contents
MINI-GY MQ Series LED Flood Light User Manual
LED Flood Light
Please read the instructions before starting the installation and keep them for future reference.
Product information
- Series: MQ Series
- Power: 10W-100W
- Voltage: AC100-265V 50/60Hz
- Lamp Bead Type: SMD2835
- Color Temperature: 3000K/6000K
- Sensing Distance: 6-8m
- Lighting Angle: 120°
- Protection Class: IP65
- Power Factor :＞0.9
- CRI: >80
Important User Advice
- This product must be connected to the Earth wire.
- Please stop using it immediately if the glass breaks.
- Ensure that all seals are intact and can be used normally after installation or maintenance.
- Keep a safe distance between eyes and lamps to avoid injuries caused by strong light.
- Please turn off the power before installation to avoid electric shock due to improper operation.
- If you find that the lamp body wire is damaged, or there are signs of smoke and burnout, please immediately cut off the power and stop using it.
- In a humid environment, please wipe the lamp and make sure there is no water in the wiring before use.
- It is recommended that qualified and professional electricians install lamps and ensure that the installation location complies with building electricity regulations.
- Before installation, please check whether the voltage range marked on the floodlight matches the actual power voltage to avoid damage to the LED Floodlight. The input voltage of this product is AC100-265V 50Hz.
Wire Connection Guide
- The brown wire is connected with the “L”
- The blue one is connected with the “N”
- The green/yellow one is connected “E”
- Power Cord type: PVC 3 x 0.75mm²
- Please pay attention to safe use of electricity!
Installation Steps
- Determine the location of the fixture.
- Make sure the power is off.
- Fix the adjustable bracket of the product to the designated position with matching screws.
- After fixing the bracket, point the lamp towards the area to be illuminated and tighten the screws on the side of the product to prevent it from falling.
- Correspond the input power cord to the live, ground, and neutral wires in the correct color, and ensure that the connection is stable.
- Insulate and waterproof the connection of the power cord to avoid leakage and water.
- After the inspection is completed, the link power is turned on and the installation is complete.
- When installing, please make sure that after the power is turned off, the switch cuts off the live wire, not the neutral wire, so as to avoid the weak light after the lamp is turned off.
THREE MODES
-
SENS mode: Change the detection distance up to 8 meters(26 feet)
-
TIME mode: The light turns on once motion is detected.
Extend the illumination time from the shortest (about 12 seconds) to the longest (about 7 minutes) -
LUX Mode: Change the lighting modes from Daytime Mode (the light works even during the day) or Night Mode (the light only works when it is completely dark)
After-Sales
- For products that have been sold, replacement warranty is provided in the case of non-artificial damage;
- If you have any questions or suggestions about the product, please contact us:
Manufacturer: Shenzhen Lanbote Technology Co., Ltd.
Add:213, bldg. B, 1970 Cultural Innovation Park, Minzhi Community, Longhua
District, Shenzhen, CN
For after-sales problems, we will provide effective solutions in time.
eVatmaster Consulting GmbH
Bettinastr. 30
60325 Frankfurt am Main, Germany
contact@evatmaster.com
EVATOST CONSULTING LTD
Suite 11, First Floor, Moy Road Business
Centre, Taffs Well, Cardiff, Wales, CF15 7QR
contact@evatmaster.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>