NFESOLAR Solar Water Fountain Pump Instruction Manual

NFESOLAR Solar Water Fountain Pump

Specifications

• Solar Panel: 10V, 7W
• Fountain Lifetime: 10,000 hours
• Battery Lifetime: Charge-discharge 300-500 times

Product Information

Thank you for purchasing our solar pump fountain. The product is tested and certified for safety and high performance. To avoid unnecessary damage or improper use, please read and understand the instructions below. Save this manual for future reference.

Product Usage Instructions

Preface

Please be sure to read and understand the instructions in detail before using the solar pump fountain. This will help prevent any damage or improper use. Save this manual for future reference.

Important Reminders

• Keep the surface of the solar panel clean at all times.
• Change water frequently to avoid any dirt that may impede the pump.
• Do not put the solar pump fountain under sunlight without water. The battery will be charged, but the fountain will not work.

Maintenance

Regularly cleaning the pump will increase its lifespan. Follow the steps below to clean the pump:

• Clean the solar panel and water pump according to the instructions provided in the “CLEANING AND MAINTENANCE” section.

Packing List

• Solar Panel with Pump x1
• Nozzle x10
• Nozzle Base x2
• Connection Head x2
• Ground Rod Part x1
• Operation Instructions x1

FAQ

Why does the solar pump stop working?

• The water level is lower than the dry-run protection device.
• The solar panel is dirty or in a shaded area.
• The pump is clogged.

How can I troubleshoot common issues?

• If the impeller is blocked, clean the solar panel and water pump according to the instructions provided in the “CLEANING AND MAINTENANCE” section.
• Make sure the water level is above the silver part.
• Install the solar panel in a sunny place.

How can I contact customer service?

If you are not satisfied with our product and require a refund or replacement, please contact us through the Amazon order page by clicking on “Contact Seller.” We will reply to your message within 24 hours and assist you in solving your problem as soon as possible.

Preface

Thank you for purchasing our solar pump fountain,the product is tested and certified, safety,high performance products. In order to avoid unnecessary damage or damage to the product due to improper use and maintenance, please be sure to read and understand the instructions in detail, and save this manual for future reference.

Specification

• The power of solar panel: 10V 7W
• The power of pump: 8V 1.5W
• The Maximum flow of pump: 350L/H
• The size of solar panel: 277*197mm
• Battery: Rechargeable Li-ion 7.4V 3000mAh
• Maximum water spray height: 3ft

Features

• The fountain life time：≥10000 Houus.
• The battery life time：Charge-discharge 300-500 times.
• Delay：≤ 3S （The pump will automatically restart within 3 seconds when sunlight recovery）
• Standby: The solar pump fountain will be activated within 1-3 seconds in the sunlight, If it’s not activated, the solar pump fountain cannot work normally.
• Working hours: During sunny days; 6hours max for battery.
• Battery function: The battery will assist the fountain working when the sunlight is weak or the weather is bad. The battery will be charged while the solar fountain working and the solar panel has excess power.
• Dry-run protection:The fountain come with capacitive water level detection, it will stop working without water. Nozzles: 10 different spray water shape nozzles for you choose.

Important Reminders

• Keep the surface of solar panel cleaning constantly.
• Change water frequently to avoid any dirt to impede the pump.
• Put solar pump fountain under sunlight without water the battery will be charged but the solar fountain will not work.
• Water should at least 2 inch(5.0cm) deep and clean.
• Do not use solar fountain at water temperature above 113°F(45°C).
• Please do not use the solar pump fountain in dirty or corrosive water.
• For safety ：any repair work should be done only by the manufacturer of the products or the facility authorized service center.

Maintenance

• Regular clean pump will increase the life of fountain.
• Clean the pump as follow:
• Step 1: Remove the pump cover.
• Step 2: Remove the impeller cap by placing your fingernail underneath the small lip located.
• Step 3: Remove the impeller and clean the parts mith water.

To avoid damage please don’t open the controller of solar pannel.

Packing List

1. Solar Panel with Pump x1
2. Nozzle x10
3. Nozzle Base x2
4. Connection Head x2
5. Ground rod Part x1
6. Operation Instrucctions x1

TO BETTER USE THE SOLAR WATER PUMP

1.  Install the panel in a sunny place, (since it is fully supply by solar power, the panel must install in a suny place, so the pump can work well)
2. The water level must be exceed the dry-run protection device which in the pump (the device shows as follow picture)
3. The installed pump nozzle should be exposed to the water level.
4.  When using water pipes to create a water feature, the max water height of the pump can push is 2.6 ft.
   If the height of your water feature exceeds it, it is recommended that you use it to another water feature, or put something under the pump to raise the height of the pump and the water level

WHY SOLAR PUMP STOP WORKING?

1. The water level is lower than the dry-run protection device.
2. The panel is dirty or in a shade.
3. The pump is clogged.

CLEANING AND MAINTENANCE

1. Clean the solar panels to prevent dust covering the panel from affecting the solar conversion efficiency (recommend once a week).
2. Clean the pump and filter cotton (recommend once a week, if there are many impurities in the water, the time can be shortened).

Please follow the steps below to clean the pump (as shows in above figure):

1. Pull the filter housing together with the filter sponge and impeller from the pump body as shown above.
2. Wash all parts including the foam filter to remove debris.
3. Assemble the pump in reverse order.
4. Cover the solar panel and put the pump into the water.
5. Expose the panel to sunlight and the fountain will run again within 15 seconds

TROUBLE SHOOTING

1. Impeller is blocked – clean the solar panel and water pump according to the instructions in “CLEANING AND MAINTENANCE”.
2. Make sure the water level is above the silver part.
3. Install the panel to a sunny place.

CUSTOMER SERVICE
If you are not satisfied with our product and want a refund or replacement, please contact us through Amazon order page- contact seller, to communicate with us, we will reply you within 24 hours, and help you solve your problem as soon as possible!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>