UCTRONICS U6271 Gigabit PoE Splitter with 2 in 1 USB-C Micro USB Adapter User Manual
- June 16, 2024
- UCTRONICS
Table of Contents
UCTRONICS U6271 Gigabit PoE Splitter with 2 in 1 USB-C Micro USB Adapter
User Manual
INTRODUCTION
UCTRONICS PoE Splitter U6271 fully complies with IEEE 802.3af/at standards. It receives power and data from a PoE switch or PoE injector, then separates the data and power into two cables. We combine the Micro USB and USB-C adapters into one cable, saving you the cost of additional cable configurations. It provides an ideal solution for powering and transmitting data to non-PoE devices such as Raspberry Pi and secure IP cameras.
FEATURES
- 2-in-1: PoE to Micro USB/PoE to USB-C PoE Splitter
- Complies with IEEE802.3af/at standard, supplies up to 15W
- 10/100/1000 Mbps data transfer rate
- Overvoltage, short-circuit and overcurrent protection
- No extra power cables needed
- Plug & Play installation, easy to set up
- Widely compatible with Raspberry pi 4B/3B+, Security IP Cameras and more
DIMENSION
SPECIFICATIONS
| Model | LS-PE0530K-U6271 |
|---|---|
| Isolation | 1KV |
| Standards | IEEE802.3af/at |
| Power Input | DC38~57V IEEE 802.3af/at PoE |
| Power Output | DC 5V 3A (15W Max) |
| LAN Port | RJ45 Male |
| Power Ports | Micro USB male port; Micro USB female to USB-C male port |
| Data Transfer Rate | 10/100/1000 Mbps |
| Certification | FC; CE; RoHS |
| Power Pin | support 1/2(+),3/6(-); 4/5(+),7/8(-) |
| Operating Temp. | -30℃~80℃(-22℉~176℉) |
| Storage Temp. | -25℃~75℃(-13℉~167℉) |
| Storage Humidity | 5%~25% RH Noncondensing |
| Multiple Protection | overvoltage, short-circuit and overcurrent protection |
CONNECTION
This PoE splitter is supposed to work fine with non-PoE devices that need a 5V 3A input without any extra configuration, provided that you have already deployed your PoE switches or injectors.
Step 1:
Connect the Micro USB male port/ USB-C male port of the splitter to the
female port on the target device.
Step 2
Connect the RJ45 male port of the splitter to the female port on the target
device.
Step 3
Use an Ethernet cable to connect the PoE splitter to a PoE switch or PoE
injector through the RJ45 female port.
Plug-and-play with deployed PoE switches or injectors.
CONTACT US
We value your voice and satisfaction and strive for high-quality products
and services. If you encounter any problem while using our product, please
feel free to contact us.
Website: http://www.uctronics.com
Email: [email protected]