UCTRONICS U6260 Complete Enclosure for Raspberry Pi Cluster User Guide
- October 30, 2023
- UCTRONICS
Table of Contents
SKU: U6260
ASSEMBLY GUIDE
www.uctronics.com
Package Contents
Installation
-
Install the fan to the back panel. Pay attention to the direction of the fan, the stickers should face the Raspberry Pi.
-
Fix cooling fans with M5 * 10 screws.
-
Install two frameworks to the back panels. Please note that all the screws for the enclosure are M3 * 4 countersunk screws.
-
Mount the side panels to the frameworks.
-
Install two frameworks on the other side of the side panel.
-
Mount the front panel.
-
Use the top panel to cover the top of the enclosure.
-
Snap the bottom panel into the enclosure.
-
Insert the 2.5-inch SSD into the mounting bracket, align the direction of the mounting hole, and fix it with M3*5 screws.
-
Mount the Raspberry Pi with M2.5 *5 screws.
-
Insert the fan adapter board into the power interface of Raspberry Pi.
-
Polarity diagram of fan adapter.
-
Connect the fan wire to the fan adapter board. Please pay attention to the red-and-black wires. Red represents the positive pole and black represents the negative pole.
-
Tilt and insert the installed bracket into the case and fix it with Captive Loose-Off Screws.
-
Insert the other Raspberry Pi mounting brackets into the enclosure.
-
Finally stick the footpads to the bottom panel. The installation is complete.
CONTACT US
If any problem, feel free to contact us.
Website: www.uctronics.com
Email: support@uctronics.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>