DAYTECH DS17BL Door Sensor User Manual
- June 16, 2024
- DAYTECH
Table of Contents
DS17BL Door Sensor
User Manual
DS17BL Door Sensor
In order to better use this product, please read the instructions carefully
before installation!
Transmitter instruction manual
FCC ID: 2AWYQ-DS17BL
Product Name: Door Sensor Model:DS17BL
product overview
The transmitter and receiver are used together, no wiring, no installation is simple and flexible, this product is mainly suitable for orchard farm alarm, family residence, company, hospital, hotel, factory doors and Windows.
product feature
- with independent power switch
- Open the door and open the window automatically to send a signal
- The remote control distance can reach 300 meters in an open barrier-free environment: the remote control signal is stable and does not interfere with each other.
- Waterproof rating IPX4
Product icon
Operating Instructions
- Start by putting the receiver into code matching mode.
- Open the transmitter switch and pull the magnetic strip to complete the code matching with the receiver.
- Attach the transmitter to the doors and Windows, and the receiver will ring automatically every time the magnetic strip is opened.
replace battery
- Snap off the bottom shell
- Open 1 screw with a screwdriver
- Remove the battery from the transmitter PCB board and dispose of it properly; Install a new CR2450 battery into the battery slot, noting that the positive and negative terminals cannot be inverted.
technical reference
| operating temperature | -30℃~+70℃ |
|---|---|
| operating frequency | 433.92MH |
| Transmitter battery | CR2450 |
| Standby time | 3 years |
This device complies with part 15 of the FCC Rules. Operation is subject to
the condition that this device does not cause harmful interference (1) this
device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>