MISPEAKER A10 Speaker User Manual
- June 16, 2024
- MISPEAKER
Table of Contents
Model: A10
USER MANUAL
Product Descrirtion
-
Speaker
-
Volume Knob:
1. Volume Up/Down
2. Power On/Off -
Mode:
1. Click to Switch Bluetooth Connection/3.5mm AUX Input
2. Press 3 Seconds to Wipe Off & Reset Bluetooth Connection -
USB-Powered Cable
-
3.5mm AUX Audio Cable
How to Setup
PC, Laptops, Macbook Pro/Air
- Plug the USB connector into USB side ports on computers;
- Plug the 3.5mm connector into headphone jack on computers;
- Fix the settings: control panel/system preference – sound settings – choose Jeecoo A10 as audio output – save changes.
- Clockwise rotate the volume knob to power on and turn up the volume, play sound.
Notes:
If you hear some noticeable white noise from A10 speakers, please refer to
below steps:
- Check and move the 3.5mm connector and USB connector are properly inserted into your device.
- If it is connected into power adapter, please change and replace a certified ad pater (5V/ 1 A ).
Cellphones, iPad, PS4/PS5, Nintendo (Bluetooth Mode)
- Plug the USB connector into a certified USB power supply (5V/1A);
- Click the “MODE” button to switch Bluetooth mode;
- Turn On Bluetooth on your cellphones, search and select device name “Jeecoo A10”, connect it and pair.
- Clockwise rotate the volume knob to power on and turn up the volume, play sound.
Notes:
- If A10 were paired with some other devices, and not able to pair now, please press the Mode button for 3 seconds to wipe off the bluetooth connection, and pair the A10 with your devices via Bluetooth again.
Suvecifications
Audio Input: | 3.5mm AUX/Bluetooth |
---|---|
Bluetooth Working Distance: | .33ft./10 meter |
Connector-1: | USB (for powered) |
Connector-2: | 3.5mm (for AUX mode) |
Output Power: | 5W |
Speaker Size: | 2.5inch |
Speaker Impedance: | 40 |
Frequency Range: | 20Hz-20KHz |
Power Supply: | USB 5V/1A |
Unit Dimension: | 4 72.74.7inch / 12712cm |
Unit Weight: | 0 77Ibg/350g |
FCC Warning Statement: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Radiation Exposure Statement
The antennas used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be
co‐located for operating in conjunction with any other antenna or transmitter.