NPS XP30 Dog Bark Deterrent Devices Instruction Manual

NPS XP30 Dog Bark Deterrent Devices Instruction Manual

DO NOT start to use the device before watching important video guide at

PETNPS.COM/GO

Based on 200 000+ sold units 97% Satisfaction Rate means less than a 3% failure due to dog nature traits.
Less than Thrilled?
Smile! Keep your device and we’ll issue a full refund or replacement, whichever makes you HAPPIEST!

Read First

Our upgraded NPS dog training system, already the most effective in the world, is now even better.
Why change the fastest, safest, most effective system in the world?

Because the 10% of dogs who fall into the hard to I train’ category eventually begin ignoring our stable 25 kHz ultrasound waves. And we won’t settle for anything less than 100% effective.

.So, we went back to the drawing board, diving deep into canine auditory research, and uncovered something fascinating. All dogs, even the most effective ‘ignorers’, can’t ignore a set range of undulating waves. So we added them – from 23 to 30 kHz – in rapid undulation, to our already 90% effective 25 kHz ultrasonic mode, making it impossible for your dogs’ auditory system (and the brain that processes everything they hear) to block you out.

This means that even the most destructive, annoying and dangerous behaviors are now easily trained away: barking, biting, chewing, digging, chasing, running off, and of course, eating dangerous things.

Thank you for trusting us with your dog and family’s safety!

We can’t wait to hear how quickly, painlessly and effectively our Advanced NPS Dog Training System helped accelerate your success, so please circle back and connect with us if you have any questions or want to share your experience with our small family company.

Questions? Please contact us at cs@petnps.com

IF YOU RECEIVED A USED OR DEFECTIVE PRODUCT FROM AMAZON, PLEASE CONTACT US AT REFUND@PETNPS.COM

Included

Ultrasonic dog training Device x1
Type-C Charging Cable x1
Wrist Strap x1
Manual x1

Overview

Product Characteristics

• Ultrasonic emission distance: up to 50 feet
• Battery capacity: 2000mAh
• Charging time: 2-3 Hours
• Work modes: beep mode, ultrasonic mode, torchlight & strobe SOS mode, nighttime flashlight mode
• Device Size: 1.83 x 1.85 x 4.43 inch

Functions of Ultrasonic

Beep Mode Button – Use First

Pressing the button creates a beeping sound. You’ll see a green light when activated.
Try using it before ultrasonic mode because some dogs can learn what happens if they don’t stop when you make this sound. If your dog stops after the beep noise and starts to follow your commands, remember to reward them for their good behavior.

Ultrasonic Mode Button – Use Second

Press and hold the button. You’ll see a green light turn on, which shuts off after 10 seconds. Release and repress if needed.
Remember to start with the 25 kHz frequency and rotate to the 20-30 kHz or 25 kHz so your dog does not become immune to ultrasonic training methods.

Torchlight & Strobe SOS Mode

Press the button once to turn on the CopBright torch.
Press again to activate SOS strobe mode. Press again to shut off.

Sonic Frequency Mode:

Undulating sound waves with a frequency of 20-30kHz
Stable and continious sound waves with a frequency of 25kHz

You can start on the stable and continuous sound waves and if that doesn’t seem to have an eect on your dog, you can switch to the undulating sound waves.
If you choose the stable and continuous sound waves mode: ultrasonic, ashing light and vibration work at the same time.
If you choose the undulating sound waves mode: ultrasonic and vibration work at the same time.

Nighttime Flashlight Mode

The smart light sensor is easily activated by pushing the flashlight button; great for walks at sunset or finding your leash in the garage.

Battery Facts

1. Charge for 5 hours before first use for maximum battery life.
2. Red flashing light? Battery requires charging. Green light? Battery is fully charged.
3. Use a 5V/2A Adapter or USB cord to power device.
   

CAUTION

1. Do not use this product on puppies.
2. Do not hand it to a child, or use it for extended periods.
3. Do not use this on hearing-impaired dogs, special service animals, or dogs over 8 years of age.
4. This works most effectively when combined with Our simple training method; Use sound mode. Issue command. Activate ultrasonic mode. Reward your pup.
5. Please consult your veterinarian or certified trainer
   if you’re unsure which method is best for your dog.

LED Indicator:

• Press the ultrasonic or beep button, and the Green LED indicator will flash.
• Hold ultrasonic or beep button. The Green LED indicator stays on.
• Press the torchlight button once. The Green LED indicator does not turn on.

Battery Saver:

• When the device has less than 25% battery left. The Red LED indicator will flash.
• Charging. Continuous red light that changes to green once charged.

Operation Guide

Step 1. Test the Device

Please check the device before using it. Go to open a space and test the device within 50 feet of your dog.

Max range up to 50 feet

Checking Performance:

Switch to unlock. Press the beep mode button. The green LED indicator light should flash. You’re ready to go! Flashing red? Simply charge with the included USB cable and test again once the light is continuously green.

Step 2. Test 3 Training Modes

Gentle, natural, and effective. This device is proven to shift ingrained behaviors by starting with beep mode, then advancing to ultrasonic + sonic frequency + nighttime flashlight mode, then to ultrasonic + sonic frequency mode.

Grab Attention with Beep Mode:

Hold the device within 50 feet of your dog. When the dog barks, speak your command (ex. Stop! Hush! Quiet!), then press the beep mode button once. If your dog continues barking without a break, hold the button down until your dog stops. If your dog barks again after a break, push beep mode once more.

Chase Stopper – Ultrasonic Mode:

Press the ultrasonic mode button once when your dog barks. Hold if the dog doesn’t stop barking. Repeat when your dog barks again. Ultrasonic stops at 10 seconds, even when it’s being held down, to protect your pup’s ears.

Max range up to 50 feet

Nighttime Flashlight + Ultrasonic Mode:

This is designed to call back and correct even the most mischievous dogs. Press once to emit one second of ultrasonic pulse and flashing. Safety shut- off prevents more than 10 seconds of pulsing and flashing to protect pups’ ears when holding the ultrasonic + flashlight button down.
Hold the device in your hand. When your dog is within 50 feet of you and barks at you, you can point the device at the dog. And say: Stop! Hush! (or a similar command)

Your Behavior Matters Tool

The more consistently you press the button as they’re barking, the faster training proceeds. For the best results, please make sure you’re within 50 feet of your dog and there are no obstacles in between.

Critical Safety Precautions

NEVER allow a child to control this. It is a training device, not a toy, and it’s important that your dog hears it only when you need them to modify behavior;
Not repeatedly.

Do not immerse this device in water or other liquids.

NEVER use this device on dogs younger than 6 months, as there is not sufficient testing on how repeated ultrasonic waves impact a puppy’s developing auditory system.

Showing your dog patience and love goes a long way in building the bond that helps your dog listen, so please use this device with kindness.

Charging

When the LED indicator goes red, the battery has less than 25% left. Please charge the device using the USB cable that comes with it

While charging the battery, the red charging indicator is on.
If the green charging indicator is flashing, the battery is fully charged.
Charging time: 2-3 hours
Time of uninterrupted working in the mode
«BEEP»: 10 hours
Time of uninterrupted working in the mode
«ULTRASONIC»: 1.5 hours
Time of uninterrupted working in the mode
«TORCHLIGHT»: 3.5hours
Stand by: up to 90 days

Attaching the Strap

Frequently Asked Questions

Q1; Is this safe for my family and other pets?

Absolutely. We love dog people as much as we love dogs and cats, and keeping peace of mind in happy homes makes our day! We've spent years developing and testing to achieve exceptional device safety for dogs, cats, humans & the planet.

Q2:How are you ensuring my dogs safety?

For safety reasons, the NPS advanced dog trainer automatically stops emitting all waves and sounds after ten seconds. The strobe light, FLashlight, and CopBright light stay on as long as it’s charged. Need to stop your dog again? Simply press the ultrasonic or sound button and it reactivates to stop your dog in its tracks for 10 more seconds.

Q3: How do I use this to train 3.7x faster?

Push sound mode to grab attention. Give a command (Example: Sit, stop barking, halt). Push the ultrasonic mode (25 kHz). Reward your dog with love or treats every time they stop the behavior.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>