Thermador MED301WS Masterpiece 30 Stainless Steel Single Electric Wall Oven Owner’s Manual

MED301WS
30-INCH SINGLE BUILT-IN OVEN
MASTERPIECE® SERIES

FEATURES & BENEFITS

– Specially crafted gray glass on stainless steel for a luxurious look and finish
– Designed for flexibility — standard or flush installation into kitchen cabinets
– Commercial style rotisserie with 12 pound capacity
– Multi-point Meat Probe to better capture temperature in roast and poultry
– Fast 2-hour self clean mode
– Fast preheat (around 7 minutes)

GENERAL PROPERTIES

Heating Modes
(16) Bake, Broil, Max Broil, Roast, Convection Bake, Convection Broil, Max Convection Broil, Convection Roast, Proof, Warm, Pizza, True Convection, Dehydrate, Speed Convection, Slow Roast, Rotisserie

OVEN PERFORMANCE
Bake Element| 2,400 W
Broil Element| 3,800 W / 1,000 W
Convection Element| 2,000 W
TECHNICAL DETAILS
Watts| 6,400 W
Circuit Breaker| 30 A
Volts| 240 / 208 V
Frequency| 60 Hz
Plug Type| Fixed Connection, No Plug
Conduit| 60″ 4-Wire
Energy Source| Electric
DIMENSIONS & WEIGHT
Overall Appliance Dimensions (HxWxD)| 29″ x 29 3/4″ x 24 1/2″
Trim Overlaps (Top – Sides – Bottom)| 3/8″ to 2″ – 9/16″ – 0″
Required Cutout Size (HxWxD) – Standard| 27″– 28 5/8″ x 28 1/2″ x 23 1/2″
Required Cutout Size (HxWxD) – Flush| 29 1/8″ x 30″ x 24 1/2″
Oven Cavity Size| 4.5 cu. ft.
Overall Oven Interior Dimensions (HxWxD)| 17 3/4″ x 24″ x 17 7/8″
Usable Oven Interior Dimensions (HxWxD)| 13 1/2″ x 21 5/8″ x 16 1/4″
Net Weight| 188 lbs

ACCESSORIES (INCLUDED)

3 Telescopic Racks, Multi-point Meat Probe, Max Broil Pan, Rotisserie

WARRANTY

INSTALLATION DETAILS

NOTE: Conventional ovens with a serial number beginning with “FD009” require accessory kit TWO30YS for Standard or Flush side-by-side installation with another oven or with any other approved product. This kit must be purchased separately and installed prior to installing the oven in the cabinetry. Refer to the Oven Installation Guide for additional information.

Combination Type| A
Left reveal cleat| B
Right reveal cleat| C
cut-out width| D
cut-out width
---|---|---|---|---
Flush Bottom hinge| 3/4″ (19 mm)| 3/4″ (19 mm)| 291/4″ (743 mm)| 291/4″ (743 mm)
Flush Side Hinge (Left)| 11/2″ (38 mm)| N/A| 30″ (762 mm)| N/A
Flush Side Hinge (Right)| N/A| 11/2″ (38 mm)| N/A| 30″ (762 mm)
| | | |

*Installation not recommended
measurements in inches (mm)

THERMADOR SIDE-BY-SIDE BUILT-IN OVEN

COMBINATION GUIDE

The following OVENS are approved to be installed side-by-side in combination and the installation has been certified by CSA. This guide is only effective with the use of the Thermador built-in oven side-by-side accessory kit TWO30YS. The built-in oven side-by-side accessory kit is required for approved installation.

BUILT- IN OVENS

**Conventional Ovens*| Steam Ovens**
ME301WS| MEDS301WS
MED301WS| PODS301WS
MED301LWS| MEDS301WS w/ SDS30WC
MED301RWS| PODS301WS w/ SDS30WC
PO301W|
POD301W|
POD301LW|
POD301RW|

The following OVENS and DRAWERS are approved by BSH Home Appliances Corporation to be installed in combination. These products, identified in the table below, may be installed in combination with other cooking units. The suitability of the combination has not been evaluated by CSA.

BUILT-IN OVENS

**Conventional Ovens*| Steam Ovens| Microwave Ovens| Speed Ovens**
---|---|---|---
ME301WS| MEDS301WS| MB30WS| MC30WS
MED301WS| PODS301WS| MB30WP| MC30WP
MED301LWS| MEDS301WS w/ SDS30WC| MB30WS w/ SD30WC| MC30WS w/ SD30WC
MED301RWS| PODS301WS w/ SDS30WC| MB30WP w/ SD30WC| MC30WP w/ SD30WC
PO301W| | MB30WS w/ WD30WC| MC30WS w/ WD30WC
POD301W| | MB30WP w/ WD30WC| MC30WP w/ WD30WC
POD301LW| | |
POD301RW| | |

• Conventional ovens with a serial number beginning with “FD009” require accessory kit TWO30YS for side-by-side installation with another oven or in combination with any other approved product. All parts in the kit may not be required. Refer to the Oven Installation Guide for additional information.

These warranties give you specific legal rights and you may have other rights that vary from state to state. Limited warranty from date of delivery. For complete warranty details, refer to your Use & Care manual, or ask your dealer.
Specifications are for planning purposes only. Refer to installation instructions and consult your countertop supplier prior to making counter opening. Consult with a heating and ventilation engineer for your specific ventilation requirements. For the most detailed information, refer to installation instructions accompanying product or write to Thermador indicating the model number. Specifications are correct at time of printing. Thermador reserves the right to change product specifications or design without notice. Some models are certified for use in Canada. Thermador is not responsible for products that are transported from the U.S. for use in Canada.

1 800 735 4328
USA THERMADOR.COM 
CANADA THERMADOR.CA
©2023 BSH HOME APPLIANCES CORPORATION. ALL RIGHTS RESERVED.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>