SONOS SO2 Wireless Charger User Guide
- June 16, 2024
- Sonos
Table of Contents
Wireless Charger
Model:SO2
User Guide
Thank you for purchasing and using this product!
Please read this Operation Instruction carefully and keep it properly before
using this product.
Product Specification
- Input:5V/ 1.5A
- Output:5V/1A
- Working Power:5W
- Working Distance:3mm
- Charigng Efficiency:70%
- Standard: QI
- Quality: Quality and meet CE/FCC/ROHS
- Oparation frequency:110.3KHZ-205KHZ
- H-field:-10.72 dBμA/m @10m
- Hardware:SO2-RevA
- Software:SO2-RevA
Application Devices
Compatible with Peregrine
Attention
- Please keep the charger away from water or other liquid.
- If you need to clean the charger, please make sure it is notconnected power supply.
- Using Environment termperature remains 40 C
- To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna. Hereby, Sharewater declares that the radio equipment typesmartwatch wireless charger is in compliance with Directive2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.sharewater.com
This equipment has been tested and found to comply with the limits for a WPC
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential Installation.
Caution
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the product.
The FCC certification of this device refers to RF exposure testing performed
in typical operating conditions, where a person is no closer than 20
centimeters from the device surface at all times, except for non-repetitive
patterns with transient time intervals in the order of a second. Only in the
stated conditions, the device is shown to fully comply with the FCC RF
Exposure requirements of KDB 447498.
Bottom shell Non-slip silicone Note: This equipment has been tested and found
to comply with the limits for a wireless power charger, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user Is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Manufacturer Information
Name: Shenzhen Shi Shan Yuan Ke Ji You Xian Gong Si
Address: Long hua Qu Dalang Jiedao
Langkou Shequ Huachang Lu 3 Hao 4 Dong 501
Shenzhen Shi Guangdong Sheng
Importer Information
Name:FINISTERRE UK LIMITED
Address:UNIT 6 WHEAL KITTY WORKSHOPS
ST.AGNES, ,CORNWALL, UK, TRS ORD
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference
that may cause undesired operation.
The FCC certification of this device refers to RF exposure testing performed in typical operating conditions, where a person is no closer than 20 centimeters from the device surface at all times, except for non-repetitive patterns with transient time intervals in the order of a second. Only in the stated conditions, the device is shown to fully comply with the FCC RF Exposure requirementsof KDB 447498.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>