unitech MS852DPMESD 2D Imager Barcode Scanner User Guide
- June 16, 2024
- unitech
Table of Contents
Quick Start Guide
609506G_ V1.0 MS852DPM ESD
2D Imager Barcode Scanner
Connecting the Scanner
Connect USB cable to the USB port of a host computer.
Test & Finish
Open a word processing program such as Microsoft Word or Notepad and scan the following barcode:
Unitech
If the word “Unitech” appears on the screen, you have succesfully installed your scanner.
Buzzer & LED Description
- Three short beeps (low – medium – high): Power on/Exit Setting Mode (setting success)
- One short beep: Barcode Good Read
- Two long beeps: Entering setting mode
- One long beep: Good Read (during setting mode)
- Three short beeps (high – high – high): Setting Failed
- Green Light On: Barcode Good Read
Default Setting
%++%
Note: The barcode with an Asterisk (*) is the default setting.
Enter/Exit Setup
%+$.$ %$$%
Scanning the Enter Setup barcode can enable the engine to enter the setup mode. Scan the Exit Setup barcode to exit the setup mode.
USB Interface Mode
OP02 OP03
Scan Mode
MD01 MD02
Beeper Control
FRQ2 FRQ3 FRQ4
Good Read Beep
SND1 SND0
Aiming
AIM02 AIM00 AIM01
HID Keyboard Case
CCT0 CCT1 CCT2
Illumination Level
FL01 FL02 FL03
Terminating Character
TC03 TC02 TC04 TC01http://www.ute.com/services01.php?rbu=0
Language Settings
KM00 KM02 KM20 KM01 KM03 KM04 KM05 KM13 KM06 KM12 KM07 KM08 KM18 KM21 KM09 KM11 KM10 KM19 KM24
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>