IKEA FRYSA Fridge User Manual
- June 4, 2024
- Ikea
Table of Contents
IKEA FRYSA Fridge
INSTALLATION
CAUTION
Product Description
- Control panel
- LED light
- Fan
- Glass shelf
- Glass Crisp Cover
- Crisper drawer
- Lower drawer
- Dairy balcony with lid
- Door Balcony
- Bottle holder with dividers
- Bottles balcony
- Door magnet switch housing
Characteristics, technical data and images may vary according to the model.
Accessories
First use
Connect the appliance to the power supply. The ideal food storage temperatures
are already factory-set (intermediate).
Note: after being switched on, the appliance needs 4-5 hours in order to reach
the correct temperature to store a typical volume of food. To avoid food
waste, please refer to the recommended setting and storage times found in the
user manual.
Important!
This appliance is sold in France. In accordance with regulations valid in this
country it must be provided with a special device (see figure) placed in the
lower compartment of the fridge to indicate the coldest zone of it.
Daily use
Refrigerator operation
The appliance’s refrigerator compartment features a control panel. It is
possible to set a different temperature with the E button.
- On/Stand-by
- Temperature display
- Key lock
- Vacation (holiday mode)
- Appliance temperature
- Turning off the sound alarm
On/Stand-by
Press the A button for 3 seconds to turn the appliance off. In Stand-by mode,
the icon will light up and the light in the refrigerator compartment does not
turn on. To turn the product on again, a brief press on the button is
sufficient.
Note: this procedure does not disconnect the appliance from the electricity
supply.
Temperature display
The display shows the refrigerator compartment temperature (between 2°C and
7°C). Recommended setting: +4°C
Key lock
The key lock can be activated/deactivated by keeping the C button pressed for
3 seconds, until a confirmation sound is heard (the icon lights up immediately
and into few seconds disappear). If you press any button while the key lock is
active, you will hear a sound and the C icon will flash.
Vacation (holiday mode)
You can use this function in the event of your prolonged absence. Press the
“Vacation” D button for 3 seconds to turn the function on. The display will
show the temperature of the refrigerator compartment (12°C) and the D icon
will light up. After activating the function, remove the food from the
appliance and keep the door closed – the appliance will maintain a suitable
temperature to prevent odors from forming. To turn off the function, press
briefly the button or act on the °C E button .
Fast Cool function
To quickly cool the refrigerator compartment, turn on the “Fast Cooling”
function by pressing button E for 3 seconds. When the function is turned on,
the icon will be displayed. The function turns off automatically after 6
hours, or manually by pressing the E button for 3 seconds.
Turning off the sound alarm
To turn off the sound alarm, briefly press the F button.
Fan function
The fan is pre-set to ON. You can turn the fan on/off by pressing the C button
and E button at the same time for 3 seconds. If the ambient temperature
exceeds 27°C, or if drops of water are present on the glass shelves, it is
essential that the fan is on to ensure the proper preservation of the food.
Deactivation of the fan allows energy consumption to be optimised.
Note: the fan restarts automatically after a power cut or after turning off
the appliance.
LED light
LEDs last longer than traditional light bulbs, improve internal visibility and
are environmentally friendly. Contact the Service Centre if replacement is
necessary.
Door Magnet switch: do not remove it, it is part of the normal operation of the product.
Refrigerator compartment
Defrosting of the refrigerator compartment is completely automatic. The
formation of water droplets on the rear internal wall of the refrigerator
compartment indicates that the automatic defrosting is underway. The defrost
water automatically runs into a drain outlet and then into a container from
where it evaporates.
Caution! The refrigerator accessories must not be placed in a
dishwasher..
Installation
The appliance must be handled and installed by two or more persons – risk of
injury. Use protective gloves to unpack and install – risk of cuts.
Installation, including water supply (if any), electrical connections and
repairs must be carried out by a qualified technician. Do not repair or
replace any part of the appliance unless specifically stated in the user
manual. Keep children away from the installation site. After unpacking the
appliance, make sure that it has not been damaged during transport. In the
event of problems, contact the dealer or your nearest Aftersales Service. Once
installed, packaging waste (plastic, styrofoam parts etc.) must be stored out
of reach of children -risk of suffocation. The appliance must be disconnected
from the power supply before any installation operation – risk of electric
shock. During installation, make sure the appliance does not damage the power
cable – risk of fire or electric shock. Only activate the appliance when the
installation has been completed. Be careful not to damage the floors (e.g.
parquet) when moving the appliance. Install the appliance on a floor or
support strong enough to take its weight and in a place suitable for its size
and use. Make sure the appliance is not near a heat source and that the four
feet are stable and resting on the floor, When contacting our Service
Provider, please state the codes provided on your product’s identification
plate. The model information can be retrieved using the QR-Code reported in
the energy label. The label also includes the model identifier that can be
used to consult the https://eprel.ec.europa.eu database portal.
Inspection check list
Please follow the inspection checklist before using your appliance. If any
answer is NOT please follow the relevant action. Please remember to write down
the product serial number and article number as required and attach your
receipt to this page.
- Product serial number (rating plate)
- Product artical number (rating plate)
- Purchasing date
adjusting them as required, and check that the appliance is perfectly level
using a spirit level. Wait at least two hours before switching the appliance
on, to ensure that the refrigerant circuit is fully efficient.
WARNING: When positioning the appliance, ensure the supply cord is not
trapped or damaged. WARNING: To avoid a hazard due to instability, positioning
or fixing of the appliance must be done in accordance with the manufacturer’s
instructions. It’s forbidden to place the refrigerator in such way that the
metal hose of gas stove, metal gas or water pipes, or electrical wires are in
contact with the refrigerator’s back wall (condenser coil). To guarantee
adequate ventilation, leave a space on both sides and above the appliance. The
distance between the rear of the appliance and the wall behind the appliance
should be 50 mm, to avoid access to hot surfaces. A reduction of this space
will increase the Energy consumption of product. Please remove the power cord
from the condenser hook during installation before connecting the product to
the power supply.
| If the answer is YES | Actions to do if NOT |
|---|
Consideration Tray
Check that the tube is inside the tray
| No action| Put the tube inside the tray
Making sure gasket seals all around the door
when the door is closed
| No action| Refer to the AI – door
allignment step
Checking no collision between parts/forniture
while opening/closing the cooling door
| No action| Refer to the AI – door
allignment step
Secure the installation inside any kitchen
system and fixed as required
| No action| Follow the AI for the proper
installation
General information
The drawers, baskets and shelves should be kept in their current position unless otherwise specified in this quick guide. The light system inside the refrigerator compartment uses LED lights, allowing for better lighting than with traditional light bulbs, aswell as for very low energy consumption. Doors and lids of the refrigeration appliance should be removed before disposal in the landfill, to avoid children or animals getting trapped inside. This product contains a light source of energy efficiency class G.
Technical data
To download the full version visit www.ikea.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>